TP-Link TL-SG108 user manual

No, the TP-Link TL-SG108 is an unmanaged switch. It does not have any management features or capabilities.

The TP-Link TL-SG108 is an unmanaged 8-port gigabit switch, which means it can support network speeds of up to 1000 Mbps (or 1 gigabit per second) on all of its ports. This makes it suitable for high-speed data transfers and streaming applications.

The lights on a TP-Link Ethernet switch indicate the status and activity of the ports and the switch itself. Here is the general meaning of the lights on a TP-Link Ethernet switch:
1. Power LED: Indicates that the switch is receiving power.
2. System LED: This light indicates the operational status of the switch. It usually turns solid green when the switch is functioning properly.
3. Link/Act LED: Each port on the switch has a Link/Act LED. The LED will be lit if a network cable is properly connected and transmitting data. It may blink when there is data activity. If the LED is off, it means there is no link detected or the port is not active.
4. Speed LED: Some switches have an additional Speed LED on each port. The LED may turn green if the port is connected to a device with a 1000Mbps (Gigabit) connection or an amber color for a 10/100Mbps connection.
Note that the exact configuration and behavior of the lights might vary slightly between different models and generations of TP-Link Ethernet switches. It is advisable to consult the user manual or documentation specific to your switch for accurate information.

To reset your TP-Link TL-SG108 switch, follow these steps:
1. Locate the reset hole on the back of the switch. It is a small hole labeled "RESET".
. Use a paperclip or a similar pointed object to press and hold the reset button for about 5-10 seconds until the LED indicators flash.
3. Release the reset button and wait for the switch to reboot.
4. Once the switch has finished resetting, it will return to its factory default settings.
Note: Resetting the TL-SG108 will erase all the configuration and settings, including username, password, and IP address information. You will need to reconfigure it after the reset.