Tower Hobbies Nitro user manual

Summary of the content on the page No. 1

Ready To Run
ASSEMBLY AND OPERATION MANUAL
Warranty
®
• Tower Hobbies will warranty this kit for 90 days after the purchase date from defects in materials or workmanship. Tower
Hobbies will either repair or replace, at no charge, the incorrectly made part.
 Make sure you save the receipt or invoice you were given when you bought your model! It is your proof of purchase and
we must see it before we can honor the warranty.
 To return your Tower Nitro ST-15 for repairs covered under warranty you

Summary of the content on the page No. 2

SAFETY PRECAUTIONS ITEMS REQUIRED FOR COMPLETION If you follow the safety precautions below the Tower Hobbies The following items will be needed to operate the Tower Hobbies 1/10th stadium truck will provide countless hours of fun. Always 1/10th stadium truck. use caution and good sense when running the Tower Hobbies ❍ Glow plug starter (TOWP1190) 1/10th stadium truck. Failure to use this vehicle in a safe, sensi- ❍ Fuel bottle (DTXP0150) ble manner can result in injury or damage to property. On

Summary of the content on the page No. 3

❍ 3. Remove the antenna tube from the parts bag. Run the anten- ❍ 5. Remove the two 3x10mm screws from the receiver battery na through your fingers a few more times to straighten the receiv- case which is located on the rear of the truck. Then remove the er antenna wire. Thread the receiver antenna wire through the cover from the top of the receiver battery case. antenna tube. Press fit the antenna tube into the antenna holder which is located on the throttle servo mount. Do not cut or coil the

Summary of the content on the page No. 4

Mask the windows off on the inside of the body with masking tape. Paint the body using a polycarbonate or lexan compatible paint. Remove the masking from the windows. Cut the excess lexan around the molded cut lines, and remove the clear protec- tive cover from the outside of the body. Locate the dimples in the body which mark the body post locations. Drill these dimples out using a 5/16" drill bit or by using a lexan body reamer. Apply the decals as shown on the front of the box. Install the bo