Manual do usuário SECO-LARM USA Electromagnetic Lock E-941SA-1200

Resumo do conteúdo contido na página número 1

Installation Manual
®
ENFORCER
E-941SA-1200
E-941SA-600
E-941SA-300
Electromagnetic Locks
Also available:
E-941SA-1K2PD E-941DA-1K2P
Status LED
1200 lb. maglock Double-Door
Status LED
with status LED 1200 lb. maglock
status sensor & with status LEDs &
delay timer status sensors
HOW THEY WORK
When power is applied to the magnetic lock, it turns on the unit's powerful built-
in electromagnet. This electromagnet is attracted to the steel armature plate
which is mounted on a door, holding the door

Resumo do conteúdo contido na página número 2

ELECTROMAGNETIC LOCK Installation Manual MOUNTING THE E-941SA-300, E-941SA-600 & E-941SA-1200 A. Drill holes for the mounting plate and 4. Make sure the anti-spin guides are armature plate (see fig. 1 and 2) by in the two guidepin holes. doing the following: C. Screw the mounting plate to the door 1. Fold the mounting template along frame or optional bracket: the dotted line. 1. Screw the two short self-tapping 2. Close the door. Find a mounting screws in the slotted holes of the location on the

Resumo do conteúdo contido na página número 3

ELECTROMAGNETIC LOCK Installation Manual FIG. For Inswing Doors 1 Filler Plate* Standard * Note: may require more "L" Bracket "Z" Mounting than one filler plate. Bracket (Z/L brackets are not available for E-941SA-300.) Steel and Steel and Steel and FIG. Rubber washers Rubber Rubber washers Sexnut tube (as needed) washers (as needed) 2 (as Armature needed) 12345 12345678 Sexnut 12345 Armature 12345678 12345 Sexnut bolt Screw 12345 bolt Armature Screw Armature Screw Drill a 8mm Armature This sid

Resumo do conteúdo contido na página número 4

ELECTROMAGNETIC LOCK Installation Manual TROUBLESHOOTING Problem: Possible cause: Solutions: Door does not lock No power • Check to make sure the wires are securely tightened to the terminal block • Check that the power supply is connected and operating • Make sure the lock switch is wired correctly Door locks, but can be Poor contact between • Make sure the electromagnet and easily forced open electromagnet and armature plate are properly aligned armature plate • Make sure the contact surfaces

Resumo do conteúdo contido na página número 5

ELECTROMAGNETIC LOCK Installation Manual Page 5