Uniden DECT-1635 user manual

There could be several reasons why your Uniden phone is going straight to the Message Bank. Here are a few possibilities:
1. Call forwarding: Check for any call forwarding settings on your phone. If call forwarding is enabled, your calls might be automatically redirected to the Message Bank.
2. Do Not Disturb mode: Make sure that Do Not Disturb mode is not activated on your phone. When enabled, it blocks all incoming calls and sends them directly to the Message Bank.
3. Incorrect answering mode: Ensure that the answering mode is set to the desired option. Depending on your phone model, it could have options like Answering Machine mode, VoiceMail mode, or others. Select the appropriate mode to avoid calls being automatically sent to the Message Bank.
4. Number of rings before voicemail: Check the number of rings set on your phone before it goes to voicemail. If it is set to a low number, such as one or two rings, calls may not have enough time to be answered manually and will go directly to voicemail.
5. Network or service provider settings: Contact your service provider to check if there are any settings on their end that could be causing the issue. They can assist you in troubleshooting specific to your network or service.
If none of these suggestions resolve the issue, it may be helpful to consult the user manual for your Uniden DECT-1635 phone or reach out to Uniden customer support for further assistance.

To reset a Uniden DECT phone, you can follow these steps:
1. Disconnect the phone line from the phone base.
. Remove the phone's battery from the handset.
3. Wait for around 15-30 seconds.
4. Reconnect the phone line to the phone base.
5. Re-insert the battery into the handset.
6. Place the handset back on the base to re-establish the connection.
7. Allow the phone to reset and reinitialize, which may take a few minutes.
After completing these steps, your Uniden DECT phone should be reset and ready to use.

There could be multiple reasons why your Uniden DECT-1635 phone base is not working. Here are a few possible reasons and troubleshooting steps you can try:
1. Power issue: Ensure that the phone base is properly connected to a power source and that the power cord is securely plugged in. Also, check if the power outlet is working by plugging another device into it.
2. Battery issue: If your phone base has a cordless handset, check if the battery is properly inserted and charged. If it's a new handset, allow it to charge for at least 15 hours before trying to use it.
3. Phone line issue: Check if the phone line is properly connected to the phone base and if the line is functional. Try connecting a different phone to the same phone line to check if it's working.
4. Check the phone settings: Make sure the phone base is not in "Do Not Disturb" mode or any other settings that might prevent it from receiving or making calls. Consult the user manual for instructions on accessing and modifying the settings.
5. Reset the phone base: If none of the above steps work, try resetting the phone base to its factory defaults. Consult the user manual for instructions on how to perform a reset.
6. Contact Uniden support: If the issue persists, reaching out to Uniden customer support or referring to their troubleshooting resources may provide further assistance.
Remember, the above steps are general suggestions, and it's always recommended to consult the user manual or contact customer support for specific instructions related to your Uniden DECT-1635 phone base model.