Resumo do conteúdo contido na página número 1
FAST NETWORK 10
USER GUIDE
Segment Status
FN10-12 TX
Select Reset Ready
RX
Link
Act
Col
AUI 1 X2X 3X 4X 5X 8X 10X 12X 1 23 45 6 7 8 91011 12 A B Usr Pwr
6X 7X 9X 11X NMS Port
13X 14X 15X 16X 17X 18X 19X 20X 21X 22X 23X 24X 13 14 15 16 17 18 19 20 21 22 23 24
Link Segment Status
FN10-24 TX
RX Select Reset Ready
Link Act
Col
1 8 A Usr
AUI 1 X2X 3X 4X 5X 6X 7X 8X 9X 10X 11X 12X 23 45 6 7 91011 12 B Pwr
NMS Port
Resumo do conteúdo contido na página número 2
Resumo do conteúdo contido na página número 3
NOTICE Cabletron Systems reserves the right to make changes in specifications and other information contained in this document without prior notice. The reader should in all cases consult Cabletron Systems to determine whether any such changes have been made. The hardware, firmware, or software described in this manual is subject to change without notice. IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT
Resumo do conteúdo contido na página número 4
FCC NOTICE This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protecti
Resumo do conteúdo contido na página número 5
CABLETRON SYSTEMS, INC. PROGRAM LICENSE AGREEMENT IMPORTANT: Before utilizing this product, carefully read this License Agreement. This document is an agreement between you, the end user, and Cabletron Systems, Inc. (“Cabletron”) that sets forth your rights and obligations with respect to the Cabletron software program (the “Program”) contained in this package. The Program may be contained in firmware, chips or other media. BY UTILIZING THE ENCLOSED PRODUCT, YOU ARE AGREEING TO BECOM
Resumo do conteúdo contido na página número 6
UNITED STATES GOVERNMENT RESTRICTED RIGHTS The enclosed product (a) was developed solely at private expense; (b) contains “restricted computer software” submitted with restricted rights in accordance with Section 52227-19 (a) through (d) of the Commercial Computer Software - Restricted Rights Clause and its successors, and (c) in all respects is proprietary data belonging to Cabletron and/or its suppliers. For Department of Defense units, the product is licensed with “Restricted Rights” a
Resumo do conteúdo contido na página número 7
CONTENTS CHAPTER 1 INTRODUCTION 1.1 About This Manual....................................................................... 1-1 1.2 Getting Help................................................................................. 1-2 1.3 Document Conventions ............................................................... 1-3 1.4 Related Documentation............................................................... 1-4 1.5 Overview...............................................................
Resumo do conteúdo contido na página número 8
Contents CHAPTER 3 CONFIGURING YOUR FN10 3.1 Assigning IP Addresses ...............................................................3-3 3.1.1 Displaying IP Addresses .................................................3-4 3.1.2 Deleting an IP Address....................................................3-4 3.1.3 Changing a Subnet Mask................................................3-4 3.2 Enabling Bridging.........................................................................3-5 3.3 Disabling
Resumo do conteúdo contido na página número 9
Contents 4.5 Using LCM to Manage the FN10............................................... 4-15 4.5.1 Disabling a Port ............................................................ 4-15 4.5.2 Enabling a Port ............................................................. 4-16 4.5.2.1 noRIP Option................................................ 4-16 4.5.3 Changing a Subnet Mask ............................................. 4-17 4.5.4 Changing a Community Name....................................
Resumo do conteúdo contido na página número 10
Contents APPENDIX A TECHNICAL SPECIFICATIONS A.1 FN10 Specifications .................................................................... A-1 A.2 Serial Cable Pin Assignments..................................................... A-3 A.3 10BASE-T Pin Assignments ....................................................... A-3 A.4 Straight-through Wiring ............................................................... A-4 A.5 Crossover Wiring .........................................................
Resumo do conteúdo contido na página número 11
CHAPTER 1 INTRODUCTION 1.1 ABOUT THIS MANUAL This manual is for system administrators responsible for configuring, monitoring, and maintaining the Fast Network 10 (FN10). You should have a familiarity with networking concepts and principles. In addition, a basic understanding of SNMP is helpful. Some FN10 configurations can only be done using an SNMP-based Network Management System (NMS). Therefore, how you configure and manage the FN10 is dependent on the NMS you use. Where appli
Resumo do conteúdo contido na página número 12
Chapter 1: Introduction • Chapter 5, FN10 Filters, describes FN10 filtering and provides specific examples of how filters can be used. It also provides instructions for adding, modifying, and deleting Port filters using the Local Console Manager (LCM). • Chapter 6, FN10 Diagnostics and Troubleshooting, describes the FN10 diagnostics and provides information on troubleshooting common problems. • Appendix A, Technical Specifications, provides the FN10 specifications an
Resumo do conteúdo contido na página número 13
Document Conventions 1.3 DOCUMENT CONVENTIONS The following conventions are used throughout this document: LCM commands, prompts, and information displayed by the computer appear in Courier typeface, for example: Current Number of Learned Addresses: 133 Number of Defined Filters: 4 Information that you enter appears in Courier bold typeface, for example: FN10 >status Information that you need to enter with a command is enclosed in angle brackets < >. For example, you
Resumo do conteúdo contido na página número 14
Chapter 1: Introduction 1.4 RELATED DOCUMENTATION The following documentation may assist the user in using this product: • Fast Network 10 MIB Reference Guide – contains enterprise MIB information. • Interconnections, Bridges and Routers, Radia Perlman, Addison Wesley © 1992. • Internetworking with TCP/IP: Principles, Protocols, and Architecture (2nd edition), Volumes I and II, Douglas Comer, Prentice Hall © 1991. • The Simple Book, An Introduction to Management of T
Resumo do conteúdo contido na página número 15
Overview . Front Panel with 12 10BASE-T (10 Mbps) Ports Segment Status FN10-12 TX Select Reset Ready RX Link Act Col 1 A Usr AUI 1 X2X 3X 4X 5X 6X 7X 8X 9X 10X 11X 12X 23 45 6 7 8 91011 12 B Pwr NMS Port Front Panel with 24 10BASE-T (10 Mbps) Ports 13X 14X 15X 16X 17X 18X 19X 20X 21X 22X 23X 24X 13 14 15 16 17 18 19 20 21 22 23 24 Link Segment Status TX FN10-24 Select Reset Ready RX Link Act Col AUI 1 X2X 3X 4X 5X 6X 7X 8X 9X 10X 11X 12X 1 23 45 6 7 8 91011 12 A B Usr Pwr NMS Port Figure 1-
Resumo do conteúdo contido na página número 16
Chapter 1: Introduction • Implements the Spanning Tree protocol (802.1d). • Configured with factory-set defaults for immediate plug-and-play capability. In addition, the FN10 offers features that can help you manage and maintain your network, such as: • Configuration and management using the Simple Network Management Protocol (SNMP) with either an in-band or out-of-band connection. • Protection against multicast storms. • Data flow control based on user-defined data packet filters. • Ab
Resumo do conteúdo contido na página número 17
Overview Media Access Control (MAC) sub-layer of the Data Link layer. Figure 1-3 shows the OSI Reference Model. 7 Application Presentation 6 5 Session 4 Transport 3 Network FN10 operates at Layer 2 2 Data Link 1 Physical Figure 1-3 OSI Reference Model Because the FN10 does not process any Network Layer information, it provides a high level of performance in terms of packet throughput. In addition, the FN10 does not need to learn network topology, requiring less programming and config
Resumo do conteúdo contido na página número 18
Chapter 1: Introduction forwards the packet to the network segment associated with that destination address. However, if the packet’s source and destination address are on the same network segment, known as local traffic, the packet is automatically discarded (i.e., ignored by the FN10). For example, a file transmitted from Workstation A to Workstation C in Figure 1-4 does not need to leave LAN 1. The FN10 connected to LANs 1 and 2 sees all traffic from LAN 1, including LAN 1 local
Resumo do conteúdo contido na página número 19
Overview automatically reconfigured by the Spanning Tree protocol to create an alternate path to the LAN. 1.5.2 FN10 Bridge Address Table The FN10 creates and maintains a dynamic database of addresses called the Bridge Address Table. The FN10 examines every packet to determine its source address and LAN segment origin. It then compares the source address and segment information it finds to the entries in the Bridge Address Table. If a packet’s address is not already stored in the Bridge
Resumo do conteúdo contido na página número 20
Chapter 1: Introduction • A single port number of the LAN on which the address resides • The age of the entry • Various statistics counters • Any filtering restrictions added by a Network Management Station (NMS) Each static entry contains the same information as a dynamic entry, except the static entry is not aged, and can contain a range of port numbers, rather than a single port number. The FN10 stores 8,192 dynamic (learned) entries in its Bridge Address Table. In addition, it sto
