Resumo do conteúdo contido na página número 1
For assistance and information
call toll free I-800-BUY-AIWA
(United States and Puerto Rico)
J
<
mil!i
8Z-MA4-91 3-11
DIGITALAUDIO
981 115BKM-Y-9
Resumo do conteúdo contido na página número 2
4 Ventilation — The unit should be situated with adequate space around it so that proper heat ventilation is assured. Allow 10 cm (4 in.) clearance from the rear and the top of the unit, and 5 cm (2 in.) from each side. - Do not place the unit on a bed, rug, or similar surface that may block the ventilation openings. - Do not install the unit in a bookcase, cabinet, or airtight rack where ventilation may be impeded. 5 Objects and liquid entry — Take care that objects or liquid do not get inside
Resumo do conteúdo contido na página número 3
Outdoor Antenna 1 Power lines — When connecting an outdoor antenna, make sure it is located away from power lines. 2 Outdoor antenna grounding — Be sure the antenna system is properly grounded to provide protection against unexpected PREPARATIONS voltage surges or static electricity build-up. Article 810 of the National Electrical Code, ANS1/NFPA 70, provides information ................................................................. 4 CONNECTIONS on proper grounding of the mast, supporting st
Resumo do conteúdo contido na página número 4
1 Connect the right speaker to the main unit. d) Connect the speaker cord with the plug to the SPEAKERS HIGH FREQ R terminal. Check your system and accessories E!2!.- CX-ZL31 Compact disc stereo cassette receiver SX-WZL60 Front speakers PX-E860 Stereo turntable Remote control AM antenna FM antenna @ Connect the speaker cord with the white stri~e to the SPEAKERS LOW FREQ R 0 terminal and the black cord to the O terminal. d Q . ,4 .,. @ e # # Operating Instructions, etc. Before connecting the AC c
Resumo do conteúdo contido na página número 5
3 Connect the stereo turntable to the main unit. Connect the red plug to PHONO IN R jack, and the white ● Be sure to connect the speaker cords correctly. Improper plug to PHONO IN L jack. E connections can cause short circuits in SPEAKERS terminals. ,,~ , *’- ,0° Q /.., II@ ;,:J 4 Connect the supplied antenhas. Connect the FM antenna to FM 75 Q terminals and the AM antenna to AM LOOP terminals. ● Do not leave objects generating magnetism, such as credit FM antenna cards, near the speakers, as th
Resumo do conteúdo contido na página número 6
Inserting batteries Detach the battery cover on the rear of the remote control and insert two R6 (size AA) batteries. R6(AA) When to replace the batteries The maximum operational distance between the remote control To turn the unit on and the sensor on the main unit should be approximately 5 meters Press one of the function buttons (TAPE, TUNER/BAND, (16 feet). When this distance decreases, replace the batteries PHONO, VIDEO/AUX, CD). Playback of the inserted disc begins, with new ones. or the p
Resumo do conteúdo contido na página número 7
4-CHANNEL MULTI-AMPLIFIER SYSTEM To provide reinforcement for the ultra-low frequencies, in addition to the Left/Right 2-channel amplifier used to reproduce mid-to- high-range frequencies, this system incorporates a second L/R 2-channel amplifier just for reproduction of ultra-low frequencies — making it, in effect, a 4-amplifier system. By utilizing discrete amplifiers for mid to-high-frequencies and low frequencies, high- quality sonic reproduction that is virtually free from distortion can be
Resumo do conteúdo contido na página número 8
To reset the game Demo Press DEMO twice, then press P. The game starts again. To change the probability of equalizing the three numbers Press + or - repeatedly to select one of the three probability levels when playing the game Demo. The tray number indicator in the display changes between 1 and 3. As the tray number increases from 1 to 3, the higher the probability of equalizing. ,i J Ill I “’”d ● During the game Demo, ■ , +, - and > are available only for the game Demo. Cancel the game Demo to
Resumo do conteúdo contido na página número 9
VOLUME. PHONES This unit provides the following three different equalization curves. ROCK: Powerful sound emphasizing treble and bass VOLUME CONTROL POP: More presence in the vocals and midrange CLASSIC: Enriched sound with heavy bass and fine treble. Turn VOLUME on the main unit, or press VOL A or V on the remote control. Press GEQ repeatedly to select the equalization The volume level is displayed as a number from Oto MAX (50). mode. The volume level is automatically set to 20 when the power i
Resumo do conteúdo contido na página número 10
To search for a station quickly (Auto Search) Press TUNER PRESET repeatedly to display “SEARCH” (auto search mode), and turn MULTI JOG clockwise or counterclockwise until the frequency starts to change rapidly. After tuning into a station, the search stops. SEARCH To stop the Auto Search manually, turn MULTI JOG a little in either direction. ● The Auto Search may not stop at the stations with very weak signals. ● +4 DOWN and -UP are also available to search for a station. Keep + DOWN or -UP pres
Resumo do conteúdo contido na página número 11
MULTI JOG \ .— I !,–-’1 i,~ ‘... --.----2 (Deck 1) (Deck 2) The unit can store a total of 32 preset stations. When a station is Usable tapes stored, a preset number is assigned to the station. Use the preset Use Type I (normal) tapes only. number to tune in to a preset station directly. 1 PressTAPE, then press WA to open the cassette 7 Press TUNER/BAND to select a band, and press holder. - DOWN or -UP to select a station. 2 Press 1I SET to store the station. A preset number beginning from 1 in c
Resumo do conteúdo contido na página número 12
Load discs. CD EDIT/CHECK MULTI JOG \ r — ml. . ~, press E. Play begins with the disc on tray 1. Number of track being played Elapsed playing time To rXav one disc only, press one of DISC DIRECT PLAY 1- 5. The selected disc is played once. Selected disc tray, number Elapsed playing time Number of track being played Press CD, then press A OPEN/CLOSE to open the To stop play, press ■ . disc compartment. Load disc(s) with the label side To pause play, press II. To resume play, press again. To searc
Resumo do conteúdo contido na página número 13
m ● uen Ioadina an 8-cm (3-inch) disc, make sure to place it onto ‘;* @_~nner circle of the trav precisely. Otherwise, the disc may The silent portions between tracks recorded on a CD can be , :, ,, ‘-!, be damaged or the disc compartment will not open. [f it does skipped during playback. ;’ ‘“:, z not open, please consult your Aiwa dealer for repair. ~,”. ● Do not place more than one compact disc on one disc tray. f r)~~~~ CD BLANK SKIP ~~ the main ~nit. 8 ● Do Inot tilt the unit with discs loa
Resumo do conteúdo contido na página número 14
To check the program Each time + or - is pressed in stop mode, a disc number, track number, and program number will be displayed. To clear the program Up to 30 tracks can be programmed from any of the inserted Press ■ CLEAR in stop mode. discs. To add tracks to the program Repeat steps 2 and 3 in stop mode. The track will be programmed after the last track. To change the programmed tracks Clear the program and repeat all the steps again. To play the programmed tracks repeatedly After programming
Resumo do conteúdo contido na página número 15
To record part of the CD When ● is pressed, recording always starts from the first track. To start in the middle of a track, play the CD first and press 1I SET for CD at the point you wish to start recording from. Then, press ..-rhe pause mode for CD button is released automatically and recc)rding starts. Sound adjustment during recording The output volume and tone of the speakers or headphones are freely varied without affecting the recording. mm ● Dc)not press the buttons on Deck 2 during reco
Resumo do conteúdo contido na página número 16
6 Press ● on Deck 1 to start recording on the first side. flashes for 10 seconds, and then CD play and recording ~ of edited tracks for the first side start simultaneously. When —nisc the end of the tape is reached, Deck 1 enters the recording stop mode. After entering the recording stop mode go to step 7. 7 Press CD EDIT/CHECK while pressing SHIFT on the remote control to display the program for the second recording. “B” is displayed. 8 Turn over the tape in Deck 1 and press ● to start recordin
Resumo do conteúdo contido na página número 17
6 Repeat step 5 for the rest of the tracks for side A. A track whose playing time is longer than the remaining time cannot be programmed. 7 Press CD EDIT/CHECK while pressing SHIFT on the remote control to select side B and program the tracks for side B. Tape side B (reverse side) 8 Press CD EDIT/CHECK while pressing SHIFT to select side A and press ● on Deck 1. ~ flashes for 10 seconds, and then CD play and recording of edited tracks for the first side start simultaneously. When the end of the
Resumo do conteúdo contido na página número 18
The unit can be turned off automatically at a specified time, When the clock is set, the “:” between the hours and minutes flashes. When the clock setting is canceled due to a power failure, the entire clock display flashes. Use the remote control. 1 Press SLEEP while pressing SHIFT on the remote 7 Press II. control. When using the remote control, press CLOCK while pressing SHIFT. 2 Within 4 seconds, turn MULTI JOG or press ++ or + to specify the time until the power is turned 2 Within 4 seconds
Resumo do conteúdo contido na página número 19
5 Adjust the volume. a The source sound will play at the volume level set in this step # when the power is turned on by the timer. If the volume level is set to 21 or higher, however, it will :;~’ :~; automatically be set to 20 when the power is turned on, :,$j \ 3- 6 Prepare the source. .,, :,,. ,—,/ –( !:& To listen to a CD, load the disc to be played first on tray 1. To listen to a tape, insert the tape into deck 1 or 2. ~ To listen to the radio, tune in to a station. o 7 Press POWER to turn
Resumo do conteúdo contido na página número 20
To check the timer setting Press TIMER. The selected source, the timer-on time, and the duration for the timer-activated period will be displayed for 4 seconds. (\.-–-—– .– ‘i To change any of the previous setting Carry out from step 1. However, if you do not change the timer-on time, in step 3 just press ENTER twice and continue from step 4. To cancel the timer standby mode temporarily 2,4 Press TIMER so that 0 disappears. To restore the timer standby mode, press TIMER again to display 0. Using
