Manual do usuário Wayne-Dalton 9000

Resumo do conteúdo contido na página número 1

Keyed-in-Handle Autolatch ECR Lock
Installation Instructions
and Owner’s Manual
Wayne-Dalton Corp.
P.O. Box 67 Mt. Hope, OH 44660
(888) 827-3667
www.wayne-dalton.com
All Residential Door Models: 8000/9000 Series & Wood Doors
PHILLIPS HEAD MACHINE SCREWS
(6) 1/4” -20
(2) FOAM TAPE
(2) 1” (9200) #306564
FLANGED HEX NUTS
(9200/9600/9900)
(2) 1-1/4” (9600/8300 & WOOD)#306565
#100279
3/4” X 2-1/2”
(2) 1-1/2” (9900) #306566
#306653
(2) 1-3/4” (8000/PR9000/8500) #306567
UNIVERSAL
LOCK STILE
OUTSIDE
(92

Resumo do conteúdo contido na página número 2

Step 1: Installing the ECR Lock CENTER STILE CAUTION DO NOT DRILL LOCK (3)PRE-PUNCHED SECTION OR INSTALL LOCK ON DOORS WITH HOLES OPENERS. THE DOOR AND/ OR OPENER MAY BE DAMAGED IF THE OPENER IS USED WHILE THE DOOR IS LOCKED. NOTE: Common practice for doors with the odd number of raised panels is to mount the lock towards (3) 3/4” DIA. the right side of the section when looking out. HOLES FACE UP FACE DOWN IMPORTANT: Remove all burrs from the drilled holes before installing the lock to the secti

Resumo do conteúdo contido na página número 3

Step 2: Outside Lock Handle Assembly 8000/PR9000 & PR9050 Series doors (see Fig. 4), 3/4” DIA. HOLES align the outside handle assembly with the handle pointing towards the floor and insert the assembly OUTSIDE through the previously drilled 3/4” diameter holes in HANDLE the section. Secure the outside lock handle to the section HANDLE with (2) #10 phillips head screws. SHANK 9000 Series & Wood doors (see Fig. 5), align the #10 PHILLIPS outside handle assembly with the handle pointing Fig. 4 HEAD

Resumo do conteúdo contido na página número 4

Step 4: Installing the Autolatch 1 8000/9000 Series & Wood doors (Fig.1-3), locate the inside handle and uncoil the lock cable, then thread the cable through the inside handle as illustrated (see Fig.1). 3 Locate the autolatch striker plates over the pre-punched 2 holes in the vertical track nearest the center of the lock section (see Fig.2). Fasten the striker plates to the vertical track using (2) 1/4-20 x 9/16” track bolts and flanged hex nuts. Align the autolatch flippers such that the arm w