JBL ENDURANCE-PEAK user manual

To control your JBL Endurance Peak wireless earphones, you can use the following steps:
1. Power On/Off: To turn your earphones on, press and hold the power button located on the right earpiece for about 3 seconds until you see the LED lights flashing. Repeat the same process to turn them off.
2. Pairing: To connect your Endurance Peak with a Bluetooth device, ensure the earphones are in pairing mode (LED lights flashing rapidly). Go to the Bluetooth settings on your device, search for available devices, and select "JBL Endurance Peak" to pair.
3. Volume control: Use the volume buttons on the right earpiece to increase or decrease the volume. Press the top button to increase and the bottom button to decrease the volume.
4. Play/Pause and Skipping Tracks: To play or pause music, press the center button on the right earpiece once. To skip to the next track, press and hold the center button for about 2 seconds. For the previous track, press and hold the center button on the left earpiece for about 2 seconds.
5. Call Management: To answer an incoming call, press the center button on the right earpiece once. To end a call, press the same button again. If you wish to reject a call, press and hold the center button for about 2 seconds.
6. Voice Assistant: Press and hold the center button on either earpiece for about 2 seconds to activate voice assistant functions, such as Siri or Google Assistant, depending on your device.
Note: The exact control mechanisms may vary slightly based on the specific JBL Endurance Peak model you own. It is recommended to refer to the user manual that came with your earphones for more detailed instructions.

To know if your JBL Endurance Peak is fully charged, you can follow these steps:
1. Make sure your earbuds are placed inside the charging case.
. Connect the charging case to a power source using the included USB cable.
3. Look for the LED indicators on the charging case:
- When you connect the charging case to a power source, the LED indicator on the front of the case will blink white briefly, indicating that it's charging.
- While the case is charging, the LED indicators will remain lit or blink white.
- Once the charging case is fully charged, the LED indicators will stop blinking and remain steady, indicating a full charge.
Please note that the earbuds will be charging simultaneously inside the case when connected to a power source.