Instrukcja obsługi Closet Maid 16" Deep 4' Garage Organizer 3596

Streszczenie treści zawartej na stronie nr. 1

Installation Instructions
Instructions d’Installation
Instrucciones de Instalación
3596
16" Deep 4' Garage Organisateur de Garage de Organizador de Garaje de
1,22 m par 40,6 cm de 1,22 m x 40,6 cm de
Organizer
Profondeur Profundo
Tools and Outils et Herramientas y
NOTE: Please read all instructions carefully before beginning.
Materials Matériaux Materiales
REMARQUE : Veuillez lire les instructions avec attention
Not supplied
avant de commencer. Non compris
No incluido
N O TA : Lea todas las in

Streszczenie treści zawartej na stronie nr. 2

NOTE: For ease of installation, perform all of the following steps for each individual 3 shelf and repeat for remaining shelves. 3. Place a steel clip (included) over back wire of shelf 8" in from EACH end of shelf. Place and center remaining clip 16" from each end clip. Close all three clips. 4. Hold shelf so clips are against wall and aligned with three studs. Align clip hole with marked stud location on wall. Use supplied (1-1/2") screw to secure clip to wall (through drywall and directly

Streszczenie treści zawartej na stronie nr. 3

CONCRETE INSTALLATION: 4' 1 1,22 m 1. Mark a LEVEL line 4' wide. Measure a minimum of 14" down from first marked line and draw a second 4' line (be sure sides are x x x aligned). Repeat for third 4' line. Measure and mark an "x" 8" in 8" 8" 16" 16" 14" 20,3 cm 40,6 cm 20,3 cm from each end of line and 16" apart as shown in diagram. 40,6 cm 35,5 cm 2. Drill 1/4" holes at all marked locations (be sure drilled hole depth x x allows for 1-1/2" long screws) Insert a gray anchor into each dril

Streszczenie treści zawartej na stronie nr. 4

3 NOTE: For ease of installation, perform all of the following steps for each individual shelf and repeat for remaining shelves. 3. Place a steel clip (included) over back wire of shelf 8" in from one end of shelf. Place remaining clips 16" apart (last clip should be 8" from other end of shelf). Close all clips. 4. Hold shelf so clips are against wall. Align clip hole with drilled hole in wall. Use supplied (1-1/2") screw to secure clip to wall (through anchor). Repeat for remaining clips. A