Instrukcja obsługi Hobo International PENDANT G UA-004-64

Streszczenie treści zawartej na stronie nr. 1

®
HOBO Pendant G
Acceleration Data Logger
(Part # UA-004-64)

Inside this package:
Thank you for purchasing a HOBO data logger. With proper care, it will
• HOBO Pendant G Acceleration Data
give you years of accurate and reliable measurements.
Logger
The HOBO Pendant G Acceleration Data Logger is a waterproof,
• Mounting bracket and screw
three-channel logger with 8-bit resolution and can record up to
approximately 21,800 combined x-, y-, and z-axis acceleration readings or
internal

Streszczenie treści zawartej na stronie nr. 2

HOBO Pendant G Acceleration Data Logger You can read out the logger or check its status while it continues to Connecting the logger log (in Normal logging mode only); stop it manually with the software; or let it record data until the memory is full. Refer to the The HOBO Pendant G logger requires HOBOware Pro or software user’s guide for complete details on launching, reading out, HOBOware Lite, and either of the following to connect to the and viewing data from the logger. computer:

Streszczenie treści zawartej na stronie nr. 3

HOBO Pendant G Acceleration Data Logger Periodically inspect the desiccant and dry it if it is not bright blue. Operation The desiccant pack is located in the cap of the logger. To dry the A light (LED) on the front of the logger confirms logger operation. desiccant, remove the desiccant pack from the cap and leave the pack The following table explains when the light blinks during logger in a warm, dry location until the bright blue color is restored. (Refer operation. to the “Battery”

Streszczenie treści zawartej na stronie nr. 4

HOBO Pendant G Acceleration Data Logger 7. Replace the end cap, ensuring that the desiccant pack is tucked WARNING: Do not cut open, incinerate, heat above 85°C into the cap, and the o-ring is seated in the groove, not pinched or (185°F), or recharge the lithium battery. The battery may explode twisted. Make sure no dirt or lint is trapped on the o-ring, as this if the logger is exposed to extreme heat or conditions that could could result in a leak. damage or destroy the battery case.