Manual do usuário Sanus Systems NFV49

Resumo do conteúdo contido na página número 1

Assembly Instructions for Natural Furniture, Models: NF203, NF213, NFV49
Thank you for choosing the Natural Furniture line from Sanus Systems. If you have any questions regarding this or any
other Sanus Systems product, please contact us at 800.359.5520 or visit us at www.sanus.com. Our customer service
representatives can assist you quickly with any issues regarding assembly or missing parts. Check carefully to make sure
none of the parts are missing or defective. Never use defective parts.

Resumo do conteúdo contido na página número 2

Allen Bolt - I Qty. 12 Washer - J Qty. 4 Allen Key - M Glass Protector - L Decorative Face Bolt - K Qty. 1 Qty. 8 Qty. 12 Step 1: Attach the Cross Tubes to the Front Frame Position the Front Frame (A) as shown in Diagram 1; then, thread each Decorative Face Bolt (K) through the Front Frame, a Three Hole Plate (C) and into a Steel Cross Tube (B). Repeat this process until all twelve Steel Cross Tubes (B) are fastened to the Front Frame (A) as shown in Diagram 1. Firmly hand tighten each Steel

Resumo do conteúdo contido na página número 3

Step 2: Attach Rear Supports NOTE: The Rear Supports (E) must be positioned with set of three holes closest to the edge toward the top and the horizontal slots facing the Front Frame (A). Thread an Allen Bolt (I) through a Washer (J), the middle hole in a Rear Support (E), the middle hole in a Three Hole Plate (C), and into the middle Steel Cross Tube (B), as shown in Diagram 2. Repeat this procedure until all four middle Allen Bolts, accompanying Washers, and Rear Supports are attached to th

Resumo do conteúdo contido na página número 4

Step 4: Add Top Glass Shelf Place four Glass Protectors (L) evenly along the top of the Front Frame (A); then, add two Glass protectors to the top of each Rear Support (E). Place the Top Glass Shelf (G) onto the Glass Protectors as shown in Diagram 4. Diagram 4 G L L A E Step 5: Install Plastic Wire Covers To install the Plastic Wire Covers (F) insert one edge of the Plastic Wire Cover into one of the grooves in the Rear Support (E) as shown in the Top View of Diagram 5; then, inser