Instrukcja obsługi Apple 073-0562

Streszczenie treści zawartej na stronie nr. 1

Power Mac G4 / Macintosh Server G4
Video Card
Replacement Instructions
Be sure to follow the instructions in this sheet carefully. Failure to follow these instructions
could result in damage to your equipment and may void your warranty.
Note: Written and video instructions covering customer-installable parts are available at
http://www.info.apple.com/installparts/.
Tools Required
• Phillips screwdriver
• Pliers
Opening the Computer
Warning: Always turn off your computer befo

Streszczenie treści zawartej na stronie nr. 2

8. Lift the latch on the right side access panel. (Figure 1B) 9. Gently lower the access panel until it lies flat. To avoid scratching the case, lower the panel onto a soft, clean cloth. (Figure 2) Warning: If you see any lights glowing on the main logic board, the computer has not been shut down. Close the side access panel and shut down the computer before proceeding. Removing the Installed Card Important: Video cards are either accelerated graphics port (AGP) cards

Streszczenie treści zawartej na stronie nr. 3

• Pull the card gently to see if it is properly connected. If it resists and stays in place, and if its gold connectors are barely visible, the card is connected. 4. Replace the card’s mounting screw and tighten it to secure the card. Closing the Computer 1. Raise the side access panel, lift the latch, and press the panel against the case until it snaps securely into place. 2. Reconnect all cables and restart your computer. Warning: Never turn on your computer unless all of its int

Streszczenie treści zawartej na stronie nr. 4

1 B A 2 Power Mac G4 Video Card - 4

Streszczenie treści zawartej na stronie nr. 5

3 C AGP slot A B 4 Power Mac G4 Video Card - 5

Streszczenie treści zawartej na stronie nr. 6

5 B B C A Power Mac G4 Video Card - 6