Manual do usuário 3Com V7300

Manual para o dispositivo 3Com V7300

Dispositivo: 3Com V7300
Categoria: Telefone IP
Fabricante: 3Com
Tamanho: 0.29 MB
Data de adição: 5/22/2013
Número de páginas: 30
Imprimir o manual

Baixar

Como usar?

Nosso objetivo é fornecer-lhe o mais rapidamente possível o acesso ao conteúdo contido no manual de instruções para 3Com V7300. Usando a pré-visualização online, você pode visualizar rapidamente o índice e ir para a página onde você vai encontrar a solução para seu problema com 3Com V7300.

Para sua conveniência

Se a consulta dos manuais 3Com V7300 diretamente no site não for conveniente para você, você tem duas soluções possíveis:

  • Visualização em tela cheia - Para visualizar facilmente o manual do usuário (sem baixá-lo para seu computador), você pode usar o modo de tela cheia. Para começar a visualização do manual 3Com V7300 no modo de tela cheia, use o botão Tela cheia.
  • Download para seu computador - você também pode baixar o manual 3Com V7300 em seu computador e mantê-lo em suas coleções. No entanto, se você não quer perder espaço no seu dispositivo, você sempre pode baixá-lo no futuro a partir de ManualsBase.
3Com V7300 Manual de instruções - Online PDF
Advertisement
« Page 1 of 30 »
Advertisement
Versão para impressão

Muitas pessoas preferem ler os documentos não na tela, mas na versão impressa. A opção de imprimir o manual também foi fornecida, você pode usá-la clicando na hiperligação acima - Imprimir o manual. Você não precisa imprimir o manual inteiro 3Com V7300, apenas as páginas selecionadas. Respeite o papel.

Resumos

Abaixo você encontrará previews do conteúdo contido nas páginas subseqüentes do manual para 3Com V7300. Se você deseja visualizar rapidamente o conteúdo das páginas subseqüentes, você pode usá-los.

Resumos do conteúdo
Resumo do conteúdo contido na página número 1


®
3Com V7300 Voice
Applications Suite
Unified Messaging Suite
Intelligent Mirroring Guide

VCX V7000 IP Telephony Solution
System Release 5.0
Part Number 900-0153-01 AA
Published August 2004
http://www.3com.com/

Resumo do conteúdo contido na página número 2

3Com Corporation Copyright © 2004, 3Com Corporation. All rights reserved. No part of this documentation may be reproduced in any form or by any means or used to make any derivative work (such as translation, 350 Campus Drive transformation, or adaptation) without written permission from 3Com Corporation. Marlborough, MA 3Com Corporation reserves the right to revise this documentation and to make changes in content from 01752-3064 time to time without obligation on the part of 3Com Corporat

Resumo do conteúdo contido na página número 3

3 CONTENTS ABOUT THIS GUIDE Assumptions 5 Conventions 5 Notices 5 Text 6 Related Documentation 6 Your Comments 7 INITIAL CONFIGURATION Overview 9 Hardware Prerequisites 9 IP Configuration 10 Single Network Configuration 10 Dual Network Configuration 11 Domain Name System (DNS) Configuration 13 Sample DNS Names and Files 14 Enabling Secure Copy (SCP) and Secure Shell (SSH) Commands 16 Network Time Protocol (NTP) Configuration 16 Configur

Resumo do conteúdo contido na página número 4

4 Balanced Intelligent Mirroring Policy 22 Switching Between Active and Standby States 22 OPERATION Verifying Intelligent Mirroring Operation 25 Manual Switchover 26 Verifying Server Synchronization 26 Database 26 File System 27 INDEX

Resumo do conteúdo contido na página número 5

ABOUT THIS GUIDE This chapter contains an overview of this guide, lists guide conventions, related documentation, and product compatibility. Assumptions This guide is intended for system administrators and assumes you have basic skills such as: ■ Basic UNIX command line usage ■ Knowledge of Solaris operating system utilities If the information in the release notes differs from the information in this guide, follow the instructions in the release notes. Conventions This section describes noti

Resumo do conteúdo contido na página número 6

6 ABOUT THIS GUIDE Text Table 2 lists text conventions that are used in this guide. Table 2 Text Convention Descriptions Convention Description Text represented as a screen display This typeface represents displays that appear on your terminal screen, for example: Netlogin: Text represented as user entry. This typeface represents information that you must type, for example: cd /usr/bin Text represented as menu or sub-menu This typeface represents all menu and names sub-menu names within p

Resumo do conteúdo contido na página número 7

Your Comments 7 Your Comments Your suggestions are important to us because we want to make our documentation more useful to you. Please send e-mail comments about this guide or any of the 3Com Voice Products documentation and Help systems to: VOICE_Techpubs_comments@3com.com Please include the following information with your comments: ■ Document title ■ Document part number (found on the front page) ■ Page number ■ Your name and organization (optional) Example: ® 3Com V7300 Voice Applications

Resumo do conteúdo contido na página número 8

8 ABOUT THIS GUIDE

Resumo do conteúdo contido na página número 9

INITIAL CONFIGURATION 1 This chapter provides an overview of how to configure Intelligent Mirroring on a Primary and Secondary server for the V7300 Voice Applications Suite. Intelligent Mirroring is the mirroring of application data on two independently running servers. The mirrored application data is composed of table data and message component files. Overview When you configure two servers for Intelligent Mirroring: ■ One of the servers operates in the active state ■ The other operates in

Resumo do conteúdo contido na página número 10

10 CHAPTER 1: INITIAL CONFIGURATION IP Configuration 3Com recommends that you define the IP configuration using the /etc/hosts files on the two systems. The /etc/hosts file on each server must contain identical information about the Intelligent Mirroring configuration. Other information in the file may vary. The examples in this document contain the information that must be identical. For each network to which Intelligent Mirroring is connected, you must configure four unique IP addresses,

Resumo do conteúdo contido na página número 11

IP Configuration 11 CAUTION: IP addresses 192.168.126.3 and 192.168.126.4 are the dynamic alias IP addresses. Do not associate them with any network interface. Sample /etc/hosts File Entries for a Single Network Configuration This section describes entries that you would add to the /etc/hosts file if your configuration was identical to the configuration examples listed earlier in this section. # # Internet host table # 192.168.126.1 voipbox1 voipbox1a voipbox1b voipbox1c voipbox1d 192.168.12

Resumo do conteúdo contido na página número 12

12 CHAPTER 1: INITIAL CONFIGURATION Figure 1 Dual Network Configuration Primary Server Secondary Server Network A Network B System 1 (Primary Server) ■ System Name — voipbox1 ■ IP Address (subnetwork 126) — 192.168.126.1 (associated with the primary network interface on the Primary Server) ■ IP Address (subnetwork 127) — 192.168.127.1 (associated with the secondary network interface on the Primary Server) System 2 (Secondary Server) ■ System Name — voipbox2 ■ IP Address (subnetwork 126) — 19

Resumo do conteúdo contido na página número 13

Domain Name System (DNS) Configuration 13 Sample /etc/hosts File Entries for a Dual Network Configuration This section describes entries that you would add to the /etc/hosts file if your configuration was identical to the configuration examples listed earlier in this section. # # Internet host table # 192.168.126.1 voipbox1 voipbox1a voipbox1c 192.168.126.2 voipbox2 voipbox2a voipbox2c 192.168.126.3 active activea activec 192.168.126.4 standby standbya standbyc 192.168.127.1 voipbox1b voipbox1

Resumo do conteúdo contido na página número 14

14 CHAPTER 1: INITIAL CONFIGURATION 3 Restart the named service on the DNS server to update the server settings with the new configuration information. For any PC on which you intend to run an e-mail client program, configure the PC so that it uses, as its primary DNS server , the DNS server that you have just configured. Sample DNS Names Modify these sample host and file names to conform to your network and Files configuration. ■ E-mail Server Host Name — umsemail ■ DNS Suffix — vcx.wan.3co

Resumo do conteúdo contido na página número 15

Domain Name System (DNS) Configuration 15 Sample file "vcx.wan.3com.com" $TTL 86400 @ IN SOA vcx.wan.3com.com. root.vcx.wan.3com.com. ( 200210210; serial, todays date + todays serial # 8H; refresh, seconds 2H; retry, seconds 1W; expire, seconds 1D ); minimum, seconds NS galaxy High light this MX record entry MX10 umsemail TXT "Voice Core eXchange, 3Com Corporation" localhost -A 127.0.0.1 umsemail A 192.168.126.1 A 192.168.126.2 voipbox

Resumo do conteúdo contido na página número 16

16 CHAPTER 1: INITIAL CONFIGURATION Enabling Secure UMS uses shell scripts to synchronize the two servers. These scripts use Copy (SCP) and the SCP and SSH commands. For these commands to work properly in Secure Shell (SSH) this environment, you must configure each UMS server so that the Commands commands do not prompt for a password. Perform these steps on the voipbox1 and voipbox2 servers as user app: 1 To create the private and public keys, enter this command: ssh-keygen -t dsa 2 When you

Resumo do conteúdo contido na página número 17

Network Time Protocol (NTP) Configuration 17 oscillator to stratum 8 in order to allow the two systems to use a lower stratum server (7 or lower) if one is available. By default, the system uses this drift file: /etc/ntp/drift. 3 On the voipbox2 system, create the /etc/ntp.conf file. 4 Edit the file and add these lines: server 127.127.1.1 peer voipbox1 5 On the voipbox1 server, su to root and execute these commands: /etc/init.d/ntpd stop /etc/init.d/ntpd start 6 On the voipbox2 server, su to r

Resumo do conteúdo contido na página número 18

18 CHAPTER 1: INITIAL CONFIGURATION

Resumo do conteúdo contido na página número 19

INSTALLATION 2 This chapter describes how to install Intelligent Mirroring on the Primary Server and the Secondary Server. Overview Follow these instructions, in the order that they are given, when you install and configure the servers. 1 Completely install the Primary Server before you begin to install the Secondary Server. See the instructions in Primary Server Installation, next. After you have installed the Primary Server, the system reboots itself. 2 Verify that the Primary Server is ope

Resumo do conteúdo contido na página número 20

20 CHAPTER 2: INSTALLATION Sample Installation When you first start a VCX V7000 server, a firstboot script is run. The Script (for voipbox1) script asks you questions and configures the software based on your answers. This section shows the portion of the firstboot script that deals with configuring Intelligent Mirroring between two VCX UMS servers. Bold text indicates values that you must type. Press Enter after each entry. The example answers in this script assume that you are using voipbo


Manuais similares
# Manual do usuário Categoria Baixar
1 3Com NBX 1105 Manual de instruções Telefone IP 8
2 3Com NBX 2102 Manual de instruções Telefone IP 15
3 3Com 3107 CORDLESS Manual de instruções Telefone IP 2
4 3Com VCX V7000 IP Manual de instruções Telefone IP 7
5 3Com NBX 2101 Manual de instruções Telefone IP 11
6 3Com V3000 ANALOG Manual de instruções Telefone IP 33
7 3Com V7000 Manual de instruções Telefone IP 2
8 3Com VCX V7111 Manual de instruções Telefone IP 35
9 3Com NBX 1102 Manual de instruções Telefone IP 1
10 3Com VCX V7000 Manual de instruções Telefone IP 45
11 3Com 3106 CORDLESS Manual de instruções Telefone IP 2
12 3Com 3101 W/SPEAKER Manual de instruções Telefone IP 24
13 Edelbrock 15018 Manual de instruções Telefone IP 0
14 Sony VERSION 1.0 Manual de instruções Telefone IP 1
15 321 Studios 6812D-MGCP Manual de instruções Telefone IP 1
16 3Com NBX 1105 Manual de instruções Telefone IP 8
17 3Com NBX 2102 Manual de instruções Telefone IP 15