Manual do usuário Dakota Digital LED Tail Lights LAT-NR170

Resumo do conteúdo contido na página número 1

INSTALLATION INSTRUCTIONS
LAT-NR170
LED Tail Lights for 1967 Chevelle and 1974‐79 Camaro 

MAN#650178 rev. A

Kit Includes:

Installation:
1. Remove the original bulb connector from the back side of the housing.
2. Remove the tail light housing from the vehicle.
3. On the Chevelle, remove the chrome tail light cover. There are four nuts on the back side of
the housing.
4. Remove the tail light lens. On the Camaro there are five screws and one metal clip on the
back side of the hou

Resumo do conteúdo contido na página número 2

7. Insert the new LED assembly through the hole where the original bulb and connector were. Use caution when feeding the wires through to avoid damaging the wire insulation. 8. Feed the wires through the large hole in the back plate and attach the back plate onto the back side of the housing. The flat side of the mounting disk should be toward the outside and the side with the slight raised center should go in toward the housing. This will align the mount in the original housing. 9. S

Resumo do conteúdo contido na página número 3

12. Cut off the existing light socket as it will not be used. Do not strip the wires. Trim the wires from LED assembly to appropriate length once mounted, making sure wires are routed cleanly and securely. 13. Use the supplied moisture resistant pigtail connectors* to attach the wires from the new LED assembly to the existing vehicle harness. Insert appropriate wire from vehicle harness and mating LED assembly wire into a connector and crimp following instructions below. *For the bes