Manual do usuário Frigidaire 154427301

Resumo do conteúdo contido na página número 1

IMPORTANT: Disconnect power before starting installation.
Parts You Will Need* (Not Included)
Figure 6 Figure 6 Figure 6 Figure 6 Figure 6
1
Roughing In
• Drain Hose Clamp, 1 / ” Diameter
Dishwasher 4
3
3
• Elbow, 90° with a /8” National Pipe Thread
Electrical
Air Gap Air Gap Air Gap Air Gap Air Gap
• Conduit Connector
Installation
1. The dishwasher operates on a 120 volt, 60 Hz electrical supply.
• Wire Nuts, two (2) for 12-14 gauge wire
Provide a separate circuit with a fuse or circuit break

Resumo do conteúdo contido na página número 2

4. Place door where it will not get scratched or damaged while Electrical Supply Floor Anchoring Sink at Left Sink at Left Sink at Left Sink at Left Sink at Left completing installation. Leveling Dishwasher This procedure is difficult and should be used only if countertop 5 1. Remove junction box cover and pull house wiring into junction Clamp Clamp Clamp Clamp Clamp 5. When ready to replace door, fit the slots on each side of top mounting brackets cannot be used. Connector Connector Connector C