Manual do usuário Ultra electronic Magicard Latin Series

Resumo do conteúdo contido na página número 1

MAGICARD LATIN SERIES PRINTER
INSTRUCTIONS FOR REPLACEMENT OF THE
PRINTHEAD
ASSEMBLY



CAUTION – The following procedures involve contact with Electrostatic
Sensitive Devices. All precautions for handling Electrostatic Sensitive Devices
should be followed at all times, including the use of a grounded wrist strap.




HOW TO USE THESE
INSTRUCTIONS



Your replacement printhead is despatched to you fully set up in the factory.
All you are required to do is:

1. Physically r

Resumo do conteúdo contido na página número 2

3506/07/01 Issue 1 LATIN SERIES DCR No. 26759 PRINTHEAD INSTALLATION & COMMISIONING

Resumo do conteúdo contido na página número 3

Removal of the Unserviceable Printhead 1. Ensure that the printer is switched off and disconnected from the mains supply. 2. Release the door catch and lift open the door assembly. 3. Locate and release the Quick Release Fastener on the Print head Assembly. 3. Gently lift the printhead assembly forwards and downwards away from the lid assembly. 4. Disconnect the electrical connector from the printhead. Installing the Replacement Printhead 1. Ensure the

Resumo do conteúdo contido na página número 4

Adjusting the Print Density To adjust the Print Density, ensure that there is power to the printer, the printer is connected to the computer and the printer is on line (Green light illuminated) CAUTION WHEN ADJUSTING THE PRINT DENSITY SETTING IT IS IMPORTANT TO NOTE THAT TOO HIGH A SETTING WILL CAUSE THE DYE FILM TO OVERHEAT AND ADHERE TO THE CARDS AN EXCESSIVELY HIGH SETTING WILL CAUSE THE DYE FILM TO MELT. 1. Select the Magicard Support Tool Program from your compute