Sinclair Manual Grommet Machine PG20 user manual

Summary of the content on the page No. 1

Model PG-20
Manual Grommet Machine
Operating Manual












(800) 624-2408 (530) 626-9386 Fax (530) 626-5144
6686 Merchandise Way Diamond Springs, Ca 95619
www.sineqco.com

Summary of the content on the page No. 2

INTRODUCTION MANUAL MACHINE MODEL PG-20 FOR PLACING APPLICATIONS BY HAND The function of this machine is the placement of applications or to punch holes (interior diameter of tube grommet 8mm or 12mm) in materials that need these applications. Specially recommended for placing grommets and washers in: awnings, curtains, advertising signs, etc. THIS MACHINE WILL PUNCH THE MATERIAL WHILE SIMULTANEOUSLY SETTING THE GROMMET. WARNINGS! We hope you will take notice of these warni

Summary of the content on the page No. 3

Installation of PG-20 Install grommet machine on secure table top with the front of machine base flush with table edge. Use four bolts with lock nuts/washers to secure machine. Adjusting both the cutting and the grommet pressure. ALWAYS ADJUST FIRST THE CUTTING PRESSURE, NEVER TRY DO CUTTING AND SETTING AT THE SAME TIME. Each time you change material or change grommet sizes, it will be necessary to adjust the pressure for the machine to work properly. In order to adjust the c

Summary of the content on the page No. 4

In order to adjust the grommet pressure. - Insert grommet on die #3 as shown in figure 1 below. Make sure bottom of grommet is up above bottom of top die. No washer is needed for 8mm grommets. For 12mm grommets, insert washer on die #4 as shown in figure 2. - Do a test grommet with the material you are using, - Slowly loosen #2 die to tighten grommet fit. Use ¼ turns or less at a time. - Try to spin grommet in material. If grommet is loose, continue to bring die #2 down until grommet

Summary of the content on the page No. 5

Change Of Dies The PG-20 will take two die sets. If you want to change out sizes, you will need to replace parts. Please refer to the following diagrams. 8mm Die Set 12mm Die Set Only used in 12mm die set.

Summary of the content on the page No. 6

Parts Schematic

Summary of the content on the page No. 7

Schematic # Part # Description 30 PGR2030 Machine Head 31 PGR2031 Die Holder Pin 32 PGR2032 Driving Stem 33 PGR2033 Driving Stem Guide Wheel Pin 34 PGR2034 Driving Stem Guide Wheel 36 PGR2036 Eccentric Part 37 PGR2037 Connecting Rod 38 PGR2038 Connecting Rod Pin 39 PGR2039 Adjusting Nut For Top Die 40 PGR2040 Screw For Fixing Lever 41 PGR2041 Lever Pin 42 PGR2042 Draw Back Spring 43 PGR2043 Driving Stem Control Part 44 PGR2044 Driving Stem Control Pin 45 PGR2045 Pin For Top Set

Summary of the content on the page No. 8

NOTES