Manual do usuário Lightolier IS:6440

Resumo do conteúdo contido na página número 1

I
-
INSTRUCTION SHEET NO.
SUSPENSION BEAM
FOR USE WITH BASIC OR ADVENT LYTESPAN@ TRACK SYSTEMS ONLY
IS:6440
R0790 Page 1 of 4
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE PROCEEDING.
This fixture is intended for installation in accordance with the National Electrical Code and local regulations. TO assure full
compliance with local codes and regulations, check with your local electrical inspector before installation. To prevent electrical
shock, turn off electricity at fuse box before proceeding

Resumo do conteúdo contido na página número 2

1S:6440 INSTALLATION OF SUSPENSION BEAM WITH CABLE OR STEM KITS (Cent’d.) Paae 2 of , CABLE(OR STEM) MOUNTING HOUSINGS TO CABLES OR STEMS AR 1. Loosen screws in TRACK CLAMPS and insert clamps into HOUSING, engaging upper ribs between clamps. Slide HOUSING to position desired. .. WIREWAY 2. Cable length may be adjusted up to ‘A” by turning ADJUSTING COLLAR. 3. Pass supply leads (from cable or stem used for power feed) along top of HOUSING, through hole in WI REWAY COVER BRACKET and down through s

Resumo do conteúdo contido na página número 3

1S:6440 INSTALLATION OF BASIC OR ADVENT LYTESPAN TRACK INTO HOUSINGS Paae 3 of z ------ Each straiaht run of track is started with an lNDIVi DUAL TRACK UNIT and continued with JOINER TRACK UNITS. To cut track, see Instruction Sheets supplied with Track. 1S:6020 or 1S:6121. I ALLEN HEAD SCREW 7/8” Long for Basic Track, ASSEMBLE MOUNTING CLIPS TO TRACK 1[2’( Long for Advent Track 1. Prepare MOUNTING CLIP ASSEMBLIES as shown. —CAPTIVE NUT 2. Remove DEAD END COVER from INDIVIDUAL TRACK UNITS, see Fi

Resumo do conteúdo contido na página número 4

1S:6440 Page 4 of i INSTALLATION OF BASIC OR ADVENT LYTESPAN TRACK INTO HOUSINGS (Cent’d.) INSTALLING TRACK INTO HOU!jlNGs IN pATTERNs AUX.ELECTRICAL POLARITY KEY CONNECTOR / TRACK (Basic) 3. Insert AUX. ELECTRICAL CONNECTORS into track units 4~G”\ at corners and intersections, POIARITY KEY points . # .C r away from BEAD. DEAD .,\ NOTE One extra AUX. ELECTRICAL CONNECTOR will be “/” discarded when used with “T” HOUSING/SPLICEBOX. & ‘% ‘h~ C%R Y BEAD ~ ‘*&[ 4. Insert DEAD END COVERS into the end