American Standard VertiSpa 6035 user manual

Summary of the content on the page No. 1

Installation
Instructions
™

6035
Designer Shower
Massage System
Thank you for selecting American-Standard...the benchmark of
fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
ROUGHING-IN DIMENSIONS
11-3/4 MAX."
8-5/8"
3"
6-1/4 MIN."
65" TO 78"
TO FINISHED FLOOR
(OPTIONAL)
3-5/8"
Certified to comply with ANSI A112.18.1M
M968416 REV 1.1
Tools required for installation:
Phillips Screwdriver
Adjus

Summary of the content on the page No. 2

INSTALL DIVERTER WITH SHOWER HEAD (NOTE: If customer desires to use alternate shower head, then pull 3 back Escutcheon (1) on SHOWER HEAD (2) and turn counter-clockwise with an adjustable wrench. Replace with customer shower head, Ensure ESCUTCHEON (1) is assembled onto DIVERTER (2). arm and flange.) Hold DIVERTER BODY (2) and thread the DIVERTER (2) with SHOWER HEAD (3) onto NIPPLE (4) until snug against the finished wall and in position as shown. 1 2 2 3 4 1 SHOWER HEAD REMOVED Adjustable Wr

Summary of the content on the page No. 3

OPERATION CONNECT FLEXIBLE HOSE TO DIVERTER 5 6 Thread the HOSE COUPLING (1) onto DIVERTER SPRAY UNIT (1) can be adjusted up 4 NIPPLE (2) and hand tighten clockwise. Note: Moulded and down by sliding unit along the end of HOSE COUPLING (1) creates watertight seal with rails. (See Maintenance section for with thread of DIVERTER NIPPLE (2), so seal washer is steps to adjust the tension of SPRAY not required. 9-3/4" UNIT (1) on the rails.) UP AND DOWN Make sure HOSE (3) is not kinked or twist

Summary of the content on the page No. 4

™ Designer Shower Massage System MODEL NUMBER M907526-YYY0A ESCUTCHEON 6035 M950120-YYY0A DIVERTER UNIT M950130-YYY0A SHOWER HEAD M912119-0070A O-RING M923107-0070A PIPE NIPPLE Replace the "YYY" with appropriate finish code CHROME 002 M962292-0070A MOUNTING KIT - SCREWS (2) - ANCHOR (2) - TOGGLE ANCHOR (2) - DRILL BIT (1) - TEFLON TAPE (1) M962291-0070A SPRAY NOZZLES KIT M923106-0070A FRICTION CLIP M962290-YYY0A SPRAY TRIM KIT M923112-YYY0A END CAP M96