Plantronics EXPLORER-500 user manual

If you're trying to reset Plantronics USB dongle (BT600 or BT300), you can follow these steps:
1. Plug the dongle into your computer.
. Wait for your computer to recognize the dongle. This might take a few moments.
3. Push and hold the small button on the dongle. The LED will flash red and blue.
4. Continue to hold the button for 6 seconds, then release. The LED will now flash purple.
5. If the LED does not flash purple, try again. Make sure you're holding the button down for full 6 seconds.
6. Once the LED flashes purple, the dongle has been reset.
Remember, however, resetting the BT600 or BT300 network adapter will clear pairing memory. The adapter must be re-paired to your headset after it has been reset.
However, if you're still having issues, contacting Plantronics Support may provide you with the most accurate information. This is currently the available procedure to follow, but this information may differ depending on the model of your device, so it's recommended to refer to your user manual or contact Plantronics' support directly.

To pair your Plantronics Explorer-500 headset, follow these steps:
1. Turn on the Bluetooth on your mobile device or computer.
. With the headset turned off, press and hold the power button on the Explorer-500 for about 5-6 seconds until the LED flashes red and blue.
3. The headset will enter pairing mode, and you will hear a voice prompt saying "pairing."
4. On your mobile device or computer, go to the Bluetooth settings and search for available devices.
5. Select "PLT Explorer 500" from the list of discovered devices.
6. If prompted, enter the passcode "0000" (four zeros) to complete the pairing process.
7. Once connected, the LED on the headset will stop flashing, and you will hear a voice prompt saying "headset connected" or similar confirmation.
Your Plantronics Explorer-500 should now be successfully paired with your device, and you can use it for hands-free communication.

The Bluetooth button on the Plantronics Explorer 500 headset is located on the backside of the main body, towards the bottom. It is marked with the Bluetooth icon.