Kenwood KID60X16 user manual

The F2 error code on a Kenwood dishwasher indicates a water leak in the appliance. When the dishwasher detects a leak, it will display the F2 error code. It's recommended to unplug the appliance and check for potential leaks or water damage. If you're unable to locate or fix the issue, consider contacting a professional appliance technician.

There could be several reasons why your Kenwood dishwasher may not be working. Here are a few possible causes:
1. Power supply: Ensure that the dishwasher is properly plugged in and that there is power reaching the appliance. Check if the circuit breaker or fuse has tripped or blown and reset/replace if necessary.
2. Door not closed properly: Confirm that the dishwasher door is properly closed and locked. Some models may not start if the door is not securely closed.
3. Water supply issue: Ensure that the water supply valve is turned on and providing sufficient water pressure to the dishwasher. Check for any kinks or blockages in the water supply hose.
4. Clogged filters or spray arms: If the filters or spray arms are clogged with food particles or debris, it can hinder the dishwasher's performance. Clean the filters and remove any obstructions from the spray arms.
5. Faulty control panel: A malfunctioning control panel could be preventing the dishwasher from starting or operating correctly. Try resetting the control panel, or if the issue persists, contact Kenwood customer service for further assistance.
6. Malfunctioning pump or motor: If the dishwasher is not draining water or making strange noises, it could indicate a problem with the pump or motor. In such cases, it may require professional repair or replacement.
If troubleshooting these common issues does not resolve the problem, it is recommended to consult the Kenwood user manual or contact their customer support for more specific troubleshooting steps or to schedule a service appointment with a technician.

The E4 error code on a Kenwood dishwasher indicates a drainage issue. There are a few possible reasons why your dishwasher is not draining with this error code:
1. Clogged drain hose: Check if the drain hose is blocked or kinked. Remove any obstructions or straighten out any kinks that may be preventing proper water flow.
2. Clogged filter or drain pump: Inspect the dishwasher's filter and the drain pump for any debris or blockages. Clean or replace the filter and clear any obstructions in the drain pump if necessary.
3. Faulty drain pump: If the drain pump is not working correctly, it may be unable to effectively remove the water from the dishwasher. In this case, the drain pump may need to be repaired or replaced.
4. Siphoning issue: A dishwasher drain can sometimes create a siphoning effect, causing the water to continuously drain and prevent normal operation. Ensure that the drain hose is properly installed and has an air gap to prevent siphoning.
If you have attempted these troubleshooting steps and the dishwasher still does not drain, it may be best to contact a professional appliance repair technician or Kenwood customer support for further assistance.

The E3 error code on a Kenwood dishwasher typically indicates an issue with the water temperature. It usually means that the dishwasher is not heating the water to the required temperature during the wash cycle. This can be caused by a malfunctioning heating element, a faulty thermostat, or a problem with the control board. It is recommended to consult the dishwasher's user manual or contact a qualified technician for further assistance in troubleshooting and resolving the issue.