Manual do usuário Dialogic PBX Integration Board D/82JCT-U

Resumo do conteúdo contido na página número 1

® Physical Description
Installing the Board
Dialogic
J1: 36-position mini-D plug

1. Working with your computer at a static-safe work
connector
D/82JCT-U area, switch off the power and disconnect all
P8
P8: CT Bus termination jumpers.
CT Bus connector
power cords from the electrical outlets.
Bus signals are terminated when
PBX Integration Board
2. Remove the chassis cover.
jumper clip is installed over
indicated pins
Board ID
3. Select an empty PCI expansion bus slot and
Displ

Resumo do conteúdo contido na página número 2

1 26 ® Note: Full H.100 capabilities are not available with To purchase Dialogic products, please refer to the Connecting the Station Interface Cable ® this release of the Dialogic D/82JCT-U. following website to locate the appropriate supplier: To punch-down block After Installing the Hardware http://www.dialogic.com/purchase.htm. 1. Attach the end connector on the ribbon cable to ® 28 GA 18-pair shielded cable After installing the hardware, run the Dialogic D/82U rear bracket th