Summary of the content on the page No. 1
®
HOME APPLIANCES
Installation Instructions
30" Electric Range
Quick Reference
Table of Contents:
with self-cleaning
Pages
thermal/convection
2 Before you start
oven
3 Product dimensions
Cabinet dimensions/requirements
3- 4
4 Electrical requirements
5- 8 Installation steps
Freestanding
9 Check operation
Range
10 If range does not operate
10 If you need assistance/service
10
Moving the range
If you need assistance:
Check your Use and Care Guide for a toll-free number to
call or call the dealer
Summary of the content on the page No. 2
shown must be used. Given dimensions Before you start... are minimum clearances. Tools needed: Grounded electrical outlet is required. Your safety and the safety of See “Electrical requirements,” Page 4. others are very important. • level • flat-blade screwdriver We have provided many important Mobile home installation • 3/8" drive ratchet safety messages in this manual and The installation of this range must • 3/8" and 5/16" nut driver on your appliance. Always read and • hand or electric dri
Summary of the content on the page No. 3
Product dimensions Freestanding Range Slide-in Range 30" (76.2 cm) 8-1/4" cooktop (21 cm) width 30" (76.2 cm) 1-1/2" cooktop (3.8 cm) width 44-3/8" (112.7 cm) overall height 22-5/8" 36" (91.4 cm) (57.5 cm) cooktop height with feet loosened 36" (91.4 cm) 1-1/2 turns cooktop height with feet loosened 1" 1-1/2 turns (2.5 cm) 1" (2.5 cm) spacer 30" 30" (76.2 cm) (76.2 cm) 25-3/4" width 27-3/4" width (65.4 cm) (70.5 cm) When installed in a 24" depth with depth with (61 cm) base cabinet with
Summary of the content on the page No. 4
Slide-in ranges: countertop preparation The cooktop sides of the slide-in range fit over the cutout edge of your countertop. 30" (76.2 cm) If you have a square finish (flat) countertop and the opening 1/2" opening width is 30" (76.2 cm), no countertop width (1.3 cm) preparation is required. Formed front-edged countertops: Must have molded edge shaved flat 1/2" (1.3 cm) from each front corner 30-7/8" of opening. (78.4 cm) Tile countertops may need trim cut back 1/2" (1.3 cm) 22-5/8" from each f
Summary of the content on the page No. 5
Electrical connection Now start... WARNING WARNING Excessive Weight Hazard Use two or more people to move and install range. Tip Over Hazard terminal Failure to do so can result in back or block cover A child or adult can tip the range other injury. and be killed. 7. Remove the terminal block cover Connect anti-tip bracket to rear located on the back of range. range foot. Reconnect the anti-tip bracket, if 1. Put on safety glasses and gloves. the range is moved. Remove shipping materials, tape
Summary of the content on the page No. 6
Power supply cord method: NOTE: The bag containing three easily attach the wiring to the terminal 10. Connect the neutral wire (center wire) aluminum terminal lugs is not used block. to the center terminal screw on the when connecting the range using a terminal block. See Figure 2. 5. Use only ring-type terminals to power supply cord. connect the power supply. 11. Connect the other two wires (lines 1 and 2) to the outer screws on the 6. Complete electrical connection terminal block. See Figure 2
Summary of the content on the page No. 7
Direct wire method: Copper or Aluminum wire NOTE:The bag containing three 8. Attach three aluminum lugs to 6 gauge aluminum wire, tighten to aluminum terminal lugs must be used terminal posts. 35 in/lbs of torque to make a proper when making a direct wire connection. electrical connection. See Figure 2. Use a 3/8” nut driver and tighten the nuts securely. Nuts must be tightened 13. Tighten the locking ring of the to 20 in/lbs of torque for proper conduit connector. WARNING electrical connectio
Summary of the content on the page No. 8
Operating position 9. Move range close to cabinet opening. 10. Remove cardboard or 14. Place rack in oven. Place level hardboard from under range. Carefully on rack, first side to side; then front to move range into final position. back. If range is not level, pull range forward until rear leveling leg is removed from the anti-tip bracket. Use 3/8" drive ratchet and channel lock pliers to adjust leveling legs up or down until range is level. Push range back into position. Check that rear level
Summary of the content on the page No. 9
MED LO HI Check operation OFF 17. Push in and turn each surface unit control knob to "HI" position. Check the operation of the cooktop elements and indicator lights. MED NIGHT LIGHT DELAY START 1 2 3 CONTROL SET PROBE TEMP 18:88 TIME O LOCK START RAISING 888 F 8:88 STOP BREAD CHECK 18:88 18:88 TIME DEHYDRATE CONVECTION FOOD AT 56 MIN SEC ENTER STANDARD COOK TIME 4 HR MIN ON CLOSE CONTROL LOCK COOK TEMP CLEAN TIME EASY CONVECT DOOR LOCKED START ? COOK BROIL 7 8 9 CLOCK EASY CONVECT CON
Summary of the content on the page No. 10
Moving the range: If range does not If you need operate: service: WARNING Check that the circuit breaker is In the event that your KitchenAid not tripped or the house fuse appliance should need service, call blown. the dealer from whom you purchased the appliance or a Check that the power supply cord KitchenAid- authorized service is plugged into the outlet. company. A KitchenAid- authorized See Use and Care Guide for service company is listed in the troubleshooting list. Yellow Pages of y
Summary of the content on the page No. 11
Notes 11
Summary of the content on the page No. 12
® HOME APPLIANCES Part No. 9757988 © 2003 KitchenAid ® Registered Trademark of KitchenAid. Prepared by KitchenAid, Benton Harbor, Michigan 49022 Printed in U.S.A.
