Resumo do conteúdo contido na página número 1
CA611 Owners Manual
CAUTION!
Be certain that the vehicle is outdoors before using this or any re-
mote vehicle starting device. A running engine produces dangerous
carbon monoxide fumes which can be harmful or fatal if prolonged
exposure occurs. DO NOT remote start the vehicle if the car is
garaged.
Resumo do conteúdo contido na página número 2
Your Remote Start Alarm System has many features and available options some of which are selected at time of installation. Consult your installing dealer for options that may have been installed and are not listed. ARMING THE SYSTEM: 1. Turn the engine OFF, exit the vehicle, and close all doors, hood and trunk. 2. Press and release the Arm button of your transmitter one time. The parking lights will flash once, the siren will chirp once, and the LED will begin to flash slowly confirming the syst
Resumo do conteúdo contido na página número 3
ARMING THE SYSTEM: If the passive arming feature has been selected: Turn the engine OFF, exit the vehicle, and close all doors, hood and trunk. The LED will begin to flash rapidly indicating that the 30 second passive arming timer has begun. If the dash mounted LED does not begin to flash rapidly, then you have left a door, hood, or trunk ajar. Closing this entry point will allow the arming cycle will begin. If any entry point is opened during the 30 second arming cycle, arming will be suspende
Resumo do conteúdo contido na página número 4
DISARMING THE SYSTEM: As you approach the vehicle, press and release the Disarm button on the transmitter. The parking lights will flash 2 times, the siren/horn will chirp 2 times, and the LED will turn off. If you have the optional door lock/unlock circuit installed, the doors will unlock. If you have the optional entry illumination circuit installed, the interior light will turn on for 30 seconds or until the ignition key is switched on. NOTE: If the passive arming mode was selected at time of
Resumo do conteúdo contido na página número 5
zone. For additional information, refer to INTRUSION WARNING SIGNALS (page 5) of this manual. NOTE: If the optional 2 step door unlock circuit is installed, when the unlock transmitter button is activated, the drivers door only will unlock, pressing the unlock button a second time will cause all doors to unlock. If your transmitter has a sperate lock unlock buttons, pressing the unlock button anytime after the first unlock command will cause all the vehicle doors to unlock. WHILE THE SYSTEM IS
Resumo do conteúdo contido na página número 6
VALET MODE: The valet button allows you to temporarily bypass all alarm functions, eliminating the need to hand your transmitter to parking attendants or garage mechanics. When the system is in valet mode, all alarm functions are bypassed, however the remote panic feature, remote door locks and remote start will remain operational. 1. Enter the vehicle, and turn the ignition key to the ON position. 2. Press and hold the valet button until the LED turns on solid. The system will remain in the v
Resumo do conteúdo contido na página número 7
1. Disarm the system by use of the transmitter, or by use of the emergency override sequence. Turn the ignition switch to the ON position. 2. Within 10 seconds, press and release the valet/override button 3 times. 3. Within 10 seconds turn the ignition switch OFF, ON, OFF, ON, OFF, ON. (The siren/horn will sound and the lights will flash one time.) 4. Within 10 seconds, begin to enter your chosen 10ths digit by pressing and releasing the button from 1 up to 9 times. 5. Within 10 seconds of the l
Resumo do conteúdo contido na página número 8
5. Within 10 seconds, begin to press and release the push button switch to set the tenths digit. (As per example press and release 5 times to set the tenths digit to 5) 6. Within 10 seconds of the last press of the button, turn the ignition OFF then ON. 7. Within 10 seconds, Begin to press and release the button to set the units digit. (As per example, press and release 2 times to set the units digit to 2) 8. Turn the ignition switch to the OFF position. Immediately observe the LED flash pattern
Resumo do conteúdo contido na página número 9
new code tenths for step 2 above, and units for step 5 above. ELIMINATING THE NORMAL ARM/DISARM CHIRPS You can selectively eliminate the normal arm and disarm chirps by holding the transmitter button slightly longer when arming or disarming. This will prevent the siren/horn chirps for one arm or disarm cycle. To eliminate the chirps permanently: 1. Start with the valet switch in the OFF position. 2. Turn the ignition switch ON then OFF. 3. Within 10 seconds of turning OFF the ignition switch, p
Resumo do conteúdo contido na página número 10
REMOTE STARTING THE VEHICLE: Press and release the option button of your transmitter 2 times within 2 seconds to activate the remote start system. The vehicle will start and remain running for the pre-programmed 10 or 15 minutes. As a visual indication, the parking lights will flash or turn on depending on the programming set up by your installa- tion center. When you arrive at your vehicle, unlock the vehicle by pressing and releasing the unlock button of your transmitter. Enter the vehicle a
Resumo do conteúdo contido na página número 11
ADDITIONAL REMOTE FUNCTION CHANNEL 3/TRUNK: The system has an additional feature (Channel 3) that can be connected to the Trunk Release. To operate the accessory associated with channel 3, press and hold the trunk button of your transmitter for 4 seconds. ADDITIONAL REMOTE FUNCTION CHANNEL 4: The system has an additional feature (Channel 4) that can be connected to a number of different optional accessories. To operate the accessory associated with channel 4, press and release the star " * " bu
Resumo do conteúdo contido na página número 12
CA 611 SYSTEM FUNCTIONS AT A GLANCE ALARM DASH MOUNTED LED INDICATORS RAPID FLASHING = PASSIVE ARMING SLOW FLASHING = ARMED OFF = DISARMED ON SOLID = VALET MODE 2 FLASH...SOLID = REMOTE START VALET MODE 3 FLASH...PAUSE = INTRUSION ZONE 3 2 FLASH...PAUSE = INTRUSION ZONE 2 1 FLASH...PAUSE = INTRUSION ZONE 1 ALARM SIREN/HORN CHIRP INDICATION 1 CHIRP = ARM 2 CHIRPS = DISARMED 3 CHIRPS = ARMING WITH ENTRY POINT OPENED 4 CHIRPS = DISARM AFTER INTRUSION 5 CONTINUOUS = TRIGGERED/PANIC ALARM PARKING LIG
Resumo do conteúdo contido na página número 13
Code Systems, Inc. Limited Lifetime Warranty Code Systems Inc. (“CODE”) warrants to the ORIGINAL PURCHASER of this CODE vehicle security product (the “Product”), purchased from an authorized CODE dealer, that (except as provided below) should this Product under normal use and conditions, be proven defective in material or workmanship DURING THE LIFETIME OF THE VEHICLE IN WHICH IT WAS ORIGINALLY INSTALLED, such defect(s) will be repaired or replaced (at CODE’s option) without charge for parts dir
