AudioEngine A5+ user manual

The Audioengine A5+ is a set of powered speakers that is designed to provide a full range of sound including deep bass. The A5+ has built-in dual analog amplifiers and a rear-firing bass port, which allows it to produce impressive low frequencies on its own. However, if you desire even more powerful and room-filling bass, you may consider adding a subwoofer to complement the A5+. Adding a subwoofer is optional and depends on your personal preference and the desired audio experience.

Several problems could be causing your Audioengine A5+ not to work.
1. Power Issues: Check to ensure the power plug is correctly inserted in the power socket and that the socket is turned on.

. Incorrect Input Selection: Ensure that the speaker input match with the source output.
3. Incorrect Volume: Check the volume on your sound source and on the speaker. If either is too low, you may not hear any sound.
4. Connection Issues: Check your connections. If you're using Bluetooth, try to disconnect and reconnect. If you're using a cable, ensure it is properly plugged in. Also, try a different cable if possible, as the one you're using might be damaged.
5. Defective Audio Source: Test your speaker with another audio source. The problem might be with the audio source and not the speaker.
6. Speaker is muted: Ensure that the speaker is not muted.
7. Hardware or firmware issue: If none of the above steps work, there could be a problem with the hardware or firmware of your speaker. If this is the case, contact Audioengine support or your retailer for further assistance.
Remember that the specific problem may vary based on whether you're using a wireless or wired connection, the type of device you're connecting, etc. Always refer to the user manual for specific troubleshooting steps for your model.

To pair the Audioengine A5+ speakers with Bluetooth, follow these steps:
1. Turn on your A5+ speakers and make sure the Bluetooth switch on the back of the right speaker is in the "On" position.
. On your Bluetooth-enabled device (such as a smartphone or computer), go to the Bluetooth settings.
3. Enable Bluetooth if it's not already on, then search for available devices.
4. Look for the Audioengine A5+ in the list of devices and select it.
5. Enter the PIN code "0000" to pair your devices, if prompted.
6. Once successfully paired, your device should indicate that it is connected to the A5+ speakers.
Note: It's important to have your device located within a close range of the speakers during the pairing process to ensure a strong and stable connection.