Marantz PM6006 user manual

The Marantz PM6006 is a stereo integrated amplifier that offers 45 watts per channel into an 8-ohm load.

Yes, the Marantz PM6006 Integrated Amplifier does have a Digital-to-Analog Converter (DAC). It actually comes with a 192kHz/24bit Digital to Analog Converter to provide high sound quality.

The frequency response of the Marantz PM6006 is 10 Hz - 70 kHz (+1, -3 dB).

There could be several reasons why there is no sound coming from your Marantz PM6006. Here are a few troubleshooting steps you can try:
1. Make sure that the speaker wires are properly connected to the speaker outputs on the back of the amplifier and to the speakers themselves. Ensure that there are no loose connections or frayed wires.
2. Check that the volume on the amplifier is turned up and not set to a minimum level. Also, verify that none of the mute or tone control settings are enabled on the amplifier.
3. Ensure that the input source you are using (such as a CD player or turntable) is connected properly to the amplifier's input jacks. Check the cables for any damage and try using a different input source to rule out a problem with the source itself.
4. Check the speaker impedance and the amplifier's speaker impedance settings. Ensure that the speakers you are using are compatible with the amplifier's impedance range.
5. Try resetting the amplifier by turning it off, unplugging the power cord, waiting for a few minutes, and then plugging it back in and turning it on again.
If none of these steps resolve the issue, there might be a problem with the amplifier itself. In that case, it would be recommended to contact Marantz customer support or take the unit to an authorized service center for further assistance.