Resumo do conteúdo contido na página número 1
Projector
CP-RS56/CP-RX61/CP-RS57
User's Manual – Operating Guide
Thank you for purchasing this projector.
WARNING ►Before using, read the "User's Manual - Safety Guide" and
these manuals to ensure correct usage through understanding. After reading,
store them in a safe place for future reference.
About this manual
Various symbols are used in this manual. The meanings of these symbols are
described below.
WARNING This symbol indicates information that, if ignored, could possibly
result in
Resumo do conteúdo contido na página número 2
Contents Contents About this manual . . . . . . . 1 . .EASY . MENU . . . . . . . . . . . . . . . . . .6 Aspect, Zoom, Keystone, Mode, Contents . . . . . . . . . . . .2 . . . . . Bright, Contrast, Color, Tint, Projector features . . . . . . . 3 . . . Sharpness, Whisper, Mirror, Reset, About contents of package . .3 Filter time, Language, Go to Advance Menu Part names . . . . . . . . . . . 4 . . . . Projector . . . . . . . . . . . . . . . . . . . . . .4 PICTURE menu . . . . .
Resumo do conteúdo contido na página número 3
Projector features / About contents of package Projector features This projector is used to project various computer signals as well as NTSC / PAL / SECAM video signals onto a screen. It requires just a little space for installation and gets a large image from short distance. High Brightness Newly developed 65W UHB (Ultra High Brightness) lamp gives you a higher brightness image on a screen. The image can be still kept as bright and clean enough for use in bright rooms. Low Noise WHISP
Resumo do conteúdo contido na página número 4
Part names Part names Projector Zoom ring (20) Focus ring (20) Remote sensor (8) Vent (10) Speaker Lens (17, 46) Elevator button (12) Lens cover (6, 17) Elevator foot ( 12) Front-Right side Lamp cover (43) (Lamp unit is inside.) Filter cover ( 9, 10, 44) (Air filter and intake vent are inside.) Bottom side Control buttons (5) Power switch (17, 18) AC inlet (16) Ports Elevator button (12) (See below.) Elevator foot (12) Vent (10) Rear-Left side RGB IN port ( 14) RGB IN
Resumo do conteúdo contido na página número 5
Part names Controls LAMP indicator (48) LAMP TEMP TEMP indicator ( 48) POWER POWER indicator (17, 18, 48) INPUT INPUT button (19) Cursor buttons ▲,▼,◄,► (19~41) MENU STANDBY/ON button (17, 18) STANDBY/ON Remote control STANDBY/ON button SEARCH button ( 20) (17, 18) RGB button (19) AUTO button (21) VIDEO button (19) VIDEO RGB SEARCH BLANK button ( 22) ASPECT button (20) ASPECT AUTO BLANK MAGNIFY VOLUME ON VOLUME button (19) MAGNIFY MUTE MUTE button (19) OFF ON button (
Resumo do conteúdo contido na página número 6
Preparations Preparations Fastening the lens cover WARNING ►Do not fasten the lens cover during use or immediately after use. Handling while the projector is in a high temperature could cause a burn and/or malfunction to the projector. Before operating, make sure that the power switch is off, that the power cord is not plugged in, and that the projector is cool adequately. To avoid losing, please fasten the lens cover to the projector using the strap. Slowly turn over the projector, so tha
Resumo do conteúdo contido na página número 7
Preparations Putting batteries WARNING ►Always handle the batteries with care and use them only as directed. Improper use may result in battery explosion, cracking or leakage, which could result in fire, injury and/or pollution of the surrounding environment. • Be sure to use only the batteries specified. Do not use batteries of different types at the same time. Do not mix a new battery with used one. • Make sure the plus and minus terminals are correctly aligned when loading a battery. •
Resumo do conteúdo contido na página número 8
Preparations Using the remote control CAUTION ►Be careful in handling the remote control. Incorrect handling could cause damage or malfunction. • Do not drop or otherwise expose the remote control to physical impact. • Do not get the remote control wet or place it on wet objects. • Remove the batteries from the remote control and store them in a safe place if you won’t be using the remote control for an extended period. • Replace the batteries whenever the remote control starts to malfuncti
Resumo do conteúdo contido na página número 9
Preparations About the filter cover for bottom-up use WARNING ►Do not replace the filter cover and/or air filter during use or immediately after use. Handling while the projector is in a high temperature could cause a burn and/or malfunction to the projector. Before operating, make sure that the power switch is off, that the power cord is not plugged in, and that the projector is cool adequately. When the projector is installed bottom up, please use the accessory filter cover for bottom-up
Resumo do conteúdo contido na página número 10
Setting up Setting up WARNING ►Place the projector in a stable position horizontally. A fall or a turnover could cause an injury and/or damage to the projector. Then using damaged projector could result in a fire and/or an electric shock. • Don’t place the projector on an unstable, slant or vibrant surface such as a wobbly or inclined stand. • Do not place the projector in the side/front/rear-up position, except care of the air filter. • For the projector installed bottom-up, use the ac
Resumo do conteúdo contido na página número 11
Setting up Arrangement Refer to the illustrations and tables below to determine the screen size and projection distance. The values shown in the table are calculated (±3%) for a full size screen of 800x600 for the model CP-RS56 / CP-RS57, or 0 4x768 for the model CP-RX6. (b) 4:3 6:9 (c) up (a) (a) (c) down For the model CP-RS56 4 : 3 screen 6 : 9 screen (a) Screen (b) Projection distance (c) Screen height (b) Projection distance (c) Screen height size [m (inch)] [cm (inch)] [m (inch)
Resumo do conteúdo contido na página número 12
Setting up Adjusting the projector's elevator WARNING ►Do not adjust the projector’s elevator during use or immediately after use. Handling while the projector is in a high temperature could cause a burn and/or malfunction to the projector. Before operating, make sure that the power switch is off, that the power cord is not plugged in, and that the projector is cool adequately. CAUTION ►If you press the elevator button without holding the projector, the projector might crash down, overtur
Resumo do conteúdo contido na página número 13
Setting up Connecting your devices CAUTION ►Turn off all devices prior to connecting them to the projector. Attempting to connect a live device to the projector may generate extremely loud noises or other abnormalities that may result in malfunction and/or damage to the device and/or projector. ►Use the accessory cable or a designated-type cable for the connection. Some cables have to be used with core set. A too long cable may cause a certain picture degradation. Please consult with your
Resumo do conteúdo contido na página número 14
Setting up Examples of connection with a computer Stereo mini audio cable RGB cable RS-3 C cable RGB OUT RGB IN2 RGB IN1 OUT RGB out RS-3C Audio out CONTROL S-VIDEO VIDEO AUDIO IN RGB cable RGB IN2 Audio out RGB OUT RGB IN2 RGB IN1 OUT AUDIO IN CONTROL S-VIDEO VIDEO RGB out Stereo mini audio cable Connecting to a monitor (output) RGB cable R GB OU T RGB OUT RGB IN2 RGB IN1 OUT RGB in AUDIO IN CONTROL S-VIDEO VIDEO Connecting to a speaker with amplifier (output) Stereo mini audio ca
Resumo do conteúdo contido na página número 15
Setting up Examples of connection with a VCR/DVD player Stereo mini audio cable Video cable RGB OUT RGB IN2 RGB IN1 OUT Audio out Video out AUDIO IN CONTROL S-VIDEO VIDEO Stereo mini audio cable S-Video cable RGB OUT RGB IN2 RGB IN1 OUT Audio out S-Video out AUDIO IN CONTROL S-VIDEO VIDEO Stereo mini audio cable Component video cable RGB OUT RGB IN2 RGB IN1 OUT Audio out Component video out CONTROL AUDIO IN S-VIDEO VIDEO 5
Resumo do conteúdo contido na página número 16
Setting up Connecting power supply WARNING ►Please use extra caution when connecting the power cord as incorrect or faulty connections may result in fire and/or electrical shock. • Only use the power cord that came with the projector. If it is damaged, contact your dealer to newly get correct one. • Only plug the power cord into an outlet rated for use with the power cord's specified voltage range. • Never modify the power cord. Never attempt to defeat the ground connection of the three-pro
Resumo do conteúdo contido na página número 17
Power on/off Power on/off Turning on the power WARNING ►When the power is on, a strong light is emitted. Do not look into the lens or vents of the projector. NOTE • Turn the power on in right order. Please power on the projector before the connected devices. LAMP VIDEO RGB SEARCH TEMP BLANK ASPECT AUTO POWER indicator POWER MAGNIFY VOLUME ON INPUT MUTE OFF FREEZE KEYSTONE STANDBY/ON ZOOM - + POSITION MENU button ENTER MENU ESC RESET Power switch STANDBY/ON Make sure that the power cord is
Resumo do conteúdo contido na página número 18
Power on/off Turning off the power NOTE • Turn the power off in right order. Please power off the projector after the connected devices. • Except for an emergency, whenever you turn the projector off, obey the procedure of the following “Turning off the power”, and do not disconnect the power cord until the procedure is completed. Neglect causes a damage of the electrode and un-lighting of the lamp. • This Projector is controlled by an internal microprocessor. Under certain exceptional cir
Resumo do conteúdo contido na página número 19
Operating Operating Adjusting the volume VIDEO RGB SEARCH ASPECT AUTO BLANK VIDEO RGB SEARCH MAGNIFY VOLUME ON Press the VOLUME button on the remote control. OFF MUTE ASPECT AUTO BLANK . FREEZE KEYSTONE ZOOM A dialog will appear on the screen to aid you in adjusting - + MAGNIFY VOLUME ON POSITION MENU ENTER the volume. MUTE ESC RESET OFF FREEZE KEYSTONE Use the cursor buttons ▲/▼ to adjust the volume. . ZOOM + - To close the dialog and complete the operation, press the VOLUME button POSITI
Resumo do conteúdo contido na página número 20
Operating STANDBY/ON VIDEO RGB SEARCH Searching an input signal ASPECT AUTO BLANK VIDEO MAGNIFRG Y B HOME SEARCPAGE UP H VOLUME ON BLANK ASPECT AUTO END PAGE DOWN MUTE OFF Press the SEARCH button on the remote control. MAGNIFY VOLUME ON FREEZE KEYSTONE . OFF MUTE VIDEO RGB SEARCH FREEZE KEYSTONE The projector will begin to check its input ports in order POSITION MENU ZOOM - + POSITION MENU ASPECT AUTO BLANK ENTER to find any input signals. ENTER ESC RESET MAGNIFY ESC RESET VOLUME ON Then w
