Seagate ST336737LW/LC user manual

Summary of the content on the page No. 1

 Most Barracuda 36ES drives are factory set with the SCSI ID set at 0. If
this is the only SCSI drive in your system and there are no other SCSI
‘
devices on the bus (cable), you can leave this drive’s SCSI ID set to 0 and
Barracuda 36ES Installation Guide
proceed to the next step.
Model ST336737LW/LC, ST318437LW/LC, ST318417N/W
 The host system’s SCSI controller usually uses SCSI ID 7.
SCSI interface disc drive
 If you have an LW model drive, the ID may be set using either J6 or J5
(located

Summary of the content on the page No. 2

5. Format the drive J2 Drive with Pin 1 HDA up, PCB The drive has been low level formatted at the factory. You do not need to down, viewed from front Pin 1 perform another low level format on this drive unless you decide to perform Reserved Positions HDA certain diagnostics through the host adapter. If you do decide to perform a Single-ended I/O A jumper here forces single-ended low level format, do not abort the format as this is likely to make the drive J6 I/O operation. L R inoperable. A low