Roberts Radio CR960 user manual

Summary of the content on the page No. 1

CR960
2 Band Stereo Dual Alarm
Clock Radio
Please read this manual before use
ROBERTS
Sound for Generations

Summary of the content on the page No. 2

Controls 1325 4 (Front) (Left hand end) (Right hand end) 7 6 89 10 11 1. Alarm 2 indicator 2. Alarm 1 indicator 3. Auto dimmer 4. Clock display 5. PM indicator 6. LED Dial pointer 7. Stereo indicator 8. Alarm 2 function switch 9. Alarm 1 function switch 10. Tuning control If you need any further advice, please 11. Volume control call our Technical Helpline on 0181 758 0338 (Mon-Fri) 2

Summary of the content on the page No. 3

Controls 14 15 (Top) (Rear) 12 13 12. Off button 13. Sleep button 14. Radio On button 15. Snooze button 16. Waveband selector 17. Alarm set button 18. Slow forward button 19. Fast forward button 20. Fast reverse button 21. Slow reverse button 16 18 20 22 22. Time set button 17 19 21 23 23. Battery compartment (on underside) 3

Summary of the content on the page No. 4

General Fuse Do not allow this unit to be exposed to water or steam. Do not leave the unit This apparatus must be protected by a 3A fuse (BS1362) in a 13A plug where excessive heat could cause damage. It is recommended that the (BS1363). If another type of plug is used a 5A fuse should be fitted in the FM band be used wherever possible as better results in terms of quality and plug, adaptor or distribution board. freedom from interference will usually be obtained than on the MW band. IF IN DOUB

Summary of the content on the page No. 5

is heard. Rotate the tuning control (10) until the desired station is received. Setting alarm time 1 If the station being received is in 'Stereo' the stereo indicator (7) will Set the alarm 1 function switch (9) to the HWS or Radio position. The alarm illuminate. Adjust the volume control (11) to the required sound level. 1 indicator (2) will show in the display. Press and hold down the alarm set If the FM signal becomes weak or is accompanied by a high level of button (17). Use the time adjust

Summary of the content on the page No. 6

Wake up to Radio Auto Dimmer Set the alarm time as previously described. Switch on the radio by pressing The Auto Dimmer (3) will automatically adjust the intensity of the clock the radio on button (14). Tune into the required station. Make sure that the display to suit room brightness. station will be broadcasting at the time you wish to wake up. Set the volume Battery Back-up facility control to the level of sound at which you want to wake to. Set the alarm The purpose of this battery is onl

Summary of the content on the page No. 7

Specifications Circuit Features Power Requirements Loudspeaker 2 x 75mm diameter 8 ohms Mains AC 230 volts, 50Hz only Back-up Battery IEC size 6F22 (6LR61, PP3) Output Power 2 x 0.5W RMS Frequency Coverage Aerial System FM Wire Aerial FM 87.5 -108MHz MW 520 - 1605kHz MW Built-in Ferrite aerial Imported by:- ROBERTS RADIO LIMITED PO BOX 130 MEXBOROUGH SOUTH YORKSHIRE S64 8YT The Company reserves the right to amend the specification without notice. 7

Summary of the content on the page No. 8

Guarantee This instrument is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component breakdown, subject to the procedure stated below. Should any component or part fail during this guarantee period it will be repaired or replaced free of charge. The guarantee does not cover: 1. Damage resulting from incorrect use. 2. Consequential damage. 3. Receivers with removed or defaced serial numbers. . Procedure: Any claim under t