Streszczenie treści zawartej na stronie nr. 1
T
A
N
C
O
Y
N
S
S
A
I
I
A
A
P
A
R
O
M
R
R
P
A
A
L
U
ELECTRIC FIREPLACE MANTEL Crafted in a Traditional Style
MANTEAU DE CHEMINÉE ÉLECTRIQUE Confectionné en style traditionnel
REPISA DE CHIMENEA ELÉCTRICA Fabricado con diseño tradicional
Assembly Instructions
MM253OK Instructions d'assemblage
YEAR
ANN E
11 1 A!O
Instrucciones de montaje
REV01
W
S
"
N
E
E
E
I
T
M
A
N
#
O
T
G
A
N
H
R
I
A
A
A
G
N
R
Streszczenie treści zawartej na stronie nr. 2
TIPS FOR THE ASSEMBLY OF YOUR NEW MANTEL • Before you begin assembly, locate the instructions and hardware. Take out all the parts and compare them to the diagrams below. Be sure you have all the parts and can identify them. • A helping hand is always good. Assemble your mantel with an adult assistant if possible. Some pieces are heavy and will need to be held by a helper. Assembly time will take approximately 30-60 minutes. OUTSIDE INSIDE VIEW VIEW BASE 1PC ZZ.253OK.01 LEFT SIDE PANEL RIGHTS
Streszczenie treści zawartej na stronie nr. 3
GET READY TO START Before assembly, use scissors to unwrap the parts from the packaging. DO NOT use a box cutter or exacto-knife as you may cut into the mantel pieces inside the box and damage the finish. Check for the hardware bag which is RED and located inside the packaging, taped to the top box. Be sure you DO NOT discard any pieces. Use an appropriate screwdriver to insert and tighten all screws. Step 1 Locate the base and place it on the floor. DO NOT put it up against the wall at this p
Streszczenie treści zawartej na stronie nr. 4
Step 4 Locate the central panel and position it by resting the panel on the front legs of the left and right front panels. Make sure the holes are lined up, then insert and tighten 1 screw on each side. OUTSIDE VIEW Step 5 Locate the upper facing panel that will be attached to the left and right legs and will sit above the firebox behind the central panel. Position this panel with the finished oak side facing the front of the mantel. Line up the holes on each side and insert and tighten 2 screw
Streszczenie treści zawartej na stronie nr. 5
Step 7 Take your electric firebox out of its packaging and position it between the 2 legs of the mantel. Once you are close to the wall, plug the firebox into the nearest outlet. The firebox comes with 3 metal brackets and 20 black screws. These metal brackets must be attached to both the sides of the firebox and the mantel to ensure that your firebox does not move around as you use it. 2 of the brackets have 2 large holes on one side. These large holes line up with the 2 screws on the side
Streszczenie treści zawartej na stronie nr. 6
WARRANTY Greenway Home Products is pleased to offer in-home warranty repairs. Please refer to your Firebox Use and Care Guide for warranty information on your Firebox. DO NOT RETURN THIS PRODUCT TO THE STORE: Please contact Customer Service at: 1-866-253-0447 AM PM AM PM Monday to Thursday from 8:30 to 5:00 (EST), Friday from 8:30 to 4:00 (EST) Web: www.greenwayhp.com Email: support@greenwayhp.com Canada: 400 Southgate Dr., Guelph, Ontario, Canada, N1G 4P5 USA: 6507 Fairfield Dr., Northwood,Oh
Streszczenie treści zawartej na stronie nr. 7
Due to the properties of natural wood, Greenway Home Products makes no warranty against mineraling of wood components. Greenway Limited Warranty is void unless the following conditions are adhered to: 1. Warranty registration must be completed and returned to a Greenway Home Products. 2. All warranty repairs must be preauthorized by a Greenway repair facility. 3. Greenway reserves the right to inspect defective parts that have been replaced under warranty. Dealer is expected to hold defective
