Manual do usuário Electro-Voice SL6.2M

Resumo do conteúdo contido na página número 1

Model SL6.2M
Extended Range
High Output Speaker
Key Features:
• 46 Hz – 20 kHz Response
 250W Power Handling
 90 dB High Sensitivity
 Full-Bandwidth overload protection
TM
 Strong-Arm-Mount for easy, flexible
aiming
 Lightweight, unobtrusive plastic enclo-
sure
 Easy access input terminals
General Description: Technical Specifications:
The SL6.2M provides high efficiency, high power 1
Frequency Response(z -10 dB) 48 Hz - 20 kH
handling, and extended frequency response in a very
2
Power Han

Resumo do conteúdo contido na página número 2

EVID SL6.2M Step 2: Mount the Speaker to the Packing List Product Feature Identification Installation and Wiring SAM™ Bracket Listed and illustrated below are the parts in- Illustrated below are the major components Step 1: Mount the SAM™ Bracket Attach the speaker to the SAM™ bracket cluded in each boxed pair of EVID™ speakers. of the EVID™ Series full-range speakers. The SAM™ bracket can be mounted on with the socket head bolt, as shown in Figure Quantity Part either side of the speaker, enabl

Resumo do conteúdo contido na página número 3

Troubleshooting Table Problem Possible Cause(s) Action Attach both logo caps as shown in Figure 8 Step 4: Secure the Seismic Tab after tightening and securing the speaker. Connection Point 1. No sound Amplifier Connect a known working test speaker to the amplifier The rear of the enclosure includes an eye- outputs. If there is no sound, check that all the elec- tronics are on, the signal routing is correct, the source bolt for connection to a seismic restraint. EV logo cap EV logo cap is active,

Resumo do conteúdo contido na página número 4

Architecture & Engineering Specs: Frequency Response and Impedance: The loudspeaker shall be a two-way system consisting of one 6” (152mm) low-frequency transducer, a 1” (25mm) high-frequency transducer with a Coherent Coverage Waveguide, and a frequency- dividing network installed in a vented, line-array enclosure. The network shall include a passive limiter for both the low-frequency and high-frequency transducers. The loudspeaker system shall meet the following performance criteria: Power han