Resumo do conteúdo contido na página número 1
Resumo do conteúdo contido na página número 2
Contents Driver Safety/Map/Itinerary Screens ........................... 41 Quick Start .......................................................................... i-xii Navigating Through CoPilot Screens ........................... 43 CoPilot Overview ............................................................. 1 Customizing the Guidance Screens ............................ 43 Safety Warning ................................................................... 2 Map Modes ......................
Resumo do conteúdo contido na página número 3
2. Uninstall any previous version If you have a previous version of CoPilot installed on your Pocket PC and/or desktop computer, you must uninstall it before updating. Make sure your GPS receiver is NOT attached, then follow these steps: (1) On your Pocket PC: 1. Tap the Start menu and select Settings > System > Remove Programs 2. Select the CoPilot application and tap Remove. 3. Select Pocket Speech and tap Remove. 4a. If you stored map data on a storage card: i. Delete the CoPilot folder on t
Resumo do conteúdo contido na página número 4
(6) When CoPilot has been installed to your Pocket PC (this will take a few Quick Start Installation minutes), you will be prompted to begin the desktop/laptop installation. If your product shipped with a Quick Start storage card, just follow these Click Next and follow the on-screen instructions. simple steps to get started with CoPilot. Otherwise skip to the Install From CD section below. (7) When the installation is complete, a CoPilot icon will appear on your desktop or laptop. (1) Ens
Resumo do conteúdo contido na página número 5
4. Give your data region a name and click Next. 3. Tap Next when ready and enter your e-mail address when prompted. CoPilot will be activated within a few seconds. Tap Next to 5. You will then be given the option to either select additional map data begin using CoPilot. or download selected areas to your Pocket PC. Click Download. 4. Select your desired map region (Step 6) and then see Step 7 NOTE: Instead of City Radius you could select Map Area to download map (hardware setup) to configure y
Resumo do conteúdo contido na página número 6
If you choose to activate a region other than the region pre-installed on your 9. Enter an address QuickStart storage card, you will be required to download the selected region NOTE: There is no need to enter a starting point. CoPilot uses GPS to your storage card using the Data Download Wizard from within the CoPilot positioning to determine your location automatically. desktop application. Additionally, you will not be able to use the data region that was pre-installed on your card. 1. In th
Resumo do conteúdo contido na página número 7
7. If an exact database match Pocket PC Guidance Screens Quick Reference was not found, you’ll see the available address options. Select a Nearby Address,a Cross Street, or one of Next Turn several Streets in Nearby Instruction Next Turn Cities. Tap your choice, then Directional tap Next. Arrow 8. (Optional) Enter a name for Distance to Step 7 Step 8 Next Turn the place you entered, then tap Finish. Next Crossroad Message Queue (customizable) 9. You will be taken back to the Going To scr
Resumo do conteúdo contido na página número 8
Hints and Trouble-shooting Product Licencing and Updates The CoPilot desktop software contains street-level maps for all of Europe, and To ensure proper GPS reception, make sure that your Pocket PC is vertically CoPilot is offered with different licences that allow you to use some or all of these mounted to your vent clip or windshield (not required if you are using the maps on your Pocket PC. Licences are available for the following: optional external GPS antenna). Also make sure to properly se
Resumo do conteúdo contido na página número 9
CoPilot Overview A Safety Warning Always keep your hands on the steering wheel and eyes on the road Your CoPilot | Pocket PC 5 Includes: when driving! Install/Data Discs Do not use this product in any way that interferes with safe and attentive operation Quick Start Guide of a vehicle. When used in a vehicle, do not place the GPS receiver, antenna, power GPS Receiver Guide supply, or your computer where it may strike the driver or passengers if the vehicle GPS Receiver (not in software-only pac
Resumo do conteúdo contido na página número 10
Getting Started - Get Connected Getting Started - Hardware In order to successfully transfer data from your desktop to your Pocket PC, Both your desktop/laptop and your Pocket PC must be turned on. The you must have Microsoft ActiveSync 3.1 (or later) installed. This software is cradle/cable for your mobile device must be connected to your desktop/laptop necessary to connect the two machines and is provided by your Pocket PC computer through either the USB or Serial port. manufacturer. If you
Resumo do conteúdo contido na página número 11
Uninstalling a Previous Version Installing CoPilot If you have been using an earlier version of Pocket CoPilot, you must uninstall the NOTE: You must uninstall any previous version of CoPilot from your application and its data before installing CoPilot. If you’re uninstalling CoPilot desktop/laptop and Pocket PC before proceeding (see above). from a Pocket device and installing the same version on another device, you must To install CoPilot, first turn on your computer and set up your Pocket PC.
Resumo do conteúdo contido na página número 12
4. The Installation Wizard will then 8. As the desktop installation start installing to your Pocket PC, proceeds, you will be given the beginning with the text-to-speech choice to install the CoPilot map software that delivers CoPilot’s data to your hard drive. This is spoken driving instructions. the recommended option and requires 700 MB of available space. If you choose None, you will need Text-to-speech provides more to insert the CoPilot Data Disc each detailed voice instructions, time you
Resumo do conteúdo contido na página número 13
Adding a Data Region Region Selection If you have purchased an additional data region after your initial purchase of If you purchased an additional data region, when downloading map data to your CoPilot, you will need to modify the original (“Base”) installation and activate the Pocket PC you will need to make sure the proper region is active. To do this, on new region. your desktop in Planning mode, click the Map menu > Region > and check the desired region. IMPORTANT: You can only use your Exp
Resumo do conteúdo contido na página número 14
Software Activation D De ea ac ct tiiv va at tiio on n a an nd d L Liic ce en nc ce e U Up pd da at te e NOTE: CoPilot won’t open on your Pocket PC unless map data has The CoPilot desktop software contains street-level previously been downloaded from CoPilot on the desktop. maps for all of Europe, and CoPilot is offered with different licences that allow you to use some or all To launch CoPilot, first turn on your Pocket PC, attach the GPS receiver, and of these maps on your Pocket PC. Licences
Resumo do conteúdo contido na página número 15
Data Download to Your Pocket PC 3. To download to a Storage Card through a Card Reader: To use CoPilot on your Pocket PC, you first need to download map data from (In this example, again all options your desktop or laptop computer to your Pocket device. You select the data to are available.) Pick the drive letter download from one or more regions (“data areas”) that you specify in the CoPilot application on your desktop. It’s a simple 4-step process. associated with your Storage Card Reader, t
Resumo do conteúdo contido na página número 16
Map Area - This method of selecting data allows you to choose an area of data Data Download by drawing a box on the Data Download Wizard's map screen. Step 2: Choose a Data Selection Method In the Wizard, you enter a city name near which you would like to select data, then click Next. The map will zoom to that location. Then you create a box around the desired area by clicking and dragging your mouse across the map. The street- level data within that box will be selected. You can zoom the map
Resumo do conteúdo contido na página número 17
Data Download Step 3: Select Your Data Use any of the methods covered on the following pages (City Radius, Map 4. Name the selection, then Area, or Trip) to select one or more regions and then download your data. click Next. Or, select a whole region to download using the Region option. City Radius 1. Click the City Radius icon. 5. You will return to the Data Selection menu where you can select another data area if you like, using any method. When you finish selecting data areas, 2. Enter a Ci
Resumo do conteúdo contido na página número 18
Map Area 1. Click the Map Area icon. 4. Name the selection, then click Next. 2. Enter a City, Country or 5. You will return to the Data Postal code (address optional) Selection menu where you can within the area that you would select another data area if you like to download. Click Next. like, using any method. When you are finished selecting data areas, click the Download icon to go to the final screen where you can build your download. 3. Click and hold the left mouse button and drag the cu
Resumo do conteúdo contido na página número 19
Trip 3a. Highlight a selection, click 1. Click the Trip icon. Select, then Add Stop. When all your stops have been entered, click Select Data. 4. By default a 20 mile radius 2. You now have several options around all stops and a width of for entering stops on your trip. 4 kilometers along the corridor If you choose the Cities and which connects them will be Addresses tab you will need to highlighted. Note: CoPilot’s enter a City, Country or available memory calculations Postal code, press
Resumo do conteúdo contido na página número 20
Data Download POI Download Options When you download a data region, you’ll get all roads within that region (but not Step 4: Download the Data roads outside the region). Also included with each download are regional points of interest (POI) such as gas stations, hotels, restaurants, visitor attractions, etc. When you’re ready to execute a download, the Wizard will display a list of Available Area(s) for download on the left side of the window. To designate an CoPilot now lets you control the num
