Resumo do conteúdo contido na página número 1
4-115-585-11 (2)
Data Projector
Operating Instructions
Before operating the unit, please read this manual
thoroughly and retain it for future reference.
SRX-T110
SRX-T105
© 2008 Sony Corporation
Resumo do conteúdo contido na página número 2
guarantee matters please refer to the addresses given in Owner’s Record separate service or guarantee documents. The model and serial numbers are located at the side. Record these numbers in the spaces provided below. This apparatus shall not be used in the residential area. Refer to these numbers whenever you call upon your Sony For kundene i Norge dealer regarding this product. Dette utstyret kan kobles til et IT-strømfordelingssystem. Model No.____________________ For the State of Califo
Resumo do conteúdo contido na página número 3
Table of Contents Chapter 1 Overview Precautions ......................................................................................5 Features............................................................................................7 Location and Function of Controls ................................................8 Projector Unit ........................................................................................ 8 Control Function Menu Window ........................................
Resumo do conteúdo contido na página número 4
Projecting the Picture ...................................................................22 Using the Remote Commander ........................................................... 22 Using the Computer for Controlling the Projector.............................. 23 Projecting a 4K Signal in Single-screen Mode ................................... 25 Chapter 4 Adjustments and Settings Using the SRX Controller Displaying the Control Function Menu Window .........................26 PICTURE CONTROL W
Resumo do conteúdo contido na página número 5
Chapter 1 Overview Overview 1 Chapter Dangerous area in case of lamp explosion Precautions On safety 2000 3 � Operate the unit on 200 – 240 V AC, 50/60 Hz (SRX- (78 /4) T110), or 100 – 240 V AC, 50/60 Hz (SRX-T105). � Should any liquid or solid object fall into the cabinet, unplug the unit and have it checked by your Sony dealer before operating it further. � Unplug the unit from the wall outlet or set the power 3 3 switch to the lower position if it is not to be used for 1000 (39 /8) 100
Resumo do conteúdo contido na página número 6
Chapter 1 Overview projector. Be aware that room heat rises to the ceiling; For maximum protection, repack your unit as it was check that the temperature near the installation location originally packed at the factory. is not excessive. � Install the projector on the floor or hang it from the On “stuck” pixels on a LCD screen ceiling. Any other installation causes a malfunction such The LCD panel fitted to this unit is manufactured with high as color irregularity or a shorten lamp life.
Resumo do conteúdo contido na página número 7
Chapter 1 Overview Flexible and Reliable System Features Dual lamp system The projector adopts a dual lamp system for versatility of use. You can select dual-lamp or single-lamp mode, and High Brightness, High Picture Quality can reduce each lamp’s power output. These modes allow you to save power and increase lamp life. High brightness Also, if one bulb burns out, the other keeps projecting The SRX-T110 uses two 2 kW Xenon lamps as a light images. source, and the SRX-T105 uses two 1 k
Resumo do conteúdo contido na página número 8
Chapter 1 Overview Left Side/Rear Location and Function of 1 2 Controls Projector Unit Front/Top 12 3 3 45 6780 9 qa qs 4 567 8 a Cooling unit A cooling fan and the two lamp houses (these are not a Remote control detector (front) supplied) are installed here. For installation and replacement of a lamp house, consult b Upper side ventilation holes (intake) your Sony dealer. c Upper side ventilation holes (exhaust) b Upper/rear side ventilation holes (exhaust) d Adjusters c Remote control de
Resumo do conteúdo contido na página número 9
Chapter 1 Overview Commander. Flashes while the fans continue to run to 11 2233 44 55 reduce internal heat. h INTER LOCK jack (minijack) Connects to the external emergency switch. When you use the interlock function, insert the mini-plug into this jack to open the + and – terminals. The projector’s lamps will be turned off immediately. When not in use, do not insert the mini-plug. i ETHERNET connector (10BASE-T/100BASE-TX) Connect to the ethernet connector on a computer in which the sup
Resumo do conteúdo contido na página número 10
Chapter 1 Overview Location: Shows the installation location of the projector For details on each window, see “Adjustments and that was set in the SETTING window. Settings Using the SRX Controller” on page 26. Name: Shows the name of the projector that was set in the SETTING window. SCREEN CONTROL window Operation Timer: Shows the total operating hours of the projector. 12 1 2 33 44 55 Lamp A/Lamp B: Shows an approximate percentage to indicate the time used before the recommended time fo
Resumo do conteúdo contido na página número 11
Chapter 1 Overview The setting also functions when you operate this unit with c MUTING button the Remote Commander. Press to cut off the whole picture on the screen. Press it again to restore the picture. Activating the muting function shuts off from lamp light completely using a shutter, and Remote Commander displays the black signal on the whole screen. d FUNCTION 1/2/3 buttons Notes Use these buttons in synchronization with the FUNCTION � Be sure that there is nothing to obstruct the i
Resumo do conteúdo contido na página número 12
Chapter 1 Overview Select the input signal with one of the INPUT SEL A/B/C/ D buttons (5), then select the screen with one of these buttons. Example: When you want to project the signal input from the INPUT B board on Screen 3 (lower left screen), press the INPUT SEL B button, then press the SCREEN SEL 3 button. h LENS CONT (Lens control) buttons FOCUS +/–: Adjust the focus. Pressing the + button focuses on a picture further back. Pressing the – button focuses on a forward picture. ZOOM
Resumo do conteúdo contido na página número 13
Chapter 2 Preparations Preparations 2 Chapter activating the protection circuit. Be sure not to block the ventilation holes for exhaust. Leave a space of more than Precautions on 3 1m (39 /8 inches) around the unit. Installation Extremely hot and humid Unsuitable Installation Do not install the projector in the following situations. Such installations may cause a malfunction or damage to the projector. Poorly ventilated Location subject to sudden change of temperature The projector is e
Resumo do conteúdo contido na página número 14
Chapter 2 Preparations Unsuitable Conditions Installation Do not use the projector under the following conditions. Laying the unit on its side or upside down Using the Carrying Handles Use the front and rear carrying handles to carry the projector. Tilting the unit to the right or left Caution To avoid injury, have at least four people carry the projector using the front and rear handles. ±10° Avoid tilting the projector more than ± 10 degrees. Doing so may cause color shading or shorten t
Resumo do conteúdo contido na página número 15
Chapter 2 Preparations Caution Installing the SRX Do not turn the spanner forcibly when the screw has fully rotated. Otherwise, the spanner may slip and injure your Controller in a Computer hand. for Controlling the Projector Installing the Projector This section describes briefly how to install the projector If you install the supplied SRX Controller in a computer, on the floor. The distance between the center of the lens you can control the projector from the computer. and the scree
Resumo do conteúdo contido na página número 16
Chapter 2 Preparations When you want to install it in the currently displayed After a while, the Welcome page of the SRX folder, click “Next”. Controller appears. If you want to install it in a different folder, click “Change…”, specify the folder, click “OK”, then click “Next”. The installation start window appears. 2 Click “Next”. The License Agreement window appears. 4 Click “Install”. The program installation starts. After a while, the following window appears. 3 Read the license ag
Resumo do conteúdo contido na página número 17
Chapter 2 Preparations Installation of the SRX Controller is completed. To restart the SRX Controller immediately after Connecting a Computer installation has been completed, click to check “Launch SRX Controller for SRX-T series”, then click for Controlling the “Finish”. Projector The icon is displayed in the desktop window. Connect a computer for controlling the projector to the projector via the ETHERNET connector or the RS232C connector. Connecting the Computer via the Ethernet
Resumo do conteúdo contido na página número 18
Chapter 2 Preparations CAUTION Starting the SRX For safety, do not connect the connector for peripheral device wiring that might have excessive voltage to this Controller port. Follow the instructions for this port. Note Starting the SRX Controller If the power of the projector remains on for a long period of time without the ethernet cable connected, the message Double-click the icon for the SRX Controller in the “Sony Data Projector Initializing…” may appear in the desktop window o
Resumo do conteúdo contido na página número 19
Chapter 2 Preparations When connecting the computer via a network by About the Program Launcher screen specifying the IP address of the projector 112 3 Select “Network” from the “Connect” menu on the menu bar to open the dialog. Enter the IP address and model name of the projector, then click “OK”. To change the port number, select “PC Port Setting” from the “Connect” menu on the menu bar to display the dialog. Enter the new port number in the dialog and click “OK”. When connecting the c
Resumo do conteúdo contido na página número 20
Chapter 2 Preparations HDCP (High-bandwidth Digital Content Protection) DVI- D signal can also be input when the input signal with Connecting the Projector specified resolution is input from LKRI-005. For details, refer to the Operating Instructions of LKRI- When you connect the projector, make sure to: 005. � Turn off all equipment before making any connections. � Use the proper cables for each connection. Notes � Insert the cable plugs firmly; loose connections may increase noise and redu
