Summary of the content on the page No. 1
R
INSTALLATION
AND
OPERATING
INSTRUCTIONS
Model: FT 1000
TM
FASTRAC HORIZONTAL CONVEYOR TOASTER
INTENDED FOR OTHER THAN HOUSEHOLD USE
RETAIN THIS MANUAL FOR FUTURE REFERENCE
UNIT MUST BE KEPT CLEAR OF COMBUSTIBLES AT ALL TIMES
TABLE OF CONTENTS
Safety Precautions
2
Important Safety Instructions
3
General Information 4
Installation Instructions 4
Operation Instructions
5
Cleaning Instructions
5
Warranty Procedure 6
Troubleshooting
6
Replacement Parts Lis
Summary of the content on the page No. 2
IMPORTANT FOR FUTURE REFERENCE Please complete this information and retain this manual for the life of the equipment. For Warranty Service and/or Parts, this information is required. Model Number Serial Number Date Purchased Notes: SAFETY PRECAUTIONS Before installing and operating this equipment be sure everyone involved in its operation are fully trained and are aware of all precautions. Accidents and problems can resu
Summary of the content on the page No. 3
1. IMPORTANT SAFETY INSTRUCTIONS IMPORTANT: Read the following important safety instructions to avoid personal injury or ! death, and to avoid damage to the equipment or property. ! WARNING: Do not allow untrained personnel to operate the toaster. ! ! NOTICE: Do not use toppings (butter, etc.) on product as product is inverted during normal ! operation. ! WARNING: To avoid any injury, turn the power switch off at the fuse disconnect switch/circuit breaker or unplug the unit from the po
Summary of the content on the page No. 4
CAUTION: The National Sanitation Foundation (NSF) requires that units over 36” (91 cm) in length or weighing more than 80 lbs. (36 kg) to be either sealed or raised on the installation surface. If this ! unit cannot be sealed at the point of use, 4” (10 cm) legs are included to allow for proper cleaning ! access below unit. WARNING: Genuine APW Wyott Replacement Parts are specified to operate safely in the environments in which they are used. Some aftermarket or generic replacement
Summary of the content on the page No. 5
III. Toaster Placement A. Locate the toaster near a grounded receptacle of the proper configuration (see below). Plug the cordset directly into receptacle (DO NOT USE AN EXTENSION CORD). 1. In the United States, NEMA 6-20R. 2. In Canada, NEMA 6-20R. B. Place the toaster on a flat surface providing the following minimum clearances: 1. Base = one inch (provided with legs installed). 2. Side and back walls = one inch 3. Overhead = Enough space to allow adequate heat displacement. 4. WARNING: Fa
Summary of the content on the page No. 6
D. Slide the reflector/crumb tray out of the toaster by pulling forward. Dispose of crumbs and wash the tray in hot, soapy water. Dry the tray and place it back into the toaster. E. Remove the bottom toast drawer from the toaster by sliding it out and lifting up. Dispose of crumbs and wash the drawer in hot, soapy water. Wipe crumbs from inside the toaster with a hot, damp cloth. Dry the drawer and place it back into the toaster. F. Wipe the exterior surfaces of the toaster with a hot, damp c
Summary of the content on the page No. 7
TROUBLESHOOTING CHART: THE PROBLEM THE CAUSE THE SOLUTION Won't toast... a. Toaster cold. a. Allow five (5) minutes for warm up. b. Wrong power switch position. b. Position power switch to full power. c. Wrong conveyor speed setting. c. Reduce conveyor speed. Toasts unevenly... d. Only part of product surface is d. Reduce conveyor speed. Toasted. e. Product located too far to side of e. Place product on conveyor between conveyor. end links. Product sticks to f. Butter or butter substitute used o
Summary of the content on the page No. 8
REPLACEMENT PARTS LIST - FT 1000 ITEM P/N DESCRIPTION QTY 1 34236 TERMINAL BLOCK END MTG 1 2 34237 TERMINAL BLOCK (6) .250 MALE 3 3 38254 IDLER SHAFT ASSY 1 4 83956 DRIVE SHAFT ASSY 2 5 38278 CRUMB TRA Y/REFLECTOR ASSY 1 6 38129 TOAST DRAWER 1 7 38131 WIRE FEEDER 1 8 54095 ELEMENT 208V 1625W 2 54096 ELEMENT 240V 1625W 2 9 58188 LABEL, CONTROL PANEL 1 10 89490 SWITCH, MAIN ROTARY 1 11 82903 #25 DRIVE CHAIN, " PITCH, 65 PITCHES 1 12 PS0029 WIRE BELT, 3 SEGMENT, 3.07' OF 8
Summary of the content on the page No. 9
9 EXPLODED VIEW - FT 1000 23 1 2 4 13 3 22 12 27 8 21 28 7 11 5 19 15 26 16 9 25 17 24 10 20 18 6 14
Summary of the content on the page No. 10
WIRING DIAGRAM - MODEL FT 1000 IMPORTANT NOTICE: The information contained in this section of the manual is intended for individuals possessing backgrounds of electrical and mechanical experience, such as an authorized APW Wyott service technician. APW or the seller ! ! cannot be responsible for the interpretation of this information, nor can it assume any liability in connection with its use. 10
Summary of the content on the page No. 11
APW WYOTT EQUIPMENT LIMITED WARRANTY APW Wyott Foodservice Equipment Company warrants it's equipment against defects in materials and workmanship, subject to the following conditions: This warranty applies to the original owner only and is not assignable. Should any product fail to function in its intended manner under normal use within the limits defined in this warranty, at the option of APW Wyott such product will be repaired or replaced by APW Wyott or its Authorized Service Agency. APW W
Summary of the content on the page No. 12
R Phone: +1 (214) 421-7366 Fax: +1 (214) 565-0976 Toll Free: +1 (800) 527-2100 APW WYOTT Website: www.apwwyott.com 729 Third Avenue E-mail: info@apwwyott.com Dallas, TX 75226 12
