Manual do usuário Audiovox 09XR1PR

Resumo do conteúdo contido na página número 1

Model 09XR1Pr
This transmitter is designed for use with your upgrade
remote start unit and is programmed by using the remote
start's program switch in combination with the transmitter
button. This transmitter can be used with any Audiovox unit
color coded with an Orange LED in the receiver.
To program this transmitter into your remote start upgrade
unit:
1) Turn the ignition to the on position.
2) Press and release the programming switch 3 times.
3) Press and hold, for 3 seconds, the button of

Resumo do conteúdo contido na página número 2

Battery Replacement After removing the two #0 point phillips screws shown, pry apart case with the edge of a finger nail or a small common screwdriver. Keep hold of the metal key ring loop to prevent its loss as it will separate from the transmitter case. Carefully remove the discharged battery by sliding it out from under the clip in the direction indicated by the arrow in the diagram. Properly dispose of the exhausted battery and insert a new CR2032 battery, taking care to arrange it so that t

Resumo do conteúdo contido na página número 3

ORDER FORM FOR TRANSMITTER 09XR1Pr Attention: Transmitter Ordering Department Important: To help us expedite your order, please print all of the information legibly and mail this form and your pay- ment according to the instructions below. 1) Name:_____________________________________ 2) Address:_________________________________________ 3) City:________________State:________Zip Code:__________ 4) Telephone Number: ( )_____________________ 5) Total Number Of Transmitters Required:_______ Cost Pe

Resumo do conteúdo contido na página número 4

© 2010 Audiovox Electronics Corp., Hauppauge, N.Y. 11788 128-8858 128-8858 4 of 4