Graco PACK-N-PLAY-ON-THE-GO user manual

To change the battery in your Graco pack and play, you will need to follow these steps:
1. Locate the battery compartment: Look for a small panel or door on the side or bottom of the pack and play. This is where the battery is usually housed.
2. Open the battery compartment: Use a screwdriver or your fingers (depending on the type of latch) to open the battery compartment door. Be careful not to force it open as you may damage it.
3. Remove the old battery: Take out the old or dead battery from the compartment. Pay attention to the polarity markings, usually indicated by plus (+) and minus (-) signs.
4. Insert the new battery: Take the new battery and ensure it is compatible with your Graco pack and play. Insert it into the battery compartment, aligning the plus and minus ends correctly with the corresponding markings.
5. Close the battery compartment: Once the new battery is securely in place, close the battery compartment door by pressing it shut or tightening the latch with a screwdriver.
6. Test the new battery: Turn on your Graco pack and play to see if the new battery is functioning properly. If it doesn't work, double-check the polarity and make sure the battery is correctly inserted.
Note: The battery type and installation method may vary slightly depending on the specific model of your Graco pack and play. It's always recommended to refer to the manufacturer's instructions or consult the user manual for detailed guidance.