Epson WORKFORCE-WF-3620 user manual

The Epson WorkForce WF-3620 was released in 2014.

Follow these steps to connect your Epson WorkForce Printer to your computer:
1. Unpack your printer according to the manufacturer’s instructions.
2. After successfully unpacking, place your printer in a convenient location where you can easily access it.
3. Turn on your printer by pressing the power button.
4. After successfully turning on the printer, connect it to your computer using a USB Cable (usually provided with the printer).
5. Connect the USB cable to the appropriate port on your printer and the other end to an available port on your computer.
6. Your computer should automatically detect the printer.
7. After the successful connection, you will need to install the printer’s software. You can do that using a CD that comes with the printer that contains the software or you can download the software from the official Epson website.
8. Launch the software setup. Follow the installation instructions on your screen.
9. After successful installation, your printer will be ready to use.
Note: Epson also offers wireless printers. The process of connection will slightly differ if you are using a wireless printer model. For a wireless connection, you need to connect the printer to your Wi-Fi network using the printer's built-in menu system, and then add the printer in your computer's Printer settings.

To connect your Epson WF 3620 printer to Wi-Fi, you can follow the steps below:
1. Ensure that your printer is turned on, and the Wi-Fi connection is active.
. On the printer's control panel, press the "Home" button.
3. Use the arrow buttons to navigate to the "Wi-Fi Setup" or "Network Settings" option and press the OK button.
4. Select the "Wi-Fi Setup Wizard" or "Wi-Fi Setup" option and press OK.
5. The printer will search for available Wi-Fi networks. Choose your network from the list and press OK.
6. If your network is password-protected, enter the password using the numeric keypad on the control panel (if applicable) and press OK.
7. Wait for the printer to establish a connection to your Wi-Fi network. It may take a few moments.
8. Once the connection is established, you will see a confirmation message on the printer's screen.
9. You can now install the printer driver on your computer and add the printer to your devices.
Note: The exact steps may vary slightly depending on the printer's firmware version and the control panel design. If you encounter any difficulties, you can refer to the printer's user manual or contact Epson customer support for further assistance.

To reset your Epson WorkForce WF-3620 printer, you can follow these steps:
1. Turn off your printer and unplug it from the power source.
. Wait for a few minutes to allow the printer to completely power down.
3. While the printer is still unplugged, press and hold the power button for about 60 seconds.
4. Release the power button.
5. Plug the printer back into the power source.
6. Turn on the printer and wait for it to initialize and start up.
This procedure will reset the printer's internal settings and potentially resolve any software-related issues. However, keep in mind that performing a reset may also clear any custom settings you may have made, so be prepared to reconfigure your preferences after the reset.