Manual do usuário Roller Derby 1687284

Resumo do conteúdo contido na página número 1

40” Roller Bar Mower Kit
Installation
Part No. 1687284
For Baron & Rear Discharge Series Lawn Tractors
Instructions
12
13
11
12
4
11
10
4
9
8
7
19
20
21
7
9
5 14
17
7
15
6
8
16
9
1
17
3
9
18 12
2
11
9
4
Figure 1. Kit Contents:
Ref Part No. Qty. Description
WARNING
1 1922127 1 Capscrew, 5/16-18 x 1-3/4
Before beginning any service work turn off the
2 2157081 1 Spacer
PTO, set the parking brake, turn off the ignition,
3 1960520 1 Nut, push, 5/8, capped
and disconnect the spark plug wire(s).
4 286

Resumo do conteúdo contido na página número 2

Installation Instructions 40” Roller Bar Mower Kit C E G B F A D H G E D C A B F Figure 2. Anti-Scalp Gage Wheel Removal A. Gage Wheels E. Nuts, Security, Lock, 3/8-16 B. Capscrews, Hex, 3/8-16 x 3 F. Capscrews, Hex, 5/16-18 x 1 C. Spacers G. Nut, Flanges, ESNA, 5/16-18 D. Mounting Brackets H. Mower Deck 2. Remove 5/16-18 x 1 capscrews (F, Figure 2), and INSTALLATION 5/16-19 locknuts (G) securing gage wheels (A) and mounting brackets (D) to mower deck (H). Removal of Anti-Scalp Gage Wheels 1. P

Resumo do conteúdo contido na página número 3

40” Roller Bar Mower Kit Installation Instructions 2. Attach the roller bar assembly (A, Figure 5) to the left Install Roller Shaft Assembly side of the mower deck (B) using a 5/16-18 x 1-1/4 1. Attach the roller bar assembly (A, Figure 4) to the left capscrew (C), 5/16 flat washer (D), spacer (E), and side of the rocker shaft assembly (B) using a 5/16-18 flange locknut (F). Tighten nut to 11 ft. lbs. 3/8-16 x 2-1/2 capscrew (C), adjusting nut (D), (15 Nm) spacer (E), and 3/8-16 security locknu

Resumo do conteúdo contido na página número 4

Installation Instructions 40” Roller Bar Mower Kit Install Height Adjustment Trunnion Note: Attaching the trunnion to the inner hole provides lift operation with minimal effort, but with average below surface operation. Attaching the trunion to the outer hole provides maximum below surface roller travel, but with greater effort for operation. 1. Attach height adjust trunnion (A, Figure 7) to bar extension (B) and secure in place with the hair pin clip(C). Re-attach the 4-link chain (D) to han