Summary of the content on the page No. 1
Control Board
Model Number AW-A795
® ®
Intel Pentium 4 Embedded SBC with Six Gigabit/Two 10/100LAN &
SSD
User’s Manual
Version 1.0
We embed your need! © Copyright 2005
Summary of the content on the page No. 2
User’s Manual © Copyright 2005. All Rights Reserved Manual Edition 1.0, January 2005 This document contains proprietary information protected by copyright. All rights are reserved, no part of this manual may be reproduced, copied, translated or transmitted in any form or by any means without prior written permission of the manufacturer. The content of this manual is intended to be accurate and reliable, the original manufacturer assumes no responsibility for any inaccuracies that
Summary of the content on the page No. 3
User’s Manual Table of Contents Chapter 1. General Information-------------------------------------------------------------5T 1.1 Introduction---------------------------------------------------------------------------------5 1.2 Specification--------------------------------------------------------------------------------- 6 1.3 AW-A795 Package--------------------------------------------------------------------------7 1.4 Board Layout--------------------------------------------------------
Summary of the content on the page No. 4
User’s Manual CN36:KB/MS Pin Header------------------------------------------------------------------------22 CN37:LAN LED Pin Header---------------------------------------------------------------------22 CN38:LAN LED Pin Header-------------------------------------------------------------------------22 JP1:PS/On Always On Select--------------------------------------------------------------------------22 JP2/4/5:PCI-X slot Frequency Select---------------------------------------------------
Summary of the content on the page No. 5
User’s Manual Chapter 1. General Information 1.1 Introduction THE AW-A795 embedded computing board, an “all-in-one” Network Security Hardware Appliance based on Intel® architecture with E7501+ICH3+P64H2 chipset supporting the Pentium® 4 processor with 400/533MHz FSB. The DDR 200/266 RAM (PC2100 registered) with ECC for enhanced data integrity up to 4GB. Based on E7501 chipset, AW-795 support eight Ethernet ports including six GbE ports, two 10/100BASE-T coppers for various markets
Summary of the content on the page No. 6
User’s Manual 1.2 Specification General Functions CPU Intel Pentium® 4 based processors with 400/533MHz Front-side Bus Award® 512KB Flash BIOS BIOS Intel® E7501 + ICH3 + P64H2 Chipset I/O Chipset Winbond® 83627HF Onboard two 184-pin DDR DIMM socket, support PC2100 registered Memory memory up to 4Gbytes Enhanced IDE Support up to two IDE devices Two RS-232 ports, oneRJ-45 connector and one pin header Serial port One pin header for parallel port Parallel port KB/Mouse 5x2 head
Summary of the content on the page No. 7
User’s Manual 1.3 AW-A795 Package Please make sure that the following items have been included in the package before installation. 1. AW-A795 Low Power Embedded SBC 2. Quick Setup 3. Cable: Please refer to Appendix B Optional Cables 4. CD-ROM which contains the following folders: (1) Manual (2) System Driver (3) Ethernet Driver (4) Tools If any of these items are missing or damaged, please contact your dealer from whom you purchased the board at once. Save the shipping mat
Summary of the content on the page No. 8
User’s Manual 1.4 Board Layout 1.5 Board Dimension ©2002 AEWIN Technologies Co., Ltd.. All rights reserved. Ver 1.0. Jan. 2005 8
Summary of the content on the page No. 9
User’s Manual Chapter 2. Connectors/Switch Location and Configuration 2.1 Connectors/Jumpers Location and Define ©2002 AEWIN Technologies Co., Ltd.. All rights reserved. Ver 1.0. Jan. 2005 9
Summary of the content on the page No. 10
User’s Manual Connector Define CN2 LAN (10/100) Connector CN1 USB0 Connector CN3 LAN (10/100) Connector ©2002 AEWIN Technologies Co., Ltd.. All rights reserved. Ver 1.0. Jan. 2005 10
Summary of the content on the page No. 11
User’s Manual CN4 Gigabit LAN Connector CN25 IDE(2mm) 44 Pin 90 Degree CN5 Gigabit LAN Connector CN26 IDE(2.54mm) 40 Pin CN6 Gigabit LAN Connector CN27 +12V Power Connector CN7 Gigabit LAN Connector CN28 FAN Connector CN8 Gigabit LAN Connector CN29 FAN Connector CN9 Gigabit LAN Connector CN30 FAN Connector CN10 COM1 RJ45 Connector CN31 FAN Connector CN11 FAN Connector CN32 HDD LED Pin Header CN12 Power LED Pin Header CN33 PS-On Pin Header CN13 USB1 Pin Header CN34 Rese
Summary of the content on the page No. 12
User’s Manual 2.2.1 Installing CPU: ©2002 AEWIN Technologies Co., Ltd.. All rights reserved. Ver 1.0. Jan. 2005 11
Summary of the content on the page No. 13
User’s Manual 2.2.2 Remove CPU (1) First, please push the tappet to unlock location. (2) Then untie the screw beginning from left side you can refer to below the picture. (3) Now you can take out the CPU from socket. ©2002 AEWIN Technologies Co., Ltd.. All rights reserved. Ver 1.0. Jan. 2005 12
Summary of the content on the page No. 14
User’s Manual 2.2.3 How to recognize CPU Before you install CPU please make sure the CPU is exactly Pentium 4 processor. You can see the difference from CPU code and the pin out at backside. (1) Pentium M CPU (Socket 479) (2) PIII CPU – (uFCPGA Package) ©2002 AEWIN Technologies Co., Ltd.. All rights reserved. Ver 1.0. Jan. 2005 13
Summary of the content on the page No. 15
User’s Manual (3) Pentium 4 CPU (Socket 478) 2.3 Installing Memory To insert a DIMM Memory: The AW-A795 supports two 184-pin DDR sockets, memory up to 4GB. Please make sure to insert DDR with registered. ©2002 AEWIN Technologies Co., Ltd.. All rights reserved. Ver 1.0. Jan. 2005 14
Summary of the content on the page No. 16
User’s Manual To Insert a DIMM Memory: Please align the module with the socket key and press down until the levers at each end of the socket snap close up. There is only one direction for installing a module in the socket. Do not attempt to force the module into the socket incorrectly. ©2002 AEWIN Technologies Co., Ltd.. All rights reserved. Ver 1.0. Jan. 2005 15
Summary of the content on the page No. 17
User’s Manual To Remove a DIMM Memory: To remove a DIMM, press down on the levers at both end of the module until the module pops out There is only one direction for installing a module in the socket. Do not attempt to force the module into the socket incorrectly. ©2002 AEWIN Technologies Co., Ltd.. All rights reserved. Ver 1.0. Jan. 2005 16
Summary of the content on the page No. 18
User’s Manual 2.4 Connector and Jumper Settings CN1 : USB0 Connector CN4/5/6/7/8/9:Gigabit LAN connector Pin Define Pin Define 1 +5V 1 TX0+ 2 Data0- 2 TX0- 3 Data1+ 3 RX0+ 4 Ground 4 N/C 5 N/C CN2/3 LAN (10/100) Connector 6 RX0- 7 N/C 8 N/C LED: D1 :Bi-Color Speed LED Pin Define 10 Mbps Off 1 TX0+ 100 Mbps Yellow 2 TX0- 1000Mbps Green 3 RX0+ D2 :Link/Activity LED 4 N/C Link Green 5 N/C Activity Blinking 6 RX0- 7 N/C CN10:COM1 RJ45 Connector 8 N/C LED:
Summary of the content on the page No. 19
User’s Manual 5 NC 3 TXD# 8 CTS# 6 RXD# 4 DTR# 9 RI#2 7 PSR# 5 Ground 10 NC 8 RTS# CN15 :Parallel Box Header CN11/20/24/28/29/30/31:FAN Connector Pin Define Pin Define 1 STROBE 14 AUTOFD 2 PD0 15 ERR 3 PD1 16 INT 4 PD2 17 SLCTIN CN12:Power LED Pin Header 5 PD3 18 Ground 6 PD4 19 Ground 7 PD5 20 Ground Pin Define 8 PD6 21 Ground 1 VCC 9 PD7 22 Ground 2 GND 10 ACK* 23 Ground 11 BUSY 24 Ground CN13:USB1 Pin Header 12 PE 25 Ground Pin Define 13 SLCT 26 G
Summary of the content on the page No. 20
User’s Manual 18 -5V 8 POWER GOOD 55 GND 56 PAR 19 +5V 9 5VSB 57 AD{17} 58 AD{18} 20 +5V 10 +12V 59 C/BE[2]# 60 AD[16] 61 IRDY# 62 GND CN17:Mini PCI 63 3.3V 64 FRAME# 65 CLKRUN# 66 TRDY# 67 SERP# 68 STOP# 69 GND 70 3.3V 71 PERP 72 DEVSEL# 73 CB/E[1] 74 GND Pin Define Pin Define 75 AD[14] 76 AD[15] 1 TIP 2 RING 77 GND 78 AD[13] 3 8PMJ-33 4 8PMJ-13 79 AD[12] 80 AD[11] 5 8PMJ-63 6 8PMJ-23 81 AD[10] 82 GND 7 8PMJ-73 8 8PMJ-43 83 GND 84 AD[09] 9 8PMJ-83 10 8PMJ-53 85 AD[0
