Resumo do conteúdo contido na página número 1
FriendlyNET 7000 Series
Gigabit Ethernet Switches
User’s Manual
Resumo do conteúdo contido na página número 2
Copyright Notice Trademarks Asanté Technologies and FriendlyNET are trademarks of Asanté Technologies, Inc. Ethernet is a registered trademark of the Xerox Corporation. All brand names and products are trademarks or registered trade- marks of their respective holders. FCC Information This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference
Resumo do conteúdo contido na página número 3
Table of Contents About This Manual ...............................................iii Chapter Contents ..............................................iv Document Conventions .....................................iv Introduction .......................................................1-1 Introducing the FriendlyNET 7000 Series ...... 1-1 Model Numbering Convention .................. 1-2 Configuration Options ............................... 1-2 Features ....................................
Resumo do conteúdo contido na página número 4
Cabling Requirements ....................................2-8 Connecting Network Devices .........................2-9 Connecting a Computer to the Switch ......2-9 Connecting a Hub or a Switch to the Asanté Switch ..............................2-10 Connecting a Hub with No Uplink Port to the Switch .........................2-10 Cascading Multiple FS7000 Switches .....2-11 Voltage Requirements ..................................2-11 Powering on the Switch ................................2
Resumo do conteúdo contido na página número 5
About This Manual This manual describes the complete line of FriendlyNET 7000 Series Gigabit Switches. The manual often focuses on two models: q FS7108 — eight-port 10/100Mbps Fast Ethernet switch plus one-port Gigabit module q FS7016 — sixteen-port 10/100Mbps Fast Ethernet switch with two expansion slots The FS7108 model is fixed in a single configuration. The FS7016 is an base unit which may be configured in a variety of ways by adding expansion modules. Because the addition of
Resumo do conteúdo contido na página número 6
Chapter Contents This manual is divided into the following chapters and appendices: q Chapter 1, “Introduction,” provides an overview of FriendlyNET 7000 Series Gigabit Switches, their features and switching technology q Chapter 2, “Installation,” describes the components and explains how to install, mount, and apply power to FriendlyNET 7000 Series Gigabit Switches q Chapter 3, “LED Indicators,” describes how to interpret the LEDs on FriendlyNET 7000 Series Gigabit S
Resumo do conteúdo contido na página número 7
1 Introduction This chapter introduces Asanté FriendlyNET 7000 Series Gigabit Switches and provides an overview of switching technology. Introducing the FriendlyNET 7000 Series Thank you for purchasing an Asanté FriendlyNET 7000 Series Gigabit Switch. FriendlyNET 7000 products are unmanaged 10/100 Fast Ethernet switches which provide built-in or optional Gigabit Ethernet connectivity. These switches are designed to address increasing network bandwidth needs and to accommodate future
Resumo do conteúdo contido na página número 8
Introduction A Media Independent Interface (MII) slot is built in to the back panel of all 7000 Series Switches. An Asanté 100 FX MII module can easily be plugged in to allow for 100Base-FX connections. Model Numbering Convention Model numbers for the Asanté FriendlyNET family of switches adhere to the following convention: q The first digit identifies the series number q The second digit indicates the number of Gigabit ports q The third and fourth digits indicate the number of
Resumo do conteúdo contido na página número 9
Introducing the FriendlyNET 7000 Series Table 1-2 Configuration Options: 1.5 Rack-Unit High (2.5 inches) Model Number 8-Port XP Gigabit XP Configuration (or equivalent) Modules Modules 16-port 10/100M switch 7016 0 0 24-port 10/100M switch 7024 1 0 32-port 10/100M switch 7032 2 0 16-port 10/100M switch 7116 0 1 + 1 Gigabit module 24-port 10/100M switch 7124 1 1 + 1 Gigabit module 16-port 10/100M switch 7216 0 2 + 2 Gigabit modules Features The FriendlyNET 7000 Series
Resumo do conteúdo contido na página número 10
Introduction q Complies with IEEE 802.3 Ethernet, IEEE 802.3u Fast Ethernet, IEEE 802.3z Gigabit Ethernet, and IEEE 802.3x flow control (in full-duplex mode) standards q Works with Category 3 (10Mbps operation only) or Category 5 UTP (unshielded twisted-pair) cable for 10/100Mbps connections q Provides power, MII power, 100/10Mbps, full- or half-duplex, and link/data LEDs to aid network diagnosis and simple management q Ideal for deployment with high-speed servers,
Resumo do conteúdo contido na página número 11
Switching Technology To ensure network reliability, a switch monitors each of its ports for signal quality. The switch automatically disconnects stations transmitting excessive noise, then reconnects them when the problem is resolved. A switch also automatically drops data packets that exceed the maximum allowable length. This prevents a device from blocking the network by transmitting continuous data streams or extra-long packets. The FriendlyNET 7000 Series Switch supports store-
Resumo do conteúdo contido na página número 12
Introduction Page 1-6
Resumo do conteúdo contido na página número 13
2 Installation This chapter describes the components and explains how to install, mount, and apply power to your FriendlyNET 7000 Series Gigabit Switch. It contains the following sections: q Package Contents q Components q Expansion Modules q 100 FX MII Module q Mounting Configurations q Cabling Requirements q Connecting Network Devices q Voltage Requirements q Powering on the Switch Package Contents FriendlyNET 7000 Series Gigabit Switches are shipped with the
Resumo do conteúdo contido na página número 14
Installation Components This section describes the front- and back-panel layouts of the FS7108 and FS7016 Switches. The only control on the front panel is the uplink push-button switch. The only control on the rear panel is the power switch. The LED indicators are described in detail in Chapter 3. The uplink push-button switch is connected to a single port on each Switch. In Normal position, the port associated with the uplink switch operates like any other port on the unit. When
Resumo do conteúdo contido na página número 15
Expansion Modules FS7016 Base Unit The front panel of the FS7016 contains sixteen 10/100Mbps ports, two expansion slots, one uplink switch button, and LED indicators. See Figure 2-3. Two Expansion Slots Option Slot A Option Slot B FriendlyNET 7000 Series Gigabit Switch Switched Gigabit Ethernet Port Switched Gigabit Ethernet Port A1 A2 A3 A4 A5 A6 A7 A8 B1 B2 B3 B4 B5 B6 B7 B8 Link/Data Link/Data 100/10Mbps Power Full Duplex/Collision Power Full Duplex/Collision Full/Half Link/Data Tx Rx
Resumo do conteúdo contido na página número 16
Option Slot B Switched Gigabit Ethernet Port Link/Data Power Full Duplex/Collision Tx Rx MII 9 10 11 12 13 14 15 16 Power Installation To install the Gigabit SX XP Module: 1 Power down the unit. 2 Remove the metal cover from the front of an empty expan- sion slot (located on the Switch’s front panel) using a small Phillips screwdriver. 3 Align the bottom of the Gigabit module with the rails on the inside of the expansion slot. See Figure 2-5. Figure 2-5 Installing a Gigabit module 4 Slide t
Resumo do conteúdo contido na página número 17
100 FX MII Module u Note: Each 10/100 expansion module provides 8 ports which are numbered 1 through 8. If the module is installed in Option Slot A, the ports on the module will correspond to LED indicators A1–A8. If the module is installed in Option Slot B, the ports on the module will correspond to LED indicators B1–B8. 100 FX MII Module All FriendlyNET 7000 Series Gigabit Switches include one Media Independent Interface (MII) slot on the rear panel of the unit which allows for connecti
Resumo do conteúdo contido na página número 18
Installation 2 Align the bottom of the MII module with the rails on the inside of the MII slot. 3 Slide the MII module into the MII slot until it stops, then push the module in until it seats with the connector. See Figure 2-7. MII Module Figure 2-7 Installing an MII module 4 Screw the module into place by tightening the thumbscrew on the module’s cover. See Figure 2-8. MII Module Figure 2-8 Securing an MII module 5 Connect the installed MII module to your network, follow- ing the instru
Resumo do conteúdo contido na página número 19
FriendlyNET 7000 Series Gigabit Switch Uplink Normal MII Uplink Power Option Slot A Option Slot B Switched Gigabit Ethernet Port A1 A2 A3 A4 A5 A6 A7 A8 B1 B2 B3 B4 B5 B6 B7 B8 100/10Mbps Link/Data Full/Half Power Full Duplex/Collision Link/Data Tx Rx 100/10Mbps Full/Half Power Link/Data 1 2 3 4 56 78 9 1011 12 1314 1516 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 FriendlyNET 7000 Series Gigabit Switch A1 A2 A3 A4 A5 A6 A7 A8 B1 B2 B3 B4 B5 B6 B7 B8 Link/Data Link/Data 100/10Mbps Pow r Full Duplex/Co
Resumo do conteúdo contido na página número 20
Option Slot A Option Slot B FriendlyNET 7000 Series Gigabit Switch Uplink MII Normal 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 Uplink Power Switched Gigabit Ethernet Port Switched Gigabit Ethernet Port A1 A2 A3 A4 A5 A6 A7 A8 B1 B2 B3 B4 B5 B6 B7 B8 100/10Mbps Link/Data Link/Data Full/Half Power Full Duplex/Collision Power Full Duplex/Collision Link/Data Tx Rx Tx Rx 100/10Mbps Full/Half Power Link/Data 1 2 3 4 56 78 9 1011 12 1314 1516 Installation 2 Mount the Switch in the equipment rack by screwi
