Resumo do conteúdo contido na página número 1
Installation Instructions
98014964 98014964
30" (76.2 cm) Freestanding Gas Range
with standard clean oven
WARNING
Quick Reference
Table of Contents:
Pages
Before you start
2
3 Product dimensions
Cutout dimensions/requirements
3
Tip Over Hazard
4 Electrical requirements
Achild or adult can tip the range and
Gas supply requirements
4- 5
be killed.
Connect anti-tip bracket to rear 5- 7 Installation steps
range foot.
Gas conversions
8- 9
Reconnect the anti-tip bracket, if the
range is moved. 10 M
Resumo do conteúdo contido na página número 2
Cabinet opening dimensions shown must Before you start... liquids in the vicinity of be used. Given dimensions are minimum clearances. this or any other Your safety and the safety of To eliminate the risk of burns or fire by appliance. others are very important. reaching over heated surface units, — WHAT TO DO IF YOU cabinet storage space located above the We have provided many important safety surface units should be avoided. If messages in this manual and on your SMELL GAS cabinet storage is t
Resumo do conteúdo contido na página número 3
Resumo do conteúdo contido na página número 4
Recommended Electrical requirements In the State of Massachusetts, the ground method following installation instructions apply: For personal safety, this range is equipped with a power supply cord • Installations and repairs must be WARNING having a 3 prong ground plug. To performed by a qualified or licensed minimize possible shock hazard, the cord contractor, plumber, or gasfitter must be plugged into a mating 3 prong, qualified or licensed by the State of ground-type outlet, grounded in Mass
Resumo do conteúdo contido na página número 5
Flexible metal appliance connector: If Line pressure testing at 1/2 psi gauge local codes permit, a new CSA design- (14" WCP) or lower — The range must be WARNING certified, 1/2" or 3/4" I.D., flexible metal isolated from the gas supply piping appliance connector is recommended for system by closing its individual manual connecting range to the gas supply line. shutoff valve during any pressure testing A 1/2" male pipe thread nipple is needed of that system at test pressures equal to for connec
Resumo do conteúdo contido na página número 6
All connections must be wrench-tightened. 7. Making sure the anti-tip bracket is 13. Check that range regulator installed: shutoff valve is in the “on” position. Open 90˚elbow the manual shutoff valve in the gas • Look for the anti-tip bracket securely supply line. attached to floor. black iron • Slide range back so rear range foot is pipe under anti-tip bracket. pressure regulator connection fitting viewed from union inside broiler manual Typical compartment gas rigid pipe shutoff nipple conn
Resumo do conteúdo contido na página número 7
Resumo do conteúdo contido na página número 8
Resumo do conteúdo contido na página número 9
5. Cooktop burners: 6. Oven burner: 9. Close the broiler door. Press the “OFF” pad. a. Check that all control knobs are in the a. Open oven door and remove oven OFF position and remove the knobs. racks, oven tray, flame spreader and set aside. Lift oven burner. The orifice spud is b. Remove the control panel. (See Step 10. Remove control knobs. Reinstall behind the oven burner air shutter. 17a, Page 7.) the control panel. Securely tighten the 4 b. Locate Natural gas orifice spud screws. Reinst
Resumo do conteúdo contido na página número 10
Moving the range: WARNING Tip Over Hazard Achild or adult can tip the range and be killed. Connect anti-tip bracket to rear range foot. Reconnect the anti-tip bracket, if the range is moved. Failure to follow these instructions can result in death or serious burns to children and adults. When moving range, slide range onto cardboard or hardboard to prevent damaging the floor covering. If removing the range is necessary for cleaning or maintenance: 1. Unplug range or disconnect power. 2. Shut off
Resumo do conteúdo contido na página número 11
For cleaning and If range does not If you need service: maintenance... operate: Maintain the quality built into your range by calling an authorized service company. Check that the circuit breaker is not If removing the range is necessary for ✓ tripped or the house fuse blown. cleaning or maintenance, disconnect the To obtain the name and number of the electric supply. authorized service company: Check that the power supply cord is ✓ If electrical supply is inaccessible, lift the plugged into the
Resumo do conteúdo contido na página número 12
Part No. 98014964 Printed in Mexico ©2004 Whirlpool Corporation Benton Harbor, Michigan 49022 2/2004
