HP (Hewlett-Packard) MAILBUS 400 user manual

Summary of the content on the page No. 1

HPMAILbus400
MessageTransferAgent
InstallingonanOpenVMSAlpha
System
October 2006
This card contains the information that you need to install the MAILbus
400 MTA on an OpenVMS Alpha system.
Use this card in conjunction with Part III of HP MAILbus 400 MTA
Planning and Setup.
Revision/Update Information: This is a revised manual.
Operating System and Version: OpenVMS Alpha Version 7.3-2 and above
OpenVMS VAX Version 7.3
Software Version: HP Mailbus 400 Message Transfer Agent
V3.2-12 for OpenVMS
Hew

Summary of the content on the page No. 2

© Copyright 2006 Hewlett-Packard Development Company, L.P. Confidential computer software. Valid license from HP required for possession, use, or copying. Consistent with FAR 12.211 and 12.212, Commercial Computer Software, Computer Software Documentation, and Technical Data for Commercial Items are licensed to the U.S. Government under vendor’s standard commercial license. The information contained herein is subject to change without notice. The only warranties for HP products and services are s

Summary of the content on the page No. 3

Installation Prerequisites Before you install the HP MAILbus 400 MTA: 1. Ensure the following software is installed on your system: OpenVMS Alpha Version 7.3-2, 8.2, or 8.3 HP DECnet-Plus/OSI for OpenVMS Alpha Version 7.3-2, 8.2, or 8.3 including the OSI Applications Kernel (OSAK) component. HP Enterprise Directory Service for OpenVMS V5.3 or later 2. Ensure you have access to the SYSTEM account. 3. Back up your system disk using the OpenVMS Backup Utility. 4. Register a valid MTA license, MAILB

Summary of the content on the page No. 4

Additional disk space is required after installation for a MAILbus 400 MTA to be able to handle message traffic. Component Title Space Required (in blocks) During After MAILbus 400 MTA Mgt 3200 1400 MAILbus 400 MTA Base 5700 5000 MAILbus 400 MTA Server, Mgt and Base 22900 20700 Installing the MAILbus 400 MTA From the SYSTEM account on the node, or cluster, where you want to install a MAILbus 400 MTA component, complete the following steps: • Mount the CD–ROM as follows: MOUNT device-name: volume-

Summary of the content on the page No. 5

Installing Component for Remote Access by XAPI Agents Where an XAPI Agent (that is, an Agent using the MAILbus 400 Application Program Interface) is to be installed on a system remote from the MTA, select the option to install the MAILbus 400 MTA Base component on the single node, or on one node in the cluster, where the Agent is to be installed. After the Installation The set-up tasks required after installation, and the MTA verification procedure are described in Part III of HP MAILbus 400 MTA

Summary of the content on the page No. 6