Resumo do conteúdo contido na página número 1
OPERATING INSTRUCTIONS
En (English)
CD Stereo System
MANUAL DE INSTRUCCIONES
E (Español)
NSX-D60
U C
MODE D'EMPLOI
F (Français)
OWNER'S RECORD
Record the model number and serial number of your set (found at the
rear of your set) below. Refer to them when contacting your Aiwa dealer.
Model No. _____________________________
Serial No. _____________________________
For assistance and information
(United States and Puerto Rico)
8C-NF7-903-11
011211BKH-U-FM
Resumo do conteúdo contido na página número 2
IMPORTANT SAFETY INSTRUCTIONS WARNING Read the Operating Instructions carefully and completely before Ventilation - The unit should be situated with adequate space To reduce the risk of fire or electric shock, do not expose operating the unit. Be sure to keep the Operating Instructions around it so that proper heat ventilation is assured. Allow 10 this appliance to rain or moisture. for future reference. All warnings and cautions in the Operating cm clearance from the rear and the top of the un
Resumo do conteúdo contido na página número 3
TABLE OF CONTENTS Overloading - Do not overload wall outlets, extension cords, Lightning IMPORTANT SAFETY INSTRUCTIONS ......... 2 integral convenience receptacles as this can result in a risk of For added protection for this unit receiver during a lightning PREPARATIONS ................................... 4 fire or electric shock. storm, or when it is left unattended and unused for long periods PARTS AND CONTROLS ......................... 5 of time, unplug it from the wall outlet and disconnect
Resumo do conteúdo contido na página número 4
PREPARATIONS 2 Connect the supplied antennas. Connection Remote control Strip off the insulation of the FM antenna with twisting Plug in the AC power cord to the AC power outlet after all other Detach the battery compartment lid at the rear of the remote the cord. connections are made. control and insert two R6 (size AA) batteries with correct Connect the FM antenna to the FM 75 Ω terminal without polarity. the 2 mark and the AM antenna to the AM LOOP 1 Connect the front speakers. terminals. Con
Resumo do conteúdo contido na página número 5
PARTS AND CONTROLS Main unit: rear Dynamic Integrated Neo Amplifier is a brand-new amplifier system where clear mid-to-high range 1 AM LOOP, FM 75 Ω terminals frequency sound, as well as rich low frequency sound, can be Plug in the supplied AM and FM antennas here. reproduced and listeners can enjoy the close-to-original sound 2 VIDEO/AUX jacks with less distortion at either high or low volume levels. Accepts analog sound signals from external equipment. Connect using an optional connecting cabl
Resumo do conteúdo contido na página número 6
Main unit: front TIMER DISPLAY Enters timer setting mode. Selects a spectrum analyzer display. 3 SYNC DUB TREBLE Starts dubbing a whole tape. Enhances high frequency sound. En wREC/REC MUTE T-BASS Starts recording. Emphasizes low frequency sound. 4aPAUSE/SET 6 DISC DIRECT PLAY 1-3 CD and Tape: pauses playback. Selects a CD tray. Radio: stores the received station to preset. DISC CHANGE sSTOP/CLEAR Rotates the CD trays. CD and Tape: stops playback. zCD OPEN/CLOSE Radio: clears a station preset. O
Resumo do conteúdo contido na página número 7
Remote control 3 The numbered buttons take on these functions when pressed 5 SHIFT Hold down when pressing a numbered button to change together with SHIFT held down: its function to that printed above the number. PROGRAM e.g.) Enters programed CD playback mode. "Press SHIFT+SLEEP on the remote control" indicates En "Hold down SHIFT and press '6' (SLEEP)", so that you RANDOM/REPEAT can use 'Sleep timer' function. Enters random or repeat CD playback mode. 6 REC MODE TUNER MODE Starts recording wit
Resumo do conteúdo contido na página número 8
ADJUSTMENTS BEFORE OPERATIONS DEMO If the clock has not been set, a DEMO appears on the display when the unit is turned off. To deactivate and activate the DEMO Press DEMO/ECO when the unit is turned off. En Spectrum analyzer display You can change the spectrum analyzer display. Press DISPLAY (SHIFT+DISPLAY on the remote control) repeatedly to select one of the three spectrum analyzer displays. - NORMAL: Displays the fluctuation from low frequencies to high ones - BASS : Displays the fluctuation
Resumo do conteúdo contido na página número 9
ECO mode Dimmer Setting the clock Reduces power consumption with the following operations, etc. Adjusts the brightness of the display. 1 Press SHIFT+CLOCK on the remote control. When the unit is turned off, you can also press aSET. 1 Press DEMO/ECO twice when the unit is turned - The unit blacks out when the unit is turned off. Only the red on, and then within 4 seconds press ENTER. 2 Press f or g to set the time. indicator lights up. (Only when the clock is set.) Each press changes the time in
Resumo do conteúdo contido na página número 10
CD OPERATIONS To replace disc(s) during playback without interruption While one disc is being played back, press DISC CHANGE so that the compartment opens, replace disc(s) with other one(s), and press DISC CHANGE to close the compartment. Random/Repeat playback En Random playback plays all the tracks on one desired disc or all the discs in random order. Repeat playback plays all the tracks repeatedly on one desired disc or all the discs. 1 Press SHIFT+RANDOM/REPEAT repeatedly on the remote contr
Resumo do conteúdo contido na página número 11
To check the program Notes on CDs Programed playback Press f or g repeatedly during stop. The track number •Do not place more than one disc on one tray. Plays back up to 30 selected tracks in programed order. and program number are displayed in succession. •Do not tilt the unit with discs loaded. 1 Press SHIFT+PROGRAM on the remote control • The unit may not play a CD-R/RW disc recorded on personal To clear the program during stop. computers or certain kinds of CD-R/RW recorders. Press s during
Resumo do conteúdo contido na página número 12
RADIO OPERATIONS Tuning in to preset stations On the unit 1 Press TUNER/BAND to select a band. 2 Press cPRESET repeatedly or turn MULTI JOG. With each press, the station with the succeeding preset number is tuned in. En On the remote control 1 Press BAND to select a band. 2 Press the numbered buttons for the preset number of your desired station. -To select preset number 20, press +10, +10 and 0. -To select preset number 15, press +10 and 5. • Pressing PRESET N,M or c repeatedly can also select
Resumo do conteúdo contido na página número 13
Adjustments Antennas Keep antennas away from metallic objects, electrical equipment and cords. FM antenna: Extend fully and position for the best reception. If receiving condition is poor, connect optional outdoor antenna to FM 75 Ω terminal. Be sure to connect the shield braid of En the antenna to the 2 terminal. AM antenna: Rotate to find best reception. To switch to monaural FM reception Press SHIFT+TUNER MODE on the remote control. With each press, "MONO" and "STEREO" are displayed alternate
Resumo do conteúdo contido na página número 14
TAPE OPERATIONS To play back type II (High position) tapes Turn MULTI JOG until "SOFT" is displayed while playing a type II tape. Then, the unit provides the optimum playback sound for type II tapes. Notes on cassettes •Use of 120-minute or longer tapes is not recommended En since they are extremely thin and easily deformed or damaged. •Take up any slack in the tape with a pencil or similar tool before use. Slack tape may jam in the mechanism. •"SOFT" sound for type II tapes described above is c
Resumo do conteúdo contido na página número 15
3 Press wREC/REC MUTE to start recording. To erase a tape 5 Press the numbered buttons on the remote When recording a CD or tape, playback starts 1 Insert the tape in DECK 2. Set the tape to the desired point if control to enter the length of the recording tape. automatically. needed. 10 to 99 minutes can be specified. When recording input from connected equipment, 2Press TAPE/DECK1/2 to select "T2". - For a 60-minute tape press 6 and 0. manually start playback of the source. 3 Press wREC/REC MU
Resumo do conteúdo contido na página número 16
8 Press SHIFT+CD EDIT/CHECK on the remote To prevent accidental erasure Programed Edit Recording control to switch back to side A. Break off the plastic tab of the cassette tape with a screwdriver As you program the CD tracks to record, Programed Edit or other pointed tool. To record on the tape again, cover the 9 Press wREC/REC MUTE to start recording on Recording displays the remaining recording time for each side detection slot with adhesive tape. side A. of the tape, so you can easily select
Resumo do conteúdo contido na página número 17
SOUND ADJUSTMENTS En Super T-BASS TREBLE Emphasizes low frequencies for a powerful sound. Enhances high frequency for sound clarity . Press T-BASS repeatedly to select one of the three Press TREBLE repeatedly to select one of the three emphasis levels (1-3) or the off position (0). enhancement levels (1-3) or the off position (0). •When the sound becomes distorted with the T-BASS effect, •When the sound becomes distorted with the TREBLE effect, cancel it. cancel it. 17
Resumo do conteúdo contido na página número 18
TIMER OPERATIONS 5 Press f or g to adjust the volume level for timed playback, then press aSET or ENTER. Adjustable range: 0 to 16 6 Prepare the source. To play CD(s), load disc(s). To play the radio, select the band and tune in to the desired station. En To play a tape, insert the tape and select the deck. To play external equipment connected to the VIDEO/AUX jacks, set an external timer for the equipment so that its playback begins at the same time. 7 Press POWER 6STANDBY/ON to turn the unit o
Resumo do conteúdo contido na página número 19
To display the timer setting Timer recording Press TIMER. Timer recording is available only for TUNER and VIDEO/AUX The timer-on time, the source and the timer-activated duration (with an external timer) sources. are displayed for 6 seconds. 1 Press TIMER (SHIFT+TIMER on the remote Tip: Timer setting can be displayed even while the unit is turned control) repeatedly until "5REC" appears on the display. off, and at that time if you press ENTER or a within 6 seconds En after TIMER is pressed, you
Resumo do conteúdo contido na página número 20
REFERENCE Condensation Care and maintenance Troubleshooting Moisture may form on the CD pickup lens when: Occasional care and maintenance of the unit and the software If your unit fails to perform properly, check the following guide •The unit is moved from a cold spot to a warm spot are needed to optimize the performance of your unit. and the relevant sections of the Operating Instructions. •The heating system has just been turned on •The unit is used in a very humid room To clean the cabinet Th
