Resumo do conteúdo contido na página número 1
T M
Canopy Subscriber Module
USER MANUA L
SM02-UG-en
Issue 2
May 2003
© 2003 Motorola, Inc. All rights reserved. Printed in the U.S.A
Resumo do conteúdo contido na página número 2
NOTICES Important Note on Modifications Intentional or unintentional changes or modifications to the equipment must not be made unless under the express consent of the party responsible for compliance. Any such modifications could void the user’s authority to operate the equipment and will void the manufacturer’s warranty. U.S. Federal Communication Commision (FCC) and Industry Canada (IC) Notification This device complies with part 15 of the U. S. FCC Rules and Regulations and with RSS-210 of
Resumo do conteúdo contido na página número 3
Product Details for Products Tested for Compliance with Relevant EC Directives (At this time, only the 5.7 GHz product has been tested for compliance with relevant EC directives.) Operating Maximum Effective Modulation Channel Frequency Range Transmitter Isotropic Type Spacing Power Radiated Power (EIRP) Access Point 5.725 to 5.825 GHz 200mW RMS 1 Watt EIRP High Index 25 MHz BFSK 20 MHz Subscriber 5.725 to 5.825 GHz 200mW RMS 1 Watt EIRP High Index 25 MHz Module BFSK 20 MHz Subscriber 5.725 to 5
Resumo do conteúdo contido na página número 4
CDROM, OR IF YOU USE THE SOFTWARE OR RELATED PRODUCT, YOU ACCEPT THE TERMS OF THIS LICENSE AGREEMENT. IF YOU DO NOT AGREE TO THESE TERMS, DO NOT USE THE SOFTWARE OR RELATED PRODUCT; INSTEAD, RETURN THE SOFTWARE TO PLACE OF PURCHASE FOR A FULL REFUND. THE FOLLOWING AGREEMENT IS A LEGAL AGREEMENT BETWEEN YOU (EITHER AN INDIVIDUAL OR ENTITY), AND MOTOROLA, INC. (FOR ITSELF AND ITS LICENSORS). THE RIGHT TO USE THIS PRODUCT IS LICENSED ONLY ON THE CONDITION THAT YOU AGREE TO THE FOLLOWING TERMS. Now
Resumo do conteúdo contido na página número 5
MOTOROLA OR AN AGENT THEREOF SHALL CREATE A WARRANTY OR IN ANY WAY INCREASE THE SCOPE OF THIS WARRANTY. MOTOROLA DOES NOT WARRANT ANY SOFTWARE THAT HAS BEEN OPERATED IN EXCESS OF SPECIFICATIONS, DAMAGED, MISUSED, NEGLECTED, OR IMPROPERLY INSTALLED. BECAUSE SOME JURISDICTIONS DO NOT ALLOW THE EXCLUSION OR LIMITATION OF IMPLIED WARRANTIES, THE ABOVE LIMITATIONS MAY NOT APPLY TO YOU. Limitation of Remedies and Damages. Regardless of whether any remedy set forth herein fails of its essential purpo
Resumo do conteúdo contido na página número 6
U.S. Government Users. If you are a U.S. Government user, then the Software is provided with "RESTRICTED RIGHTS" as set forth in subparagraphs (c)(1) and (2) of the Commercial Computer Software-Restricted Rights clause at FAR 52 227-19 or subparagraph (c)(1)(ii) of the Rights in Technical Data and Computer Software clause at DFARS 252.227-7013, as applicable. Disputes. You and Motorola hereby agree that any dispute, controversy or claim, except for any dispute, controversy or claim involving in
Resumo do conteúdo contido na página número 7
TABLE OF CONTENTS GETTING STARTED ............................................................................................. 8 Welcome........................................................................................................................ 8 Features......................................................................................................................... 8 Intended Use................................................................................................
Resumo do conteúdo contido na página número 8
GETTING STARTED WELCOME Congratulations on the purchase of the Canopy subscriber module from Motorola! The Canopy subscriber module is the latest innovation in high-speed wireless networking that lets you easily network at high speeds. FEATURES The following is a subset of features included with your Canopy subscriber module: ♦ Broadband network speeds. ♦ Small, compact design. ♦ No special setup on your PC. INTENDED USE This manual is intended to be used with Canopy software release version 3.
Resumo do conteúdo contido na página número 9
Remove the base cover as shown in FIGURE 1 to access the Ethernet connection and to view the LED indicators. • The RJ-45 connector is used to attach the Ethernet cable. • The LED’s indicate system status and can be used for alignment. Canopy SM RJ45 Connection Connector LEDs Base Cover Ethernet Cable FIGURE 2 SM User Manual Issue 2 Page 9 of 34
Resumo do conteúdo contido na página número 10
The Connection LEDs report information about the current status of the subscriber module. The following descriptions explain the function of each LED. Operational Mode When looking at the LEDs on the module the following descriptions go from left to right. LNK: The link LED displays the status of the Ethernet link to the Canopy module. The LED will be constantly lit if there is an Ethernet link present. The LED is colored green. ACT/4: The activity LED displays the status of any data activ
Resumo do conteúdo contido na página número 11
BACKGROUND INFORMATION ON NETWORKING Computers are assigned IP addresses by network operators, which have two methods available, static or dynamic IP addressing. The user of this document will need to understand how IP addressing is done at their particular location. All Canopy radio products (Subscriber Modules, Access Point Modules, and Backhaul Modules) have the default IP address of 169.254.1.1. For a computer to talk to Canopy, as it comes from the factory, either of the following conditi
Resumo do conteúdo contido na página número 12
INSTALLATION The following steps are required to install the Canopy subscriber module. • Unpack the Canopy products • Configure the subscriber module for the Canopy network • Install the module • Align the module UNPACK THE CANOPY PRODUCTS Upon receipt, carefully inspect all shipping boxes for signs of damage. If there is damage, immediately notify the transportation company. Unpack equipment, making sure that all ordered components have arrived. It is recommended that you save all the packagi
Resumo do conteúdo contido na página número 13
discern that a password is set. • The operator can enter in information about the Site Name, Location, and Contact. This is optional. If the subscriber module is in the 5.7 GHz band and the operator will be utilizing the Canopy passive reflector to obtain a link at distances of 10 miles or less, the subscriber module should be mounted to the reflector in the following manner. The reflector arm is molded to receive the plastic housing of the subscriber module. Utilize stainless steel hose cla
Resumo do conteúdo contido na página número 14
Stainles s Steel Hos e Clamps o r any Suitab le l Equivalen nt Typica l Antenna Mast FIGURE 3 • Leave the unit mounting means loose enough to allow for movement when performing the alignment procedure. They must be tightened after the alignment procedure is completed. As with any such installed devices, the Canopy subscriber module and the Ethernet cable must be grounded in accordance with the latest revision of the National Electrical Code (NEC) and/or all country and local electrical cod
Resumo do conteúdo contido na página número 15
Wiring Diagram of Canopy subscriber module to Computer with Surge Suppressor outside wall Ethernet cable Ethernet cable SM 300SS to NIC 24 VDC to Canopy Computer wall adapter 10 AWG CU wire grounding system ALIGN THE SUBSCRIBER MODULE There are two methods that can be utilized for aligning a subscriber module to an access point module. The first is to monitor the RSSI and Jitter values on the subscriber. The second is to utilize the built-in alignment tool on the subscriber module. In either
Resumo do conteúdo contido na página número 16
• Point subscriber module in direction of the access point. Remember that when utilizing the internal patch antenna the energy is radiated out in a 60° horizontal by 60° vertical pattern. IF UTILIZING A 5.7 GHz SUBSCRIBER MODULE: the passive reflector will change the radiated pattern to 6° horizontal by 6° vertical. • Set the web page to auto-refresh (see Configuration section for further information) • Go to Alignment web page. Ensure that “RSSI Only Mode” is disabled. • Click “Enable Aim
Resumo do conteúdo contido na página número 17
CABLING The following information describes the wiring standards for installing a Canopy system. All diagrams use the EIA/TIA 568B color standard. Currently shipping modules auto-sense the Ethernet cable type – either RJ-45 straight-thru cable or RJ-45 crossover cable can be used to connect a network interface card (NIC), hub, router, or switch to a module. Earlier modules did not auto-sense. In cases where older modules are used: • When connecting a Canopy device directly to a network interfac
Resumo do conteúdo contido na página número 18
ADVANCED FEATURES These features may be utilized in the Canopy System but are not required for basic operation. DES ENCRYPTION DES (Data Encryption Standard) is a secret key encryption scheme. The basics of DES are that it performs a series of bit permutations, substitutions, and recombination operations on blocks of data utilizing a secret key. On the Canopy system, DES encryption of the over the air link is done on a per access point module or backhaul timing master module basis and does not
Resumo do conteúdo contido na página número 19
Flash Web files /canopy.jpg 7867 free directory entries: 31 free file space: 56468 Telnet +> clearwebfile Telnet+> lsweb Flash Web files free directory entries: 32 free file space 64336 bytes
Resumo do conteúdo contido na página número 20
THE INTERFACE SCREENS The Canopy subscriber module contains a series of web pages that are used to interface to the unit. The following is a quick reference to interface screens. Note: These screens are subject to change by subsequent software versions. To access the web based interface you first must be on a computer that is in some way connected to the subscriber module. This can be done either directly or through a network. Enter the IP address of the subscriber module (default is 169.2
