Instrukcja obsługi Psiber Data Systems 10

Streszczenie treści zawartej na stronie nr. 1

PORT IDENTIFICATION
Connect the Model 10 to a wall outlet,
select “Port ID” and then go to the hub or
CABLETRACKER
switch connected to the wall outlet. The Link
NETWORK ID KIT
light for the port connected to the wall outlet will
blink at a rate similar to the pattern selected on
USER’S GUIDE
the Model 10. Three patterns are provided.
SHORT CIRCUIT TEST
Connect the Model 10 to a cable with the
test leads and select “Short”. If a short is
detected, the LED will stay on continuously
otherwise the L

Streszczenie treści zawartej na stronie nr. 2

OPERATION CONTENTS The Model 10 Signal Generator features •Model 10 Signal Generator •User Guide •Model 15 Probe • RJ-45 Patch Cable one button operation. Each press of the TEST •Red/Black Alligator Test Leads button advances the operating mode of the unit. •Carrying Case (CTK1015 Kit Only) The modes are selected in the following order: 1. Low Frequency Tone Pattern 1 BATTERY 2. Low Frequency Tone Pattern 2 The CableTracker Model 10 Signal 3. High Frequency Tone Pattern 1 Generator