Manual do usuário Dakota Digital PAC-3500

Resumo do conteúdo contido na página número 1

PAC-3500
AUTOMATIC DOOR LOCK CONTROLLER
Dakota Digital
PAC-3500
AUTOMATIC DOOR LOCK CONTROL
#1 Pin mode sel
#2 Unlock mode
#3 Lock mode
Indicator LEDs
#4-6 Speed select
Option switches
1 wire gear signal (optional)
fused constant +12V
+12V park signal (optional)
ground
fused +12V with key on
Unlock wire on
Only used for
dual relay pack
suicide safety pin
Lock wire on
applications.
Suicide safety pin
dual relay pack
switches
see relay wiring diagram
in instructions
Vehicle spee

Resumo do conteúdo contido na página número 2

Wiring to a door lock motor. Dakota Digital RLY-2 relay pack shown. The wires between the switch and the motor will need to be cut, and the relay pack wired in between as shown. PURPLE Fused 12V power. To PAC-3500 BLUE Lock output. small wire +12v on lock BLUE DUAL MOTOR RELAY RED FUSED 12V POWER GREEN PACK +12v on lock BROWN To PAC-3500 MOTOR GREEN WHITE small wire Unlock output. SWITCH Indicator LEDs The green LED will turn on when the auto-lock module is receiving a signal from

Resumo do conteúdo contido na página número 3

WARN Negative output used to drive bulb for warning output, only used in suicide pin mode. It is capable of switching 0.25A, equivalent to a 3 watt 12V bulb. Connect one wire from bulb to terminal and other wire to fused +12V. If a larger or high power indicator is used a relay should be used to turn on the light. In this case connect one side of the relay coil to the WARN terminal and the other side to fused +12v. The relay contacts will then be used to power the light. Any 12v automotive

Resumo do conteúdo contido na página número 4

TROUBLESHOOTING PROBLEM CAUSE SOLUTION Module does not respond, no green light Poor connection on IGN terminal. Check for broken or pinched IGN wire. visible. Poor ground connection Check for broken or pinched ground wire. Poor connection to PWR terminal Check for broken or pinched PWR wire. Module does not lock with speed signal Lock on speed option not selected Check switch settings (see chart first page) Speed setting two high Select slower speed setting from chart (settings above cur