Resumo do conteúdo contido na página número 18
EO1-33038 2. SPECIFICATIONS 2.6 BATTERY 2.6 BATTERY Item Description Type Lithium-ion battery Voltage DC 7.4V Capacity 1400mAh 2- 4
Resumo do conteúdo contido na página número 19
EO1-33038 2. SPECIFICATIONS 2.7 MEDIA 2.7 MEDIA Label E I A H B Feed direction F G D C Tag/Receipt Black Mark (on reverse side) H B A E G D 2- 5
Resumo do conteúdo contido na página número 20
EO1-33038 2. SPECIFICATIONS 2.7 MEDIA (Unit:mm) Tag/Receipt Receipt Media Label No black mark Item Batch mode Strip mode With black mark A Variable Label/Receipt pitch 10.0 − 167.0 13.0 − 67.0 10.0 − 507.0 Variable 7.0 − 160.0 10.0 − 60.0 7.0 − 500.0 B Label/Receipt length C Backing paper 28, 31, 34, 37, 40, 43, 46, (NOTE 2) 49, 52, 55, 58±0.5 width 28, 31, 34, 37, 40, 43, 46, 49, (NOTE 3) D Media width 25.0 − 55.0 (NOTE 2) 52, 55, 58±0.5 E Gap/black mark 3.0 − 7.0 3.0 - 7.0 length F Distance be
Resumo do conteúdo contido na página número 1
TEC Portable Printer
B-SP2D SERIES
Owner’s Manual
Resumo do conteúdo contido na página número 2
CE Compliance (for EU only) This product complies with the requirements of EMC, Low Voltage and R&TTE Directives including their amendments. FCC Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
Resumo do conteúdo contido na página número 3
EO1-33038 Safety Precautions Precautions for Handling of Wireless Communication Devices ® Bluetooth Module: TEC-BTM (GH30 model) Wireless LAN Module: TEC-WLM (GH40 model) Trade Mark Bluetooth is a trademark owned by Bluetooth SIG, Inc. and used by TOSHIBA TEC CORPORATION under license from Japan Total Design Communication Co., Ltd. Cautions General For all countries and areas This product is a wireless communication device, and the use of this product is restricted to the following countries or
Resumo do conteúdo contido na página número 4
EO1-33038 Safety Precautions For USA This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modification not expressly approved by manufacturer for compliance could void the user’s authority to operate the equipment. For Canada Operation is subject to the following tw
Resumo do conteúdo contido na página número 5
EO1-33038 Safety Precautions Do not disassemble, modify, or repair the product. Doing so may cause injury. Also, modification is against the Laws and Regulations for Radio Equipment. Please ask your TOSHIBA TEC sales agent for repair. Precaution in use This product communicates with other devices by radio. Depending on the installation location, orientation, environment, etc., its communication performance may deteriorate or devices installed near by may be affected. Keep away from a microwave.
Resumo do conteúdo contido na página número 6
EO1-33038 Safety Precautions Changes or modifications not expressly approved by manufacturer for compliance could void the user's authority to operate the equipment. CAUTION! 1. To avoid injury, be careful not to catch or jam your fingers while opening or closing the cover. 2. Do not touch moving parts. To reduce the risk that fingers, jewellery, clothing, etc., be drawn into the moving parts, turn off the power switch to stop movement. Safety Summary Personal safety in handling or maintaining
Resumo do conteúdo contido na página número 7
EO1-33038 Safety Precautions This indicates that there is the risk of death or WARNING serious injury if the machines are handled improperly or contrary to this indication. • If water or any other liquid enters the machine, turn off the power. Continuous use of the machine under such conditions may cause fire or electric shock. • If the enclosure is damaged when dropped or subject to shock, turn off the power. Continuous use of the machine under such conditions may cause fire or electric shock.
Resumo do conteúdo contido na página número 8
EO1-33038 Safety Precautions • Be aware of the following precautions when using batteries. Otherwise they could heat up, burst or burn. ■ Do not throw the battery into fire or heat it with a microwave or oven, etc. ■ Do not load the battery with the electrodes reversed. ■ Do not connect the electrodes with metal objects like wire. Do not carry or store the battery along with metal objects such as necklaces, hairpins, etc. ■ Do not stick a needle into, hammer, step on, or drop the battery. ■ Do
Resumo do conteúdo contido na página número 9
EO1-33038 Safety Precautions • Do not charge the battery near flame or under direct sunlight. High temperature may activate or damage the protection unit of the battery, disabling the electric charge or causing it to overheat, burst, or burn. • Unload the battery when the machine will not be used for a long time. Failure to do this may cause machine failure. • Keep the battery away from flame, a heat source or other locations subject to high temperature. Failure to do this may cause it to ove
Resumo do conteúdo contido na página número 10
EO1-33038 Safety Precautions (4) DO NOT STORE the media where it might be exposed to direct sunlight, high temperatures, high humidity, dust, or gas. (5) Any data stored in the memory of the printer could be lost during a printer fault. (6) DO NOT open the media cover and battery cover during operation. Doing so will stop printer operation. (7) DO NOT scratch the surface of printed labels or receipt with a sharp object. - viii -
Resumo do conteúdo contido na página número 11
EO1-33038 TABLE OF CONTENTS Page 1. INTRODUCTION ............................................................... 1-1 1.1 APPLICABLE MODEL .............................................. 1-2 1.2 ACCESSORIES ........................................................ 1-2 2. SPECIFICATIONS ............................................................ 2-1 2.1 PRINTER .................................................................. 2-1 2.2 SERIAL INTERFACE (RS-232C) .............................. 2-2 2
Resumo do conteúdo contido na página número 12
EO1-33038 7. CONNECTING THE SERIAL INTERFACE CABLE ......... 7-1 8. ISSUING THE MEDIA ...................................................... 8-1 9. CARE/HANDLING OF THE MEDIA ................................. 9-1 10. GENERAL MAINTENANCE ........................................... 10-1 10.1 CLEANING ............................................................. 10-1 10.2 COVERS ................................................................. 10-3 10.3 REMOVING JAMMED MEDIA .......................
Resumo do conteúdo contido na página número 13
EO1-33038 1. INTRODUCTION 1. INTRODUCTION 1. INTRODUCTION Thank you for purchasing the TEC B-SP2D series portable printer. This printer displays its high performance with extraordinarily high speed printing up to 80 mm/sec. It has a considerably compact and light body - 44 mm in height, 114 mm in width and 91 mm* in depth, weighing about 380 g*. (*: For the GH40 model, 101 mm in depth and 410 g in weight.) Besides the RS-232C, IrDA, Bluetooth, and wireless LAN which require no cable for data tr
Resumo do conteúdo contido na página número 14
EO1-33038 1. INTRODUCTION 1.1 APPLICABLE MODEL 1.1 APPLICABLE MODEL • B-SP2D Series Model name description B - S P 2 D - G H 2 0 -Q M Destination Interface 20: IrDA + RS-232C 30: IrDA + Bluetooth 40: IrDA + Wireless LAN Print mode H: Batch/Strip mode Dot density of the print head G: 8 dots/mm 1.2 ACCESSORIES Owner’s Manual (1 copy) Battery (1 pc.) Media Guide (2 pcs.) Belt Holder (1 pc.) Media Guide for Outside Cable Clamp (1 pc.) Wound Paper (1 pc.) (GH20 model only) Ferrite Core (1 pc.) SMW-
Resumo do conteúdo contido na página número 15
EO1-33038 2. SPECIFICATIONS 2.1 PRINTER 2. SPECIFICATIONS 2.1 PRINTER Item Description Dimensions GH20/30 model: 114mm (W) x 91mm (H) x 44mm (D) GH40 model: 114mm (W) x 101mm (H) x 44mm (D) Weight GH20/30 model: Approx. 380 g (Including a battery) GH40 model: Approx. 410 g (Including a battery) Operating Temperature -5°C to 40°C Operating humidity 25% to 85% RH (No condensation) Print mode Batch mode/Strip mode Print head Thermal print head Print method Thermal direct Print head dot density 8 do
Resumo do conteúdo contido na página número 16
EO1-33038 2. SPECIFICATIONS 2.2 SERIAL INTERFACE (RS-232C) Item Description Interface GH20 model: IrDA + RS-232C GH30 model: IrDA + Bluetooth GH40 model: IrDA + Wireless LAN Power source Lithium ion battery 7.4V 1400mA (nominal) NOTES: 1. Print speed automatically changes depending on the operating temperature, head temperature, and battery voltage. 2. Some fonts and bar codes are not available depending on the print mode. 3. Some two-dimensional codes are not available depending on the print mo
Resumo do conteúdo contido na página número 17
EO1-33038 2. SPECIFICATIONS 2.4 WIRELESS LAN INTERFACE 2.4 WIRELESS LAN INTERFACE The following specification is applicable only to the GH40 model. Item Description Communication method IEEE802.11b Supporting print protocol Socket/LPR Communicable distance 100 m (When there is no obstacle.) Client protocol DHCP, WINS Security protocol WEP (40 bits/104 bits), MD5/EAP Flow control TCP/IP Antenna Built-in Parameter setting Via HTTP, via IrDA 2.5 IrDA INTERFACE Item Description Type Physical layer
