Toro 1132-080-A user manual

User manual for the device Toro 1132-080-A

Device: Toro 1132-080-A
Category: Convection Oven
Manufacturer: Toro
Size: 3.1 MB
Added : 8/16/2014
Number of pages: 40
Print the manual

Download

How to use this site?

Our goal is to provide you with a quick access to the content of the user manual for Toro 1132-080-A. Using the online preview, you can quickly view the contents and go to the page where you will find the solution to your problem with Toro 1132-080-A.

For your convenience

If looking through the Toro 1132-080-A user manual directly on this website is not convenient for you, there are two possible solutions:

  • Full Screen Viewing - to easily view the user manual (without downloading it to your computer), you can use full-screen viewing mode. To start viewing the user manual Toro 1132-080-A on full screen, use the button Fullscreen.
  • Downloading to your computer - You can also download the user manual Toro 1132-080-A to your computer and keep it in your files. However, if you do not want to take up too much of your disk space, you can always download it in the future from ManualsBase.
Toro 1132-080-A User manual - Online PDF
Advertisement
« Page 1 of 40 »
Advertisement
Print version

Many people prefer to read the documents not on the screen, but in the printed version. The option to print the manual has also been provided, and you can use it by clicking the link above - Print the manual. You do not have to print the entire manual Toro 1132-080-A but the selected pages only. paper.

Summaries

Below you will find previews of the content of the user manuals presented on the following pages to Toro 1132-080-A. If you want to quickly view the content of pages found on the following pages of the manual, you can use them.

Abstracts of contents
Summary of the content on the page No. 1



SERVICE MANUAL
(DOMESTIC)

IMPINGER CONVEYOR OVENS

MODEL
1116-080-A, 1116-080-A1, 1117-080-A, 1117-080-A1,
1130-080-A, 1130-080-A1, 1131-080-A, 1131-080-A1,
1132-080-A, 1132-080-A1, 1133-080-A, 1132-080-A1,
1130-08H-A, 1131-08H-A, 1132-08H-A, 1133-08H-A,
1161-080-A, 1162-080-A

WITH PUSH BUTTON CONTROLS



Lincoln Foodservice Products, LLC
1111 North Hadley Road
Fort Wayne, Indiana 46804
United States of America

Phone : (800) 374-3004
U.S. Fax: (888) 790-8193 •

Summary of the content on the page No. 2

SEQUENCE OF OPERATION IMPINGER II ADVANTAGE, GAS (OVENS WITH PUSH BUTTON CONTROLS) MODEL 1116-080-A NAT. GAS 120VAC 60 HZ. 1 PHASE MODEL 1116-080-A1 NAT. GAS 120VAC 60 HZ. 1 PHASE MODEL 1117-080-A LP GAS 120VAC 60 HZ. 1 PHASE MODEL 1117-080-A1 LP GAS 120VAC 60 HZ. 1 PHASE POWER SUPPLY Electrical power is supplied to the oven by a three-conductor cordset. Voltage from the black conductor to the white conductor is 120VAC. Black conductor is hot White conductor is neutral. Green

Summary of the content on the page No. 3

SEQUENCE OF OPERATION IMPINGER II ADVANTAGE, ELECTRIC (OVENS WITH PUSH BUTTON CONTROLS) 1130-080-A 120/208VAC 60 HZ. 1 PHASE 1130-080-A1 120/208VAC 60 HZ. 1 PHASE 1130-08H-A 208 VAC 60 HZ. 1 PHASE 1131-080-A 120/240VAC 60 HZ. 1 PHASE 1131-080-A1 120/240VAC 60 HZ. 1 PHASE 1131-08H-A 240 VAC 60 HZ. 1 PHASE 1132-080-A 120/208VAC 60 HZ. 3 PHASE 1132-080-A1 120/208VAC 60 HZ. 3 PHASE 1132-08H-A 208 VAC 60 HZ. 3 PHASE 1133-080-A 120/240VAC 60 HZ. 3 PHASE 1133-080-A1

Summary of the content on the page No. 4

SCHEMATIC DIAGRAM MODEL 1116-080-A, 1116-080-A1, 1117-080-A, 1117-080-A1 4 Impinger II – Advantage Digital Express Service Manual - Domestic

Summary of the content on the page No. 5

SCHEMATIC DIAGRAM MODEL 1130-080-A, 1130-080-A1, 1131-080-A, 1131-080-A1 Impinger II – Advantage Digital Express Service Manual - Domestic 5

Summary of the content on the page No. 6

SCHEMATIC DIAGRAM MODEL 1132-080-A, 1132-080-A1, 1133-080-A, 1133-080-A1 6 Impinger II – Advantage Digital Express Service Manual - Domestic

Summary of the content on the page No. 7

SCHEMATIC DIAGRAM MODEL 1161-080-A Impinger II – Advantage Digital Express Service Manual - Domestic 7

Summary of the content on the page No. 8

SCHEMATIC DIAGRAM MODEL 1162-080-A 8 Impinger II – Advantage Digital Express Service Manual - Domestic

Summary of the content on the page No. 9

SCHEMATIC DIAGRAM MODEL 1130-08H-A, 1131-08H-A Impinger II – Advantage Digital Express Service Manual - Domestic 9

Summary of the content on the page No. 10

SCHEMATIC DIAGRAM MODEL 1132-08H-A, 1133-08H-A 10 Impinger II – Advantage Digital Express Service Manual - Domestic

Summary of the content on the page No. 11

TROUBLESHOOTING GUIDE GAS OVENS MODEL 1116-080-A NAT. GAS 120VAC 60 HZ. MODEL 1116-080-A1 NAT. GAS 120VAC 60 HZ. MODEL 1117-080-A LP GAS 120VAC 60 HZ. MODEL 1117-080-A1 LP GAS 120VAC 60 HZ. SYMPTOM POSSIBLE CAUSE EVALUATION Oven fan will not run Incoming power supply Check circuit breakers, reset if required. Check power plug to be sure it is firmly in receptacle. Measure incoming power, call power co. if needed. Fuse, 10 Amp Check, replace if necessary. Fuse holder Check, r

Summary of the content on the page No. 12

the main fan motor) to neutral. If no voltage is present, trace wiring back to the main power switch. If voltage is present, check for 120VAC at wire #22 (output of centrifugal switch) to neutral. If no voltage is present at #22, and the motor is running, replace the main fan motor. Hi-limit thermostat, Terminals are normally closed. If open, reset oven cavity thermostat and retest. If thermostat will not hold for maximum oven temperature, and oven is not exceeding temperature setti

Summary of the content on the page No. 13

occur. If flame is not detected, the ignition control will shut off and lock out. To reset the ignition control, turn off the power switch for 45 seconds, then turn the switch on to re-try ignition. The ignition control requires a minimum of 0.8 DC microamps to prove flame. To check flame sensing operation, connect a digital multimeter (capable of measuring DC microamps) between the “ground” terminal on ignition control and the ground lead. NOTE: This is a current measurement and the me

Summary of the content on the page No. 14

Oven control If the thermocouple checks good, but the oven control display indicates that there is a thermocouple failure, replace the oven control. If the oven control indicates a temperature reading but the oven won’t heat, proceed. Thermocouple WITH POWER ON AND THERMOCOUPLE ATTACHED TO THE OVEN CONTROL: Measure the DC millivolt output of the thermocouple. Refer to the thermocouple chart (located in the “Removal” section of the manual) for proper millivolt readings. If these readi

Summary of the content on the page No. 15

needed. WARNING: Capacitor has a stored charge, discharge before testing. Switch, conveyor reversing Check continuity between switch terminals. Replace switch as needed. Oven control If there is 120VAC supplied to the motor, and the motor, capacitor, and reversing switch check good, replace the oven control. Conveyor motor runs, but NOTE: Display will indicate there is no speed display “Belt Jam” Oven control Check for output voltage from oven control to hall effect sensor (sens

Summary of the content on the page No. 16

TROUBLESHOOTING GUIDE ELECTRIC OVENS 1130-080-A 120/208VAC 60 HZ. 1 PHASE 1130-080-A1 120/208VAC 60 HZ. 1 PHASE 1130-08H-A 208 VAC 60 HZ. 1 PHASE 1131-080-A 120/240VAC 60 HZ. 1 PHASE 1131-080-A1 120/240VAC 60 HZ. 1 PHASE 1131-08H-A 240 VAC 60 HZ. 1 PHASE 1132-080-A 120/208VAC 60 HZ. 3 PHASE 1132-080-A1 120/208VAC 60 HZ. 3 PHASE 1132-08H-A 208 VAC 60 HZ. 3 PHASE 1133-080-A 120/240VAC 60 HZ. 3 PHASE 1133-080-A1 120/240VAC 60 HZ. 3 PHASE 1133-08H-A 240 VAC 60 H

Summary of the content on the page No. 17

Oven fan relay Check for 120VAC to relay coil, if no voltage is present, trace wiring back to 20 minute time delay. If voltage is present, be sure that relay contacts stay closes during the 20 minute cool down. Replace relay as needed. Main fan runs after Oven start relay Contacts should open when main power switch is 20 minute cool down turned off. Replace relay as needed. 20 Minute time delay 120VAC at terminal #2 should discontinue approx. 20 minutes after main power is switched of

Summary of the content on the page No. 18

24VAC is present, check for a read-out on the display. If there is 24VAC supplied, but there is no read-out on the control display, replace the oven control. If there is a read-out on the control, set the control to maximum temperature (see installation operations manual for temperature adjustment). With the control set at maximum temperature, check for supply voltage at mercury contactor. If there is voltage at the mercury contactor, proceed to “mercury contactor” for next check. If

Summary of the content on the page No. 19

closed position. If there is no voltage to the operating coil, but there is high voltage at the contactor output, replace the mercury contactor. Intermittent heating Thermal/overload of motor The main fan motor is equipped with internal thermal protection and will cease to operate if overheating occurs. As the motor overheats and then cools, this will cause the oven to cycle on and off intermittently. Improper ventilation or lack of preventive maintenance may cause this. Also, most of t

Summary of the content on the page No. 20

approx. 10VDC. If no voltage is present, trace wiring back to oven control. If there is no voltage present at the oven control, replace the oven control. Conveyor motor If there is voltage supplied to the hall effect sensor, check for a frequency output from the hall effect sensor. Measure frequency across the yellow and white wires at the motor connector. Frequency reading should be approx. 25 – 100 Hz. If these readings are not achieved, replace conveyor motor. If the readings are a


Alternative user manuals
# User manual Category Download
1 Toro TRUE User manual Convection Oven 1
2 Toro 1132-08H-A User manual Convection Oven 1
3 Toro 1130-080-A1 User manual Convection Oven 2
4 Toro 1117-080-A1 User manual Convection Oven 1
5 Toro 1116-080-A1 User manual Convection Oven 1
6 Toro 1132-080-A1 User manual Convection Oven 2
7 Toro 1131-080-A User manual Convection Oven 1
8 Toro 1133-080-A User manual Convection Oven 1
9 Toro 1131-080-A1 User manual Convection Oven 1
10 Toro 1130-080-A User manual Convection Oven 1
11 Toro 1131-08H-A User manual Convection Oven 1
12 Toro 1117-080-A User manual Convection Oven 1
13 Toro 1116-080-A User manual Convection Oven 1
14 Alto-Shaam Inc.767-SK/III User manual Convection Oven 14
15 AEG KB7100000 User manual Convection Oven 10
16 Alto-Shaam Inc.1000-TH/III User manual Convection Oven 1
17 Alto-Shaam PLATINUM ASC-2E User manual Convection Oven 1
18 AEG BE3013021 User manual Convection Oven 69