Resumo do conteúdo contido na página número 1
Safety Instructions & Operator’s Manual for
EUROPEAN
19” STEEL DECK
WALK MOWERS
SERIES 17
MODEL
ER195517B
MODEL NUMBER EXPLANATION
E R 19 55 17 B
MODEL DESIGNATION BRIGGS & STRATTON
CUTTING WIDTH SERIES DESIGNATION
ENGINE HORSE POWER
E – European Model 17 - Series Designation
R – Recycling Model 55 – 5.5 HP (Engine Horse Power)
19 – 19” Cutting Width B – Briggs & Stratton Engine
Thank you for buying a SNAPPER Product! Before operating your Walk
Resumo do conteúdo contido na página número 2
IMPORTANT SAFETY INSTRUCTIONS WARNING: This powerful cutting machine is capable of amputating hands and feet and can throw objects that can cause injury and damage! Failure to comply with the following SAFETY instructions could result in serious injury or death to the operator or other persons. The owner of the machine must understand these instructions and must allow only persons who understand these instructions to operate machine. Each person operating the machine must be of sound mind
Resumo do conteúdo contido na página número 3
IMPORTANT SAFETY INSTRUCTIONS SAFE HANDLING OF GASOLINE OPERATION (Continued From Previous Page) (Continued From Previous Column) 3. DO NOT remove fuel cap or add fuel with the engine 11. STOP engine and wait until the blade comes to running. Allow the engine to cool before refueling. complete STOP before removing grass bag and/or 4. DO NOT refuel the machine indoors. clearing grass. 5. DO NOT store the machine or fuel container inside 12. DO NOT operate mower without the entire grass
Resumo do conteúdo contido na página número 4
TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS ................................................2-3 TABLE OF CONTENTS.............................................................................4 SECTION 1 - FAMILIARIZATION..............................................................5 SECTION 2 - OPERATING INSTRUCTIONS .........................................6-9 Pre-start Checklist ...................................................................................................
Resumo do conteúdo contido na página número 5
Section 1 - FAMILIARIZATION BLADE CONTROL RECOIL PRIMER BULB ROPE GUIDE KNOB ROPE START HANDLE KNOB OIL FILL CAP & DIPSTICK FUEL FILLER CAP AIR CLEANER MUFFLER CUTTING DECK RECYCLING COVER PRIMER CUTTING HEIGHT SEE INSET ADJUSTMENT BUSHINGS FIGURE 1.1 1.1 INTRODUCTION 1.2 NOMENCLATURE This manual has been prepared for the operators of The nomenclature information above, Figure 1.1, the SNAPPER WALK BEHIND MOWERS. Its shows the essential parts of the SNAPPER WALK
Resumo do conteúdo contido na página número 6
Section 2 - OPERATING INSTRUCTIONS 2.1 PRE-START CHECK LIST 2.1.5. Add fuel to tank after pushing the mower Make the following checks and perform the service outside where fumes can safely dissipate. Make required before each start-up. sure cap is tightened after refueling. Refer to Engine Owners Manual for fuel specifications. 2.1.1. Check guards, deflectors, grass bag, adapter and covers to make sure all are in place and securely tightened. 2.1.6. Clean exterior surfaces of cutting d
Resumo do conteúdo contido na página número 7
Section 2 - OPERATING INSTRUCTIONS 2.3 STOPPING 2.4 HANDLE HEIGHT ADJUSTMENT Stop engine and blade by releasing the blade The height of the mower handle can be adjusted as control. See Figure 2.4. follows: 1. Loosen the two nuts on the inside of each of the lower handles as shown in Figure 2.5. RELEASE BLADE 2. Move the handle up or down to the desired CONTROL TO STOP ENGINE & BLADE height. 3. Retighten all nuts securely after adjustment. LOOSEN NUTS TO ADJUST HANDLE
Resumo do conteúdo contido na página número 8
Section 2 - OPERATING INSTRUCTIONS 1. Set all wheels in the highest cutting position WARNING (Notch 4). DO NOT attempt any maintenance, adjustments or 2. Proceed mowing slowly. If grass is very dense, service with engine and blade running. STOP engine lower each rear wheel latch one notch lower than and blade. Disconnect spark plug wire and secure the front wheel latches to improve recycling away from spark plug. Engine and components are performance. HOT. Avoid serious burns, allo
Resumo do conteúdo contido na página número 9
Section 2 - OPERATING INSTRUCTIONS 3. Place discharge deflector over two bolts at top WARNING of discharge opening and secure to deck using the DO NOT attempt any maintenance, adjustments or two knobs removed in Step 1. Tighten knobs service with engine and blade running. STOP securely. engine and blade. Disconnect spark plug wire and 4. Using hardware removed in Step 2, insert bolt secure away from spark plug. Engine and with head on inside of deck into bottom rear hole of compone
Resumo do conteúdo contido na página número 10
Section 3 - MAINTENANCE 3.1 INTRODUCTION 4. Loosen with ratchet and short extension, but do To retain the quality of the mower, use genuine not remove oil drain plug. Loosen plug until you SNAPPER replacement parts only. Contact a local can turn it with your fingers. SNAPPER dealer for parts and service assistance. 5. Lower the mower down and place the piece of For the correct part or information for a particular wood under left rear wheel. Reach under mower mower, always mention model
Resumo do conteúdo contido na página número 11
Section 3 - MAINTENANCE 3.3 SERVICE - ANNUALLY Perform all maintenance as described in the “Service Schedule” section of this manual. 3.3.1. Engine Service engine according to engine owner’s manual. 3.3.2. Air Filter Refer to engine owner’s manual for service instructions. 3.3.3. Engine Oil Refer to engine owner’s manual for service instructions. 3.4 STORAGE PROCEDURE Refer to the Engine Owner’s Manual for directions regarding engine storage pre
Resumo do conteúdo contido na página número 12
Section 4 - ADJUSTMENTS & REPAIR WARNING BLADE DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. Wear heavy leather gloves when handling or working around cutting blades. Blades are extremely sharp and can cause severe injury. REMOVE BLADE 4.1 MOWER BLADE REPLAC
Resumo do conteúdo contido na página número 13
TROUBLESHOOTING PROBLEM PROBABLE CAUSE CORRECTIVE ACTION Engine Will Not Start 1. Fuel tank empty. 1. Fill fuel tank with fresh fuel. Using Recoil Starter 2. Engine needs choking or priming. 2. Choke/Prime. Check Engine Manual for instruction. 3. Spark plug wire disconnected. 3. Place spark plug wire onto spark plug. 4. Spark plug faulty. 4. Replace with new spark plug. Engine Stalls or Stops 1. Blade control is released or is not being held securely 1. Blade control should be h
Resumo do conteúdo contido na página número 14
SERVICE SCHEDULE ITEM SERVICE PERFORMED REF. EACH 5 25 50 100 EACH USE HRS HRS HRS HRS SEASON Check Oil Level Page 6 Engine Oil X Initial Oil Change Page 10 X Periodic Oil Change Page 11 X* Clean or Replace Engine Manual. Air Cleaner X** Spark Plug Replace Engine Manual. X Mower Blade Check For Wear, Damage Page 10 & 12 X & Replacement Mower Deck Clean Debris Page 11 X Accumulation * Change oil every 25 hours when operating under heavy load o
Resumo do conteúdo contido na página número 15
DECAL IDENTIFICATION KEEP CHILDREN AND OTHERS OUT OF MOWING SAFETY ALERT SYMBOL. OBSERVE AND FOLLOW ALL SAFETY INSTRUCTIONS. READ, UNDERSTAND AND FOLLOW INSTRUCTIONS AND WARNINGS IN OPERATOR’S MANUALS, AND ON THE MOWER, ENGINE AND ATTACHMENTS BEFORE OPERATING. (1) WARNING INSTRUCTIONS. WARNING (DECK) DECAL P/N 7-2921 (2) WARNING (DECK): Read and follow Starting and Safety Instructions in Owner’s Manual. Improper use of machine can result in seriou
Resumo do conteúdo contido na página número 16
DECAL IDENTIFICATION SPARK PLUG SYMBOL P/N 29779 (5) SPARK PLUG: Warns of potential electrical shock from plug while engine is running. EUROPEAN NOISE CONTROL DECAL 23356 (6) NOISE CONTROL: This unit is certified to be within the 96 Lwa sound power limit at the specified Engine RPM. EUROPEAN COMMUNITY DECAL 29776 (7) EUROPEAN PERFORMANCE: Maximum level of vibration measured at the operators hand is 23.4 m/sec2. (8) OPERATOR PRESENCE CONTROL (OPC): Arrow point
Resumo do conteúdo contido na página número 17
2 YEAR LIMITED WARRANTY For two (2) years from purchase date for the original purchaser's residential, non-commercial use, SNAPPER, through any authorized SNAPPER dealer will replace, free of charge (except for taxes where applicable), any part or parts found upon examination by the factory at McDonough, Georgia, to be defective in material or workmanship or both. For ninety (90) days from purchase date for the original purchaser's commercial, rental, or other non-residential use, SNA
Resumo do conteúdo contido na página número 18
PRIMARY MAINTENANCE 18
Resumo do conteúdo contido na página número 19
PRIMARY MAINTENANCE 19
Resumo do conteúdo contido na página número 20
PRIMARY MAINTENANCE 20
