Resumo do conteúdo contido na página número 1
Projector
WT615/WT610
User’s Manual
The WT615 projector is not distributed in the U.S.A or Canada.
Resumo do conteúdo contido na página número 2
Important Information Safety Cautions Precautions Please read this manual carefully before using your NEC WT615/WT610 Projector and keep the manual handy for future reference. Your serial number is located on the right side of your projector. Record it here: CAUTION To turn off main power, be sure to remove the plug from power outlet. The power outlet socket should be installed as near to the equipment as possible, and should be easily accessible. CAUTION TO PREVENT SHOCK, DO NOT OPEN THE CABINE
Resumo do conteúdo contido na página número 3
Important Information RF Interference (for USA only) WARNING The Federal Communications Commission does not allow any modifications or changes to the unit EXCEPT those specified by NEC Solutions (America), Inc. in this manual. Failure to comply with this government regulation could void your right to operate this equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide re
Resumo do conteúdo contido na página número 4
Important Information Fire and Shock Precautions 1. Ensure that there is sufficient ventilation and that vents are unobstructed to prevent the build-up of heat inside your projector. Allow at least 4 inches (10 cm) of space between your projector and a wall. 2. Prevent foreign objects such as paper clips and bits of paper from falling into your projector. Do not attempt to retrieve any objects that might fall into your projector. Do not insert any metal objects such as a wire or screwdriver into
Resumo do conteúdo contido na página número 5
Important Information Lamp Replacement •To replace the lamp, follow all instructions provided on page 134. • Be sure to replace the lamp when the message “The lamp has reached the end of its usable life. Please replace the lamp.” appears. If you continue to use the lamp after the lamp has reached the end of its usable life, the lamp bulb may shatter, and pieces of glass may be scattered in the lamp case. Do not touch them as the pieces of glass may cause injury. If this happens, contact your NEC
Resumo do conteúdo contido na página número 6
Table of Contents Important Information ........................................................................... i 1. Introduction ...................................................................................... 1 What's in the Box? ........................................................................................................ 2 Introduction to the Projector ......................................................................................... 3 Part Names of the Proje
Resumo do conteúdo contido na página número 7
Table of Contents 4. Convenient Features...................................................................... 50 Turning Off the Image and Sound ............................................................................... 51 Freezing a Picture....................................................................................................... 51 Using the Pointer ........................................................................................................ 51 Enlarging an
Resumo do conteúdo contido na página número 8
1 Introduction ○○○○○○○○○○○○○○○○○○○○○○○○○○○ ○○○○○○○○○○○○○ What's in the Box? ....................................................... 2 Introduction to the Projector ........................................ 3 Part Names of the Projector ........................................ 5 Opening and Closing the Mirror Cover ................................................................... 6 Top Features ................................................................................................
Resumo do conteúdo contido na página número 9
UNLOCK MIRROR LOCK Setup Guide NEC Network Setup Guide Important Information 1. Introduction What's in the Box? Make sure your box contains everything listed. If any pieces are missing, contact your dealer. Please save the original box and packing materials if you ever need to ship your Projector. Remote control Batteries (AAA 2) (7N900501) Projector Power cable RGB/VGA signal cable Remote Control USB cable (7N080204) US (7N520032) Cable (7N520045) (7N080008) EU (7N520019) • Security sticker
Resumo do conteúdo contido na página número 10
1. Introduction Introduction to the Projector This section introduces you to the WT615/WT610 Projector and describes key features and controls. Congratulations on Your Purchase of the WT615/WT610 Projector The WT615/WT610 is a sophisticated four aspherical mirror XGA projector that produces an enhanced display. With the WT615/WT610 you will be able to project images up to 100” (measured diagonally). Enjoy crisp and sharp large screen display from your PC, workstation or Macintosh computer, DVD
Resumo do conteúdo contido na página número 11
1. Introduction About this user's manual The fastest way to get started is to take your time and do everything right the first time. Take a few minutes now to review the user's manual. This may save you time later on. At the beginning of each section of the manual you'll find an overview. If the section doesn't apply, you can skip it. • IBM is a trademark or registered trademark of International Business Machines Corporation. • Mac, Macintosh and PowerBook are trademarks of Apple Computer, Inc.,
Resumo do conteúdo contido na página número 12
UNLOCK MIRROR LOCK 1. Introduction Part Names of the Projector Front indicator Mirror cover Lights blue to indicate that the projector is turned on or in the Standby mode. Mirror cover lock switch NOTE: When [Standby Mode] is set to “Power-saving”, this indicator lights blue only with power on. Speaker Ventilation (outlet) Foot Foot Remote sensor Lamp cover Lamp cover screw Built-in Security Slot ( )* Speaker Foot * This security slot supports the MicroSaver® Security System. MicroSaver® is a
Resumo do conteúdo contido na página número 13
UNLOCK MIRROR LOCK UNLOCK MIRROR LOCK UNLOCK MIRROR LOCK UNLOCK MIRROR LOCK 1. Introduction Opening and Closing the Mirror Cover To close the mirror cover: To open the mirror cover: 1. Slide the mirror cover lock switch to the unlock position. 1. Slowly close the mirror cover while holding both ends. 1 1 2. Slowly open the mirror cover holding both ends. NOTE: • Do not release your hold of the mirror cover until the mirror cover is fully closed. • Do not apply excessively strong pressure against
Resumo do conteúdo contido na página número 14
1. Introduction Top Features 5. SOURCE Button Use this button to select a video source such as a PC, PC CARD 13 VCR, DVD player or Viewer (PC card). 8 FOCUS Press and release this button quickly to display the Source List. SOURCE 5 MENU Each time this button is pressed for a minimum of ONE second, the input source will change as follows: 9 Computer → DVI (DIGITAL) → DVI (ANALOG) → 10 Video → S-Video → Viewer → Computer → ... SELECT If no input signal is present, the input will be skipped. 12 11
Resumo do conteúdo contido na página número 15
1. Introduction Terminal Panel Features 10 11 14 15 13 12 4 2 6 REMOTE PCCONTROL PC CARD USB AUDIO IN AUDIO OUT IN DVI-I COMPUTER S-VIDEO IN DVI-I IN COMPUTER IN MONITOR OUT AUDIO IN VIDEO IN L R /MONO 9 8 7 3 1 5 1. COMPUTER IN / Component Input Connector 6. AUDIO OUT Mini Jack (Stereo Mini) (Mini D-Sub 15 Pin) Connect an additional audio equipment here to listen to audio coming from your COMPUTER, DVI-I, VIDEO Connect your computer or other analog RGB equip- or S-VIDEO input. ment such as IBM
Resumo do conteúdo contido na página número 16
1. Introduction Terminal Panel Features 10 11 14 15 13 12 4 2 6 REMOTE PCCONTROL PC CARD AUDIO IN AUDIO OUT USB IN DVI-I COMPUTER S-VIDEO IN DVI-I IN COMPUTER IN MONITOR OUT AUDIO IN VIDEO IN R L /MONO 9 8 7 3 1 5 12. USB Port (Type B) 14. PC CARD Slot Connect this port to the USB port (type A) of your PC Insert a PC card, commercially available LAN card or using the supplied USB cable. You can operate your NEC optional wireless LAN card here. computer's mouse functions from the remote control.
Resumo do conteúdo contido na página número 17
T I X E R U - C N 1. Introduction Part Names of the Remote Control 2 6. MAGNIFY (+) (–) Buttons Use these buttons to adjust the image size. 3 1 The image can be magnified about the center of the screen up to 400%. See page 52. OFF ON 4 POWER 5 7. LASER Button LASER 7 MAGNIFY PAGE Press and hold this button to activate the laser pointer. UP POINTER When lit, you can use the laser to draw your audience's 6 9 DOWN attention to a red dot that you can place on any ob- 8 ject. See page 44. 10 8. POI
Resumo do conteúdo contido na página número 18
T I X E R U - C N 1. Introduction 20. SLIDE (+) (–) Buttons 15 Press (+) to select the next folder or slide and press (–) to select the previous folder or slide. 21. ASPECT Button Press this button to display the Aspect Ratio select menu. See page 90. 22. PIC-MUTE Button This button turns off the image and sound for a short period of time. Press again to restore the image and sound. See page 51. 15. L-CLICK Button 23. HELP Button Works as the mouse left button when the supplied Provides the onli
Resumo do conteúdo contido na página número 19
1. Introduction Battery Installation 1 2 3 Slip the cover back over the bat- Remove the battery cover. Remove both old batteries and teries until it snaps into place. NOTE: Do not pull the battery install new ones (AAA). Ensure that you have the batteries' po- NOTE: Do not mix different types of cover by force. Doing so can larity (+/ –) aligned correctly. batteries or new and old batteries. result in its complete removal. 2 2 1 1 Operating Range for Wireless Remote Control Remote sensor on the
Resumo do conteúdo contido na página número 20
1. Introduction Part Names and Functions of the Supplied Electronic Pen (WT615 only) The WT615 comes with an electronic pen. The electronic pen works as a USB mouse connected to the projector. See page 53 for connecting a USB mouse. The electronic pen and the projector’s sensors can be used to convert your whiteboard into a virtual touchscreen which allows you to operate your projector’s menu or use the ChalkBoard feature. See “ Using the Electronic Pen” on page 45. Important Before you use t
